1. Introduction
This manual provides comprehensive instructions for the installation, operation, and maintenance of your Argo Livorno 2890 Cromo single-lever kitchen sink mixer tap. Please read this manual thoroughly before installation and use to ensure proper function and longevity of the product. Keep this manual for future reference.
2. Safety Information
Always observe the following safety precautions:
- Ensure the main water supply is turned off before beginning any installation or maintenance work.
- If you are unsure about any part of the installation process, consult a qualified plumber.
- Do not use abrasive cleaners or scouring pads on the chrome finish, as this can cause damage.
- Protect the product from freezing temperatures.
3. Package Contents
Verify that all components are present before starting installation:
- Argo Livorno 2890 Cromo Mixer Tap (1 unit)
- Connection Hoses (2 units, 50 cm length)
- Mounting Hardware (gasket, washer, nut)
- User Manual (this document)
4. Setup and Installation
Professional installation is recommended. Follow these steps carefully:
- Preparation: Turn off the main water supply to your kitchen sink. Clear the area under the sink.
- Remove Old Tap: Disconnect the water supply lines from the old tap and remove the old tap from the sink.
- Install Mixer Tap:
- Insert the new mixer tap into the mounting hole on your sink or countertop.
- From underneath the sink, slide the rubber gasket, then the metal washer, and finally tighten the mounting nut onto the threaded rod of the tap. Ensure the tap is securely fastened and straight.
- Connect Hoses:
- Attach the 50 cm flexible connection hoses to the corresponding inlets on the bottom of the tap. Hand-tighten, then use a wrench for a quarter turn to ensure a secure, leak-free connection.
- Connect the other ends of the hoses to your hot and cold water supply lines. The hot water connection is typically on the left, and cold on the right.
- Check for Leaks: Slowly turn on the main water supply. Check all connections for leaks. If leaks occur, gently tighten the connections.
- Flush System: Open the tap lever to allow water to flow for a few minutes to flush out any debris from the new installation.
This image illustrates the process of securing the tap to the sink and connecting the hot and cold water supply lines underneath the counter.
5. Operating Instructions
The Argo Livorno 2890 Cromo features a single-lever design for easy control of water flow and temperature.
- Water Flow: Lift the lever upwards to increase water flow. Push it downwards to decrease or stop the flow.
- Water Temperature: Move the lever to the left for hot water and to the right for cold water. The temperature can be adjusted by positioning the lever between these two extremes.
- Spout Rotation: The tap spout can rotate 360 degrees, allowing for flexible use across multiple sink bowls or for moving it out of the way when not in use.
6. Maintenance and Cleaning
Regular cleaning and maintenance will help preserve the appearance and functionality of your tap.
- Cleaning the Finish: Clean the chrome surface with a soft, damp cloth and mild soap. Rinse thoroughly with clean water and dry with a soft cloth to prevent water spots. Do not use abrasive cleaners, acidic cleaners, or solvents, as these can damage the chrome finish.
- Aerator Cleaning: If water flow becomes restricted, the aerator at the end of the spout may be clogged. Unscrew the aerator, clean any debris or mineral deposits, and rinse it before reattaching.
- Cartridge Maintenance: The 35mm ceramic cartridge is designed for long-lasting, drip-free performance. If leaks or stiffness occur, the cartridge may need to be replaced. This typically requires professional assistance.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Water leaks from spout when off | Worn or damaged cartridge | Replace the ceramic cartridge. Contact a qualified plumber. |
| Water leaks from base of tap | Loose mounting nut or damaged gasket | Check and tighten the mounting nut. Inspect and replace the gasket if damaged. |
| Low water flow | Clogged aerator or restricted water supply | Clean the aerator. Check water supply valves are fully open. |
| Difficulty adjusting temperature | Cartridge issue or unbalanced water pressure | Ensure hot and cold water supplies are functioning correctly. Consider cartridge replacement if problem persists. |
8. Specifications
- Model: Livorno 2890 Cromo
- Brand: Argo
- Product Type: Kitchen Sink Mixer Tap
- Finish: Chrome
- Material: Brass
- Cartridge Diameter: 35 mm
- Spout Rotation: 360°
- Connection Hoses Length: 50 cm
- Installation Method: Single-hole (Monoforo) / Deck Mounted
- Number of Handles: 1 (Single-lever)
- Item Weight: Approximately 454 g (1 lb)
9. Warranty and Support
For warranty information or technical support, please refer to the documentation provided at the point of purchase or contact your retailer. Keep your proof of purchase for warranty claims.
For further assistance, please visit the manufacturer's website or contact their customer service department.