1. Introduction
This manual provides essential information for the safe and effective installation, operation, and maintenance of your Samsung MKV190CL2B/E01 Compressor. This component is an authorized aftermarket replacement part designed to fit various Samsung brand appliance models. Please read this manual thoroughly before proceeding with any installation or service.
Safety Information
WARNING: Appliance repair, especially involving refrigeration systems, can be hazardous. It is strongly recommended that installation and service be performed by a qualified technician. Disconnect power to the appliance before attempting any installation or maintenance.
Always wear appropriate personal protective equipment (PPE) such as safety glasses and gloves. Ensure proper ventilation when working with refrigerants.
2. Setup and Pre-Installation Checks
Before installing the Samsung MKV190CL2B/E01 Compressor, it is critical to verify compatibility with your specific appliance model. Replacement parts can appear similar but may not function correctly or safely if not matched to the correct model.
Figure 2.1: Important reminder to verify part compatibility. Always check your appliance's model number against the compressor's specifications before installation to ensure proper fit and function.
Installation Steps (Professional Installation Recommended)
- Disconnect Power: Ensure the appliance is completely disconnected from its power source.
- Access Compressor: Carefully access the compressor compartment of your appliance. This may involve removing back panels or other components.
- Refrigerant Recovery: If the system contains refrigerant, it must be properly recovered by a certified technician using appropriate equipment. Do not vent refrigerants into the atmosphere.
- Remove Old Compressor: Disconnect all electrical wiring and refrigerant lines from the old compressor. Note the position and connection of each component for correct reinstallation.
- Install New Compressor: Position the new Samsung MKV190CL2B/E01 Compressor in the designated location. Secure it firmly.
- Connect Lines and Wiring: Reconnect refrigerant lines and electrical wiring according to the appliance's service manual. Ensure all connections are secure and leak-free.
- Evacuate and Recharge: The refrigeration system must be evacuated to remove air and moisture, then recharged with the correct type and amount of refrigerant as specified by the appliance manufacturer. This step requires specialized tools and expertise.
- Leak Check: Perform a thorough leak check on all new connections.
- Restore Power: Once installation is complete and verified, restore power to the appliance.
Figure 2.2: The Samsung MKV190CL2B/E01 Compressor. This image shows the general appearance of the unit, including its compact design and connection points for refrigerant lines and electrical wiring.
3. Operating Principles
The Samsung MKV190CL2B/E01 Compressor is a vital component in your refrigeration system, responsible for circulating refrigerant and maintaining the desired temperature. Once properly installed and the appliance is powered on, the compressor will operate automatically as needed to cool the appliance's interior.
- The compressor draws in low-pressure, low-temperature gaseous refrigerant from the evaporator.
- It compresses this gas, increasing its pressure and temperature.
- The high-pressure, high-temperature gas then flows to the condenser, where it releases heat and condenses into a liquid.
- The liquid refrigerant then passes through an expansion device, reducing its pressure and temperature before returning to the evaporator to absorb heat, completing the cycle.
The compressor's operation is controlled by the appliance's thermostat or control board, which cycles it on and off to maintain the set temperature.
4. Maintenance
Proper maintenance ensures the longevity and efficiency of your appliance and its components, including the compressor. While the compressor itself requires minimal direct user maintenance, regular checks of the surrounding system are beneficial.
- Keep Condenser Coils Clean: Dust and debris on the condenser coils (usually located at the back or bottom of the appliance) can hinder heat dissipation, forcing the compressor to work harder. Clean these coils regularly with a brush or vacuum cleaner.
- Check for Proper Ventilation: Ensure the appliance has adequate clearance around it for proper airflow, especially around the compressor compartment.
- Monitor for Unusual Noises: While some operational noise is normal, listen for any new or excessively loud sounds coming from the compressor area, which could indicate a problem.
- Inspect Electrical Connections: Periodically, and with power disconnected, visually inspect electrical connections to the compressor for any signs of wear, corrosion, or looseness.
For any complex maintenance or service, consult a qualified appliance technician.
5. Troubleshooting
This section provides general troubleshooting tips for common issues related to refrigeration compressors. For specific appliance issues, refer to your appliance's user manual or consult a professional.
| Problem | Possible Cause | Solution |
|---|---|---|
| Compressor not starting | No power to appliance; faulty thermostat/control board; faulty start relay/capacitor; compressor failure. | Check power supply. Consult a technician to diagnose and replace faulty electrical components or the compressor if necessary. |
| Appliance not cooling sufficiently | Dirty condenser coils; low refrigerant charge; faulty fan motor; compressor running inefficiently. | Clean condenser coils. A technician should check refrigerant levels and system components. |
| Unusual noises from compressor area | Loose mounting; worn internal components; refrigerant line vibration. | Ensure compressor is securely mounted. If noise persists, professional diagnosis is required as it may indicate internal wear. |
| Compressor runs continuously | Dirty condenser coils; door seal leaks; low refrigerant; faulty thermostat. | Clean coils, check door seals. A technician can assess refrigerant levels and thermostat function. |
Note: Many troubleshooting steps for refrigeration systems require specialized tools and knowledge. Attempting repairs without proper training can lead to further damage or personal injury.
6. Specifications
The following are the technical specifications for the Samsung MKV190CL2B/E01 Compressor:
- Brand: Samsung
- Model Number: MKV190CL2B/E01
- Part Number: MKV190CL2B/E01
- Manufacturer: Samsung
- Item Weight: 22.2 Pounds (approximately 10.07 kg)
- Product Dimensions: 13 x 10 x 11 inches (approximately 33 x 25.4 x 27.9 cm)
- Color: Black
- Power Source: AC
- Included Components: Appliance replacement parts (compressor unit)
- Batteries Required: No
- UPC: 716686375256
- Date First Available: April 10, 2015
Note: Specifications are subject to change without notice. Always refer to the specific appliance's service manual for detailed compatibility and system requirements.
7. Warranty and Support
For information regarding the warranty coverage for your Samsung MKV190CL2B/E01 Compressor, please refer to the documentation provided with your original appliance or contact Samsung customer support directly. Warranty terms may vary based on region and purchase conditions.
For technical assistance, service inquiries, or to locate authorized service centers, please visit the official Samsung support website or contact their customer service hotline. When contacting support, have your appliance's model and serial number, as well as the compressor's part number (MKV190CL2B/E01), readily available.
Samsung Support Website: www.samsung.com/us/support/
