Olympus IS 10 Film Camera Instruction Manual

Introduction

This manual provides essential instructions for the safe and effective use of your Olympus IS 10 Film Camera. Please read this manual thoroughly before using the camera and keep it in a safe place for future reference. The Olympus IS 10 is a 35mm point-and-shoot film camera featuring a 28-110mm Glass Aspherical AF Zoom Lens and Intelligent Flash.

Setup

1. Battery Installation

The Olympus IS 10 requires batteries for operation. Locate the battery compartment cover, typically on the bottom or side of the camera. Open the cover and insert the required batteries, ensuring correct polarity (+/-) as indicated inside the compartment. Close the cover securely.

2. Film Loading

Open the camera back cover by sliding the latch, usually located on the side of the camera body.
Place a 35mm film cartridge into the film chamber.
Pull the film leader across to the film take-up spool, aligning it with the orange mark or insertion point.
Close the camera back cover firmly until it clicks shut. The camera will automatically advance the film to the first frame. The frame counter will display '1'.

3. Strap Attachment

Attach the camera strap to the strap lugs located on the camera body. Ensure the strap is securely fastened to prevent accidental drops.

Operation

1. Power On/Off

To power on the camera, slide the ON/OFF switch, typically located near the top left of the camera body. To power off, slide the switch back to the OFF position.

Olympus IS 10 Film Camera front-top view with lens and power switch

Image: Front-top view of the Olympus IS 10 camera, showing the lens, power switch, and some control buttons. The lens is extended, indicating the camera is powered on or ready for use.

2. Focusing and Zooming

The Olympus IS 10 features a 28-110mm autofocus zoom lens. Use the zoom lever, usually located near the shutter button, to adjust the focal length. The camera will automatically focus on your subject when the shutter button is half-pressed.

3. Shooting Modes

The camera offers various shooting modes, including a 'FULL AUTO' mode for simplified operation. Select your desired mode using the mode dial or buttons, typically located on the top right of the camera. Refer to the display for the selected mode.

Olympus IS 10 Film Camera rear-top view with controls

Image: Rear-top view of the Olympus IS 10 camera, highlighting the control panel with buttons for flash, full auto mode, zoom, and the Quartzdate settings. The LCD display is also visible.

4. Flash Operation

The camera is equipped with an Intelligent Flash. Press the flash button to cycle through different flash modes (e.g., Auto Flash, Red-eye Reduction, Flash Off, Fill-in Flash). The selected mode will be indicated on the camera's display.

5. Shutter Release

To take a picture, compose your shot and gently press the shutter button located on the top of the camera. Pressing halfway will activate autofocus and exposure metering. Pressing fully will release the shutter and capture the image.

6. Quartzdate Function

The Quartzdate function allows you to imprint the date or time onto your photographs. Use the 'MODE' and 'SET' buttons, typically found on the rear of the camera, to adjust the date/time settings and activate/deactivate the imprint function.

Olympus IS 10 Film Camera top view showing Quartzdate controls

Image: Top view of the Olympus IS 10 camera, clearly showing the 'QUARTZDATE' display and its 'MODE' and 'SET' buttons for date imprinting functionality.

7. Film Rewinding and Unloading

Once all frames on the film roll have been exposed, the camera will automatically rewind the film back into its cartridge. Wait for the rewinding process to complete (indicated by a sound or display message), then open the camera back cover and remove the film cartridge.

Maintenance

1. Cleaning the Camera

Camera Body: Use a soft, dry cloth to wipe the camera body. For stubborn dirt, slightly dampen the cloth with water and then wipe dry. Avoid using organic solvents.
Lens: Use a lens brush or a blower to remove dust. For smudges, use a specialized lens cleaning cloth and lens cleaning fluid. Do not touch the lens surface with your fingers.
Film Chamber: Keep the film chamber clean and free of dust or debris, which can scratch film. Use a blower brush if necessary.

2. Battery Care

Remove batteries if the camera will not be used for an extended period to prevent leakage. Store batteries in a cool, dry place. Dispose of used batteries responsibly according to local regulations.

3. Storage

Store the camera in a cool, dry, and well-ventilated place, away from direct sunlight, high temperatures, high humidity, and strong magnetic fields. Use a desiccant if storing in humid environments.

Troubleshooting

Camera does not power on: Check if the batteries are inserted correctly and are not depleted. Replace with fresh batteries if necessary.
Flash does not fire: Ensure the flash mode is not set to 'Flash Off'. Check battery level. In some low-light conditions, the flash may not fire if the camera determines sufficient ambient light.
Pictures are out of focus: Ensure the subject is within the camera's focusing range. Half-press the shutter button to allow the camera to focus before fully pressing. Avoid shooting through dirty or smudged lenses.
Film does not advance/rewind: Check if the film is loaded correctly. Ensure the camera back is securely closed. If the issue persists, the film may be jammed or the camera may require servicing.
Error message on display: Consult the camera's display for specific error codes or messages. If the message is not clear, try turning the camera off and on again.

If you encounter persistent issues not covered here, please refer to the support section.

Specifications

Brand	Olympus
Model Name	IS 10
Item Model Number	101-950
Lens	28-110mm Glass Aspherical AF Zoom Lens
Film Format Type	35mm
Shutter Type	Focal Plane Shutter
Special Feature	Compact
Included Components	Camera Body & Lens
Item Weight	1.5 pounds
Package Dimensions	7.99 x 5.98 x 2.99 inches
UPC	050332316157

Warranty and Support

For warranty information, please refer to the documentation provided at the time of purchase or contact your retailer. Olympus provides customer support for their products. For technical assistance, service, or further inquiries, please visit the official Olympus website or contact their customer service department. Keep your purchase receipt as proof of purchase for warranty claims.

Note: This manual is for informational purposes. Product features and specifications are subject to change without notice.

	Olympus Pen-S Camera User Manual and Specifications A comprehensive guide to the Olympus Pen-S camera, detailing its specifications, features, operation, and accessories. Learn how to load film, set focus and exposure, use the viewfinder, and maintain your camera for optimal performance.
	Olympus PEN EES-2: Vintage Half-Frame 35mm Camera Overview and Specifications Explore the features, specifications, and accessories of the classic Olympus PEN EES-2, a lightweight and compact half-frame 35mm film camera known for its programmed EE exposure system and Zuiko lens.
	Olympus XA1 35mm Camera and A9M Electronic Flash Overview Detailed overview of the Olympus XA1 compact 35mm film camera and its compatible A9M electronic flash unit, covering features, specifications, and components.
	Olympus OM-1 Instruction Manual Comprehensive instructions and specifications for the Olympus OM-1 35mm single-lens reflex camera, covering controls, operation, and technical details.
	Olympus Stylus 105 35mm Film Camera User Manual Comprehensive user manual for the Olympus Stylus 105 35mm film camera, detailing its features, operation, flash modes, exposure settings, care instructions, and technical specifications.
	Olympus Pen EES-2 Camera: Official Instructions and User Guide Explore the Olympus Pen EES-2, a classic half-frame 35mm film camera. This official instruction manual details its components, features, operation, flash photography, and accessories for optimal use.

Olympus IS 10 (Model 101-950)