Diversey REVIVE PLUS SC 5L

Diversey REVIVE PLUS SC Maintainer/Rejuvenator 5L User Manual

Model: REVIVE PLUS SC 5L

Introduction

The Diversey REVIVE PLUS SC Maintainer/Rejuvenator is a specialized floor care product designed to repair microscopic scratches and restore a glossy appearance to hard-surface floors. This 5-liter solution is formulated for daily cleaning and maintenance, preventing browning out and enhancing floor aesthetics when burnished correctly. It is suitable for use with high-speed burnishers (1500 to 2000+ RPM).

Important Safety Information

WARNING: Always read the product label and Safety Data Sheet (SDS) before use. Keep out of reach of children. Avoid contact with eyes and skin. In case of contact, rinse immediately with plenty of water and seek medical advice. Do not ingest. Use in a well-ventilated area. Wear appropriate personal protective equipment (PPE) such as gloves and eye protection.

Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition. This product is for industrial and commercial floor maintenance only.

Setup and Preparation

  1. Inspect Floor: Ensure the floor surface is clean and free of loose debris before application.
  2. Dilution: This product is typically used undiluted or diluted according to specific floor care programs. Refer to your facility's standard operating procedures or Diversey guidelines for precise dilution ratios.
  3. Equipment: Prepare appropriate floor cleaning equipment, such as an automatic scrubber, mop and bucket, or spray bottle, along with a high-speed burnisher (1500-2000+ RPM).
  4. Ventilation: Ensure adequate ventilation in the work area.
Diversey REVIVE PLUS SC 5L container

Image: Diversey REVIVE PLUS SC Maintainer/Rejuvenator 5L container. This image shows the product in its original packaging, a large red container with a white cap.

Operating Instructions

For Daily Cleaning and Maintenance:

  1. Application: Apply the diluted or undiluted solution evenly to the floor surface using an automatic scrubber, mop, or spray bottle.
  2. Scrubbing: Scrub the floor as usual to clean and distribute the product.
  3. Drying: Allow the floor to dry completely.
  4. Burnishing (Optional but Recommended): For enhanced gloss and scratch repair, burnish the dry floor with a high-speed burnisher (1500-2000+ RPM) using an appropriate burnishing pad. This step activates the rejuvenating properties of the product.

For Scratch Repair and Rejuvenation:

Maintenance and Storage

Troubleshooting

ProblemPossible CauseSolution
Floor appears dull after application.Insufficient burnishing or incorrect burnishing pad.Ensure floor is completely dry. Burnish with a high-speed burnisher (1500-2000+ RPM) and an appropriate pad until desired gloss is achieved.
Streaks or residue on floor.Over-application or insufficient drying.Apply product evenly and avoid excessive amounts. Ensure proper drying time. If using a scrubber, check squeegee condition.
Product not effectively repairing scratches.Scratches are too deep or burnishing is inadequate.This product is designed for microscopic scratches. For deeper scratches, more aggressive floor restoration methods may be required. Ensure proper burnishing technique.

Specifications

Warranty and Support

For specific warranty information or technical support regarding the Diversey REVIVE PLUS SC Maintainer/Rejuvenator, please contact Diversey customer service directly or refer to the official Diversey website. Contact details are typically available on the product label or packaging.

You can visit the official Diversey store for more information: Diversey Store on Amazon