iReliev ET-7575

iReliev TENS + EMS Combination Unit (Model ET-7575) Instruction Manual

Your guide to safe and effective use of your iReliev device.

1. Introduction

The iReliev TENS + EMS Combination Unit is a versatile device designed for both pain relief and muscle stimulation. It integrates two distinct therapies:

  • TENS (Transcutaneous Electrical Nerve Stimulation): This therapy delivers low-voltage electrical pulses to the skin, stimulating nerve fibers to help block pain signals and promote the release of natural endorphins. It is commonly used for various types of pain, including arthritis.
  • EMS (Electrical Muscle Stimulation): Also known as Neuromuscular Electrical Stimulation (NMES), EMS uses electrical impulses to elicit muscle contractions. This can be beneficial for muscle strengthening, rehabilitation, and post-exercise recovery.

This device features 14 therapy modes (7 TENS pain relief modes, 1 Arthritis TENS mode, and 6 EMS muscle strength and recovery modes), 25 intensity levels, and an adjustable timer from 5 to 60 minutes. Its dual-channel versatility allows for independent control of two sets of electrodes.

iReliev TENS + EMS Combination Unit with electrode pads and accessories

Figure 1: iReliev TENS + EMS Combination Unit and included accessories.

2. Important Safety Information and Warnings

Please read all safety information carefully before using the device. Failure to do so may result in injury or adverse effects.

  • Do not use this system if you have a cardiac pacemaker, implanted defibrillator, or any other implanted metallic or electronic device.
  • This product is not suitable for individuals with heart rhythm problems.
  • Do not use this product if you have undiagnosed chronic pain. Consult a physician for diagnosis.
  • Do not use if pregnant or in labor.
  • Do not use if you have cancer.
  • Not suitable for children under 16 years of age. Keep out of reach of children.
  • Consult your physician or qualified healthcare provider regarding your condition and appropriate medical treatment. The information provided in this manual is not intended for medical diagnosis or treatment and should not substitute professional medical advice.
  • Individual symptoms, situations, circumstances, and results may vary.

Refer to the full user manual for additional warnings and cautions.

3. Setup and Preparation

3.1. Battery Installation

The iReliev TENS + EMS unit requires 3 AAA batteries (included). To install:

  1. Locate the battery compartment on the back of the device.
  2. Open the battery compartment cover.
  3. Insert 3 AAA batteries, ensuring correct polarity (+/-).
  4. Close the battery compartment cover securely.

3.2. Connecting Electrode Pads

The device comes with lead wires and electrode pads of various sizes. The unit has two independent channels (CH1 and CH2).

  1. Connect the lead wires to the electrode pads. Ensure a secure connection.
  2. Plug the lead wires into the output ports (CH1 and/or CH2) at the top of the iReliev unit.
  3. Ensure the device is turned OFF before attaching pads to your skin.
  4. Clean and dry the skin area where the pads will be placed.
  5. Remove the protective film from the electrode pads and firmly press them onto the skin. Ensure full contact.
Included electrode pads: 4 large and 8 small

Figure 2: The device includes 4 large and 8 small electrode pads for various body areas.

4. Operating Instructions

The iReliev unit offers 14 pre-set therapy modes and adjustable settings for intensity and time.

Diagram showing iReliev device features: TENS modes, EMS modes, Arthritis mode, 25 intensity levels, treatment time, lock function, dual channel versatility, portable design.

Figure 3: Overview of iReliev TENS + EMS unit features.

4.1. Powering On/Off

  • To turn ON: Press the "ON +" button.
  • To turn OFF: Press the "OFF -" button.

4.2. Selecting a Therapy Mode

The device has 14 pre-set programs:

  • P1-P7: TENS Pain Relief Modes.
  • P8: Arthritis TENS Mode.
  • P1-P6 (EMS): EMS Muscle Strength & Recovery Modes.

Press the "MODE" button to cycle through the available programs. The selected program will be displayed on the LCD screen.

Close-up of iReliev device screen showing mode P8, TENS/EMS indicator, intensity levels for CH1 and CH2, and timer.

