Introduction
This manual provides essential instructions for the safe and efficient operation, maintenance, and troubleshooting of your Univex SRM30 Floor Model Mixer. Please read this manual thoroughly before operating the mixer to ensure proper usage and to prevent injury or damage.
Figure 1: Univex SRM30 Floor Model Mixer. This image shows the overall design of the mixer, including its robust base and mixing head.
Important Safety Information
Always follow basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and injury to persons. This mixer is equipped with interlock switches to protect the operator from injury. Do not bypass or tamper with these safety features.
- Ensure the mixer is placed on a stable, level surface.
- Keep hands, hair, and clothing away from moving parts during operation.
- Always turn off and unplug the mixer before cleaning, assembling, or disassembling parts.
- Do not operate the mixer with a damaged cord or plug.
- Use only attachments recommended by Univex.
Setup and Installation
Unpacking
Carefully remove the mixer and all accessories from the packaging. Inspect for any shipping damage. Retain packaging for future transport or service.
Placement
Position the mixer on a sturdy, level floor capable of supporting its weight (approximately 415 pounds). Ensure adequate clearance around the mixer for operation and maintenance.
Electrical Connection
The Univex SRM30 mixer operates on 115VAC, 60Hz, 1 phase power and draws 13.6 Amps. Connect the mixer to a properly grounded electrical outlet. Consult a qualified electrician if you are unsure about your electrical supply.
Attachment Installation
- Ensure the mixer is turned off and unplugged.
- Lower the bowl lift to its lowest position.
- Attach the desired accessory (batter beater, whip, or dough hook) to the planetary shaft, ensuring it clicks securely into place.
- Place the heavy-duty stainless steel bowl onto the bowl supports and raise it into position.
Operating Instructions
Controls Overview
The mixer features push-button controls for power and speed adjustment. A 15-minute timer is integrated for precise mixing durations.
Starting the Mixer
- Ensure the bowl and attachment are correctly installed and the safety guard is closed. The 2-piece Swing Ring Safety Guard must be properly closed for the mixer to operate due to interlock switches.
- Add ingredients to the mixing bowl.
- Select the desired speed using the speed control buttons. The rugged gear/belt drive system allows for speed changes while the mixer is running.
- Set the 15-minute timer if a specific mixing duration is required.
Changing Speeds
The Univex SRM30 is designed to allow speed changes while the mixer is running. Use the speed control buttons to adjust the mixing speed as needed for your recipe. Always observe the mixing process to prevent over-mixing or splashing.
Using the Power Drive Head
The mixer's power drive head accommodates various attachments, such as meat and food choppers (sold separately). Refer to the specific attachment's manual for installation and operation instructions.
Maintenance and Cleaning
Regular cleaning and maintenance will extend the life of your Univex SRM30 mixer.
Daily Cleaning
- Always unplug the mixer before cleaning.
- Remove the mixing bowl and attachment. The heavy-duty stainless steel bowl is dishwasher safe.
- The 2-piece Swing Ring Safety Guard opens wide for full access to the bowl area, making cleaning easier. Wipe down the exterior surfaces of the mixer with a damp cloth and mild detergent. Avoid using abrasive cleaners or scouring pads.
- Ensure all parts are thoroughly dried before reassembly or next use.
Periodic Inspection
Periodically inspect the power cord for any signs of damage. Check that all bolts and fasteners are secure. If any issues are found, contact Univex customer support or a qualified service technician.
Troubleshooting
This section addresses common issues you might encounter with your Univex SRM30 mixer. For problems not listed here, contact customer support.
| Problem | Possible Cause | Solution |
|---|---|---|
| Mixer does not start. |
|
|
| Unusual noise during operation. |
|
|
| Motor overheats. |
|
|
Specifications
| Feature | Detail |
|---|---|
| Model | SRM30 |
| Motor | 1 HP |
| Electrical Requirements | 115VAC, 60Hz, 1 Phase, 13.6 Amps |
| Drive System | Rugged Gear/Belt Drive |
| Bowl Material | Heavy Duty Stainless Steel |
| Safety Features | Interlock Switches, 2-piece Swing Ring Safety Guard |
| Timer | 15 Minute |
| Included Attachments | Batter Beater, Whip, Dough Hook |
| Power Drive Head | Accommodates Meat and Food Chopper Attachments |
| Product Dimensions | 36 x 33 x 56 inches |
| Item Weight | 415 pounds |
| Dishwasher Safe Parts | Bowl |
| Country of Origin | Made in the USA |
Warranty Information
The Univex SRM30 Floor Model Mixer comes with a 2-year factory parts and labor warranty. This warranty covers defects in materials and workmanship under normal use and service. For warranty claims or service, please contact Univex customer support with your proof of purchase and model number.
Customer Support
For technical assistance, parts, or service inquiries, please contact Univex customer support. Have your model number (SRM30) and serial number ready when contacting support.
Contact information (e.g., phone number, website) would typically be provided here by the manufacturer.