Bulldog Vaults BD8000 Trigger Lock with Combination Instruction Manual

Introduction

This manual provides comprehensive instructions for the safe and effective use of your Bulldog Vaults BD8000 Trigger Lock with Combination. This device is designed to secure firearms by preventing unauthorized trigger access, enhancing safety around children and other individuals. Please read all instructions carefully before use.

Important Safety Information

Always treat every firearm as if it is loaded. Keep the muzzle pointed in a safe direction. This trigger lock is a deterrent against unauthorized use and accidental discharge; it is not a substitute for responsible firearm storage practices. Always store firearms unloaded and separate from ammunition. Keep the combination confidential and out of reach of unauthorized individuals.

WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

Product Overview

The Bulldog Vaults BD8000 Trigger Lock is a keyless combination lock designed for securing most handguns, rifles, shotguns, and MSRs. It features a positive locking mechanism with an adjustable ratchet and special cushion pads to protect the firearm's finish.

Image: The Bulldog Vaults BD8000 Trigger Lock shown installed on a revolver, covering the trigger and trigger guard area. The combination dials are visible on the side of the lock.

Setup: Setting Your Combination

Your trigger lock comes with a factory preset combination, typically 0-0-0. You can reset this to a personal combination.

1. Ensure the lock is open and set to the current combination (factory default is 0-0-0).
2. Locate the reset button or lever, usually on the side or bottom of the lock.
3. Using a pen or small pointed object, press and hold the reset button/lever.
4. While holding the reset button, rotate the combination dials to your desired 3-digit code.
5. Release the reset button. Your new combination is now set. Test the new combination before locking it onto a firearm.

Operating Instructions

Applying the Trigger Lock

1. Ensure the firearm is unloaded and safe.
2. Open the trigger lock by entering the correct combination and pressing the release button/lever.
3. Position the two halves of the lock around the trigger guard, ensuring the trigger is fully enclosed and cannot be accessed. The cushion pads should be against the firearm to prevent scratching.
4. Press the two halves together firmly until they click and lock into place.
5. Scramble the combination dials to secure the lock.

Removing the Trigger Lock

1. Align the combination dials to your preset 3-digit code.
2. Press the release button/lever to disengage the locking mechanism.
3. Carefully separate the two halves of the lock from the firearm.

Maintenance

The Bulldog Vaults BD8000 Trigger Lock requires minimal maintenance. Keep the lock clean and free of debris. If the combination dials become stiff, a small amount of graphite lubricant can be applied. Do not use oil-based lubricants as they can attract dirt and grime.

Troubleshooting

• Lock will not open: Ensure the combination is correctly aligned. Double-check that you are using the correct 3-digit code. If you have recently reset the combination, ensure you are using the new code.
• Lock feels loose on firearm: The lock features an adjustable ratchet mechanism. Ensure it is fully closed and engaged. The cushion pads should provide a snug fit. This lock is designed to fit most firearms, but some variations may occur.
• Dials are hard to turn: Apply a small amount of graphite lubricant to the dials. Avoid forcing the dials.

Specifications

Warranty and Support

For warranty information or technical support, please refer to the official Bulldog Vaults website or contact their customer service directly. Keep your purchase receipt for warranty claims.