Figure 4: Device display showing active mode and settings.

4.3. Adjusting Intensity

The device offers 25 levels of intensity. Intensity can be adjusted independently for each channel (CH1 and CH2).

  • Press "CH1" or "CH2" button to select the channel you wish to adjust.
  • Press "ON +" to increase intensity.
  • Press "OFF -" to decrease intensity.
  • Adjust the intensity to a comfortable level, avoiding any painful sensations.

4.4. Setting the Timer

The therapy duration can be set from 5 to 60 minutes. The device will automatically shut off once the timer expires.

  • After selecting a mode, the timer will be displayed.
  • Use the "ON +" and "OFF -" buttons to adjust the therapy duration.

4.5. Lock Function

The lock function prevents accidental changes to settings during therapy.

  • To activate: Press and hold the "MODE" button for a few seconds until a lock icon appears on the screen.
  • To deactivate: Press and hold the "MODE" button again until the lock icon disappears.

4.6. Electrode Pad Placement

Proper pad placement is crucial for effective therapy. Refer to the diagrams below for common placement areas. Always ensure pads are placed on clean, dry skin.

Woman using iReliev TENS + EMS unit with four electrode pads placed on her lower back while sitting on a yoga mat.

Figure 5: Example of electrode pad placement on the lower back.

Woman demonstrating large electrode pads for better coverage on body areas like the abdomen, with an arrow pointing from large pads to smaller pads on her abdomen.

Figure 6: Large electrode pads provide broader coverage for larger body areas.

Diagram showing recommended small pad placements for various body parts: ankle, calves, elbow, feet, shoulder, knee, lower back, quads, wrist, upper back, upper arm.

Figure 7: Recommended small pad placements for targeted therapy.

5. Maintenance and Care

5.1. Device Care

  • Wipe the device with a soft, damp cloth. Do not use abrasive cleaners or immerse the device in water.
  • Store the device in a cool, dry place, away from direct sunlight and extreme temperatures.
  • Remove batteries if the device will not be used for an extended period.

5.2. Electrode Pad Care

  • After each use, place the protective film back onto the adhesive side of the pads.
  • Store pads in a sealed bag to prevent drying out.
  • If pads lose their stickiness, gently wipe the adhesive surface with a damp cloth and allow to air dry. Replace pads when they no longer adhere properly.
  • Do not share electrode pads with others.

6. Troubleshooting

If you encounter issues with your iReliev unit, refer to the following common solutions:

ProblemPossible CauseSolution
No sensation or weak sensation
  • Low battery
  • Pads not adhering well
  • Lead wires not connected properly
  • Intensity too low
  • Replace batteries
  • Ensure pads are firmly pressed onto clean, dry skin; replace if necessary
  • Check all lead wire connections
  • Increase intensity gradually
Device does not turn on
  • Dead batteries
  • Incorrect battery installation
  • Replace batteries
  • Check battery polarity
Sensation is uncomfortable or painful
  • Intensity too high
  • Pads not fully adhering
  • Pads placed over bony areas or sensitive skin
  • Decrease intensity immediately
  • Ensure full pad contact; replace if needed
  • Reposition pads to a fleshy area

If the problem persists, contact customer support.

7. Specifications

FeatureDetail
Model NumberET-7575
Dimensions0.5 x 2.5 x 3.5 inches
Weight10 ounces
Power Source3 AAA batteries (included)
Intensity Levels25 levels (up to 80 mA output)
Therapy Modes14 (7 TENS, 1 Arthritis TENS, 6 EMS)
Adjustable Timer5-60 minutes
ChannelsDual Channel
ManufacturerExcelHealth Inc.
UPC853635002365

8. Warranty and Support

8.1. Warranty Information

For detailed warranty information, please refer to the documentation included with your product packaging or visit the official iReliev website. Warranty terms and conditions may vary.

8.2. Customer Support

If you have any questions, require assistance, or need to report an issue with your iReliev TENS + EMS Combination Unit, please contact iReliev customer support. Contact details can typically be found on the product packaging, the official iReliev website, or through your retailer.

Manufacturer: ExcelHealth Inc.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.