Eurom MM350

Eurom MM 3500 Aggregaat - 2800W - Mitsubishi GT 600 Motor

User Manual

Product Overview

The Eurom MM 3500 Aggregaat is a robust generator designed for reliable power supply, featuring a powerful Mitsubishi GT 600 engine. This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your generator.

Eurom MM 3500 Aggregaat Generator

Figure 1: Eurom MM 3500 Aggregaat Generator. This image displays the complete generator unit, highlighting its red fuel tank with "EUROM" branding, the Mitsubishi GT 600 engine, and the control panel with various outlets and indicators, all encased within a sturdy black frame.

Key Features:

  • Engine Type: Mitsubishi GT 600
  • Engine Power: 6 HP / 4.41 kW
  • Fuel Tank Capacity: 15 liters
  • Maximum Power Output: 2.8 kVa / 2,800 W
  • Continuous Power Output: 2.5 kVa
  • Voltage: 230 Volts, 50 Hz
  • Start System: Manual
  • Oil Sensor: Equipped with an oil sensor for engine protection.

Setup and Initial Preparation

Before operating the Eurom MM 3500 Aggregaat, ensure proper setup and initial preparations are completed to guarantee safe and efficient performance.

  1. Placement: Position the generator on a firm, level surface in a well-ventilated area, away from combustible materials. Ensure adequate clearance around the unit for air circulation.
  2. Fueling: Fill the fuel tank with Euro95 gasoline. The tank capacity is 15 liters. Always use fresh, clean fuel. Do not overfill.
  3. Engine Oil: Check the engine oil level. If necessary, add the recommended type and amount of engine oil. The generator is equipped with an oil sensor, which will prevent the engine from starting or running if the oil level is too low.
  4. Pre-Operation Check: Inspect the generator for any visible damage, loose connections, or fuel/oil leaks. Ensure all covers and guards are securely in place.

Operating Instructions

Follow these steps to safely start and operate your Eurom MM 3500 Aggregaat.

  1. Fuel Valve: Open the fuel valve.
  2. Choke: If the engine is cold, move the choke lever to the "CHOKE" position. For a warm engine, the choke may not be necessary.
  3. Engine Switch: Turn the engine switch to the "ON" position.
  4. Starting the Engine: Firmly pull the recoil starter handle until the engine starts. Once the engine starts, slowly return the choke lever to the "RUN" position.
  5. Connecting Loads: Allow the generator to run for a few minutes to warm up before connecting any electrical loads. Connect appliances one by one, ensuring the total load does not exceed the continuous power output of 2.5 kVa.
  6. Stopping the Engine: To stop the engine, disconnect all electrical loads, turn the engine switch to the "OFF" position, and close the fuel valve.

Important: Never operate the generator indoors or in poorly ventilated areas due to the risk of carbon monoxide poisoning.

Maintenance

Regular maintenance is crucial for the longevity and optimal performance of your generator.

  • Engine Oil: Check the engine oil level before each use. Change the engine oil after the first 20 hours of operation, and then every 50-100 hours or annually, whichever comes first. Refer to the engine manufacturer's recommendations for oil type.
  • Air Filter: Inspect the air filter regularly and clean or replace it as needed, especially in dusty conditions. A clogged air filter can reduce engine performance and increase fuel consumption.
  • Spark Plug: Inspect the spark plug annually or every 100 hours. Clean or replace it if it is fouled or worn. Ensure the correct gap is maintained.
  • Fuel System: If storing the generator for an extended period, drain the fuel tank and carburetor or use a fuel stabilizer to prevent fuel degradation.
  • General Cleaning: Keep the generator clean and free of dirt and debris. Regularly check for loose bolts or connections.

Troubleshooting

This section provides solutions to common issues you might encounter with your Eurom MM 3500 Aggregaat.

ProblemPossible CauseSolution
Engine does not start.
  • No fuel or stale fuel.
  • Low engine oil level (oil sensor activated).
  • Engine switch is OFF.
  • Choke not set correctly.
  • Spark plug issues.
  • Add fresh fuel.
  • Add engine oil to the correct level.
  • Turn engine switch to ON.
  • Adjust choke lever.
  • Inspect and clean/replace spark plug.
No power output.
  • AC voltage fuse tripped.
  • Overload.
  • Loose connections.
  • Check and reset the AC voltage fuse.
  • Reduce connected load.
  • Check all electrical connections.
Engine runs rough or loses power.
  • Clogged air filter.
  • Stale fuel.
  • Spark plug issues.
  • Clean or replace air filter.
  • Drain and refill with fresh fuel.
  • Inspect and clean/replace spark plug.

Technical Specifications

Detailed specifications for the Eurom MM 3500 Aggregaat.

SpecificationValue
ManufacturerMitsubishi / Eurom
Model NumberMM350
Product Dimensions (L x W x H)57 x 48 x 44 cm
Weight45 kg (99.21 lbs)
Engine TypeMitsubishi GT 600, 4-stroke
Engine Displacement181 cm³
Engine Power6 HP / 4.41 kW
Fuel TypeEuro95 Gasoline
Fuel Tank Capacity15 liters
Max Power Output2.8 kVa / 2800 Watts
Continuous Power Output2.5 kVa
Voltage230 Volts
Frequency50 Hz
Noise Level (at 7m)95 dB(A)
Start SystemManual
Oil SensorYes
AC Voltage FuseYes
Included ComponentsNone

Warranty and Support

For warranty information and technical support, please contact Eurom customer service directly. Keep your purchase receipt as proof of purchase.

Regarding spare parts, information on their availability is currently not provided. For any spare part inquiries, it is recommended to contact the manufacturer or an authorized service center.

This product was first available on Amazon.fr on August 28, 2015.

© 2024 Eurom. All rights reserved.

This manual is for informational purposes only. Specifications are subject to change without notice.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.