Swiffer WetJet Starter Kit Instruction Manual

Introduction

The Swiffer WetJet floor spray mop system is designed to provide an effective clean on various finished floor types. This all-in-one mopping system features a dual-nozzle sprayer that helps break up and dissolve tough messes. The cleaning solution works to loosen dirt, which is then captured and locked away by the WetJet pad. The reinforced handle allows for precise control over solution dispensing.

Important Note: This floor mop is safe on all finished wood floors. Do not use on unfinished, oiled or waxed wooden boards, non-sealed tiles, or carpeted floors, as these surfaces may be water sensitive.

Setup Instructions

1. Assemble the Mop Handle: Connect the handle sections by pushing them firmly together until they click into place.
2. Insert Batteries: Open the battery compartment (typically located on the handle or main body) and insert 4 AA batteries. Ensure correct polarity. The starter kit includes the necessary batteries.
3. Attach Cleaning Solution Bottle: Align the cleaning solution bottle with the opening on the mop body and push it firmly into place until it clicks. Ensure the bottle is securely seated to prevent leaks.
4. Attach Cleaning Pad: Place a fresh Swiffer WetJet cleaning pad onto the bottom of the mop head. The pad will adhere to the hook-and-loop fasteners on the mop head.

Operating Instructions

1. Prepare the Area: For best results, sweep or vacuum the floor to remove loose dirt and debris before using the WetJet.
2. Spray Solution: Hold the mop with the handle and press the spray button located on the handle. The dual nozzles will dispense the cleaning solution onto the floor in front of the mop head.
3. Mop the Floor: Glide the mop over the wet area, allowing the cleaning pad to absorb the dissolved dirt and grime. The solution is designed to dry quickly, minimizing streaks.
4. Repeat: Continue spraying and mopping in sections until the desired area is clean.

Image: Swiffer WetJet spraying solution during use.

Maintenance

• Replacing Cleaning Pads: After use, peel the dirty cleaning pad off the mop head and dispose of it. Attach a new pad for the next cleaning session.
• Replacing Solution Bottle: When the cleaning solution bottle is empty, press the release button (if applicable) or pull the empty bottle firmly to remove it. Insert a new Swiffer WetJet cleaning solution refill bottle.
• Cleaning the Mop: Wipe down the mop handle and head with a damp cloth as needed to remove any residue. Do not submerge the mop head or handle in water.

Image: Swiffer WetJet mop head with a fresh cleaning pad.

Troubleshooting

• No Spray:
  • Check if the batteries are correctly inserted and not depleted. Replace if necessary.
  • Ensure the cleaning solution bottle is fully inserted and clicked into place.
  • Verify that the spray nozzles are not clogged.
• Streaks on Floor:
  • Ensure you are using the correct Swiffer WetJet solution for your floor type.
  • Replace the cleaning pad if it is heavily soiled.
  • Avoid oversaturating the floor with solution.
• Mop Handle Feels Loose:
  • Ensure all handle sections are firmly connected. The handle is designed to be reinforced for durability.

Specifications

Warranty Information

Specific warranty details for the Swiffer WetJet Starter Kit are typically provided with the product packaging or can be found on the official Swiffer website. Please refer to these resources for comprehensive warranty coverage and terms.

Customer Support

For further assistance, questions, or to purchase replacement parts and solutions, please visit the official Swiffer website or contact Swiffer customer service directly. Contact information can usually be found on the product packaging or the brand's website.