HAND CT-6616 Magnetic Badge Holder Instruction Manual

Introduction

This manual provides instructions for the HAND CT-6616 Strong Magnetic Badge Name Holder. This product is designed for securely attaching identification badges, name tags, or other lightweight items to clothing without pins, preventing damage to fabric.

Setup and Assembly

The CT-6616 magnetic badge holder consists of two main parts: a metal plate with adhesive (for attaching to the badge) and a magnetic plate (worn under clothing).

1. Prepare Your Badge: Ensure the surface of your identification badge or name tag is clean and dry.
2. Attach Metal Plate: Peel the protective backing from the adhesive side of the metal plate. Carefully align and press the metal plate firmly onto the back of your badge. Apply pressure for a few seconds to ensure a strong bond.
3. Position on Clothing: Place your badge (now with the attached metal plate) on the desired outer surface of your clothing.
4. Secure with Magnetic Plate: On the inside of your clothing, directly behind where the badge is positioned, place the magnetic plate. The strong magnets will attract, securing the badge in place.

Image Description: A close-up view of the two components of the magnetic badge holder: a metal plate with adhesive and a separate magnetic plate. This illustrates how the two parts connect through fabric.

Operating Instructions

Once assembled, the magnetic badge holder is ready for use.

• Placement: Position the badge holder on a flat, non-bulky part of your clothing for optimal magnetic hold.
• Removal: To remove the badge, gently separate the magnetic plate from the inside of your clothing. Avoid pulling directly on the badge itself to prevent stress on the adhesive.
• Storage: When not in use, store the magnetic badge holder away from sensitive electronic devices, credit cards, or medical implants (e.g., pacemakers) to prevent interference.

Maintenance and Care

The CT-6616 magnetic badge holder requires minimal maintenance.

• Cleaning: Wipe the surfaces with a soft, dry cloth if needed. Do not use abrasive cleaners or immerse in water.
• Adhesive Longevity: The adhesive on the metal plate is designed for a single, permanent application. Avoid repositioning the metal plate once it has been firmly attached to a badge.
• Magnetic Strength: The magnets are designed for long-term use and should retain their strength under normal conditions.

Troubleshooting

If you encounter issues with your magnetic badge holder, consider the following:

• Badge Not Holding Securely:
  • Ensure the magnetic plate is directly behind the metal plate on the badge.
  • Check if the clothing material is too thick or has multiple layers, which can reduce magnetic strength.
  • Verify that the metal plate is firmly adhered to the badge.
• Badge Falling Off:
  • This may indicate insufficient magnetic contact or excessive movement. Re-adjust placement.
  • Avoid using the holder on very loose or slippery fabrics.

Specifications

Image Description: The HAND CT-6616 magnetic badge holders displayed in their original packaging, showing a pack of three units. This image provides a visual reference for the product as it is typically sold.