1. Introduction
The NuFACE MINI is a compact microcurrent facial toning device designed to provide a non-invasive solution for improving facial contour and tone, and reducing the appearance of fine lines and wrinkles. This device utilizes low-level electrical currents to stimulate the skin and underlying muscles, offering a convenient 5-minute treatment for at-home use. This manual provides essential information for the safe and effective operation of your NuFACE MINI device.
Figure 1: The NuFACE MINI Starter Kit, featuring the device, Hydrating Aqua Gel primer, and power adapter.
2. Safety Information
Please read all safety instructions before using your NuFACE MINI device. Failure to follow these instructions may result in injury or device malfunction.
- The NuFACE Trinity, TRINITY+, Mini, MINI+ and FIX facial trainer devices are contraindicated against and should not be used if you have epilepsy or seizures, or if you have an electronic implanted device such as a defibrillator, pacemaker or ECG monitor.
- The devices should also not be used if you are pregnant, have active cancer or are under the age of 18.
- If you have any medical concerns, please consult your doctor before using a device.
- It is recommended to wait 2 weeks after receiving a hydrafacial, Botox, or fillers before using the device.
- Wait 1 week after a microneedling treatment before using the device.
3. Package Contents
Verify that all items are present in your NuFACE MINI Starter Kit:
- NuFACE MINI Petite Facial Toning Device
- NuFACE Hydrating Leave-On Gel Primer (2 fl oz)
- User Manual + Quick Start Guide
- Power Adapter
4. Setup and Charging
Before first use, fully charge your NuFACE MINI device.
- Connect the power adapter to the charging port on the NuFACE MINI device.
- Plug the power adapter into a wall outlet.
- The indicator lights on the device will illuminate to show charging status. A full charge is indicated when all lights are solid.
- For optimal battery life, it is recommended to charge your Mini Device at least once a week for 8 hours. A fully-charged device should last 1-2 weeks based on daily usage of 5-20 minutes.
Figure 2: The NuFACE MINI device, showing the power button and indicator lights.
5. Operating Instructions
Follow these steps for a typical 5-minute NuFACE MINI treatment:
- Cleanse Skin: Begin with clean, dry skin. Remove all makeup and skincare products.
- Apply Gel Primer: Apply a mask-like layer of NuFACE Hydrating Leave-On Gel Primer to the treatment area. Ensure the skin remains wet throughout the treatment. Reapply if the gel starts to dry.
- Power On: Press the power button to turn on the device. Adjust the intensity level if desired (refer to Quick Start Guide for specific intensity settings).
- Perform Glides: Glide the device over the natural contours of your face and neck. Perform glides in an upward motion, holding for a few seconds at the end of each glide. Refer to the Quick Start Guide or official NuFACE tutorials for recommended glide paths.
- Treatment Duration: Each treatment area typically requires 5 minutes. The device is designed for daily use, 5 minutes a day, 5 days a week for optimal results.
- Power Off: Press and hold the power button to turn off the device after your treatment.
- Massage in Primer: Gently massage any remaining gel primer into your skin.
Figure 3: Demonstrating the proper technique for gliding the NuFACE MINI device on the cheek.
6. Maintenance and Care
Proper care ensures the longevity and performance of your device.
- Cleaning: After each use, wipe the device's spheres with a damp, lint-free cloth. Do not submerge the device in water.
- Storage: Store the device in a cool, dry place. Keep it away from direct sunlight and extreme temperatures.
- Charging: Adhere to the recommended charging schedule to maintain battery health.
7. Troubleshooting
If you encounter issues with your NuFACE MINI, refer to the following common solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Stinging or tingling sensation during use. | Insufficient gel primer or dry skin. | Ensure a generous, mask-like layer of NuFACE Hydrating Leave-On Gel Primer is applied to the treatment area. Reapply if the gel begins to dry during the treatment. |
| Device not turning on. | Low battery or device not charged. | Charge the device for at least 8 hours. Ensure the power adapter is properly connected to the device and a working outlet. |
| No sensation during treatment. | Insufficient gel primer, low intensity setting, or device malfunction. | Apply more gel primer. Increase the intensity setting. If the problem persists after ensuring proper gel application and charging, contact customer support. |
8. Specifications
| Feature | Detail |
|---|---|
| Model Number | 40300 |
| Product Dimensions | 2 x 1.5 x 1 inches |
| Weight | 1.6 ounces |
| UPC | 858271002793 |
| Manufacturer | NuFACE |
| ASIN | B00JRW7QCC |
9. Warranty and Support
The NuFACE MINI device comes with a 1-year manufacturer warranty. For warranty claims, technical assistance, or further inquiries, please contact NuFACE customer support directly. Keep your proof of purchase for warranty validation.
For additional resources, including video tutorials and frequently asked questions, visit the official NuFACE website.
