Introduction
The Waterpik Aquarius Water Flosser WP-660 is an advanced oral hygiene device designed to provide effective cleaning for teeth, gums, and dental work. It utilizes a combination of water pressure and pulsations to remove plaque bacteria and improve gum health. This manual provides detailed instructions for the proper setup, operation, maintenance, and troubleshooting of your Waterpik Aquarius Water Flosser.

Safety Information
Please read all instructions before using this product. When using electrical products, especially when children are present, basic safety precautions should always be followed.
- Do not direct water under the tongue, into the ear, nose or other delicate areas.
- Only use tips and accessories recommended by Water Pik, Inc.
- Use this product only as indicated in the instruction manual or as recommended by your dental professional.
What's Included in the Box
Your Waterpik Aquarius Water Flosser WP-660 comes with the following components:
- Waterpik Aquarius Water Flosser Unit
- 7 Flossing Tips, including:
- Classic Jet Tips (for general use)
- Plaque Seeker Tip (for implants, crowns, bridges, and other restorations)
- Orthodontic Tip (for braces)
- Pik Pocket Tip (for periodontal pockets)
- Toothbrush Tip (for brushing and flossing simultaneously)

Setup
Follow these steps for the initial setup of your Waterpik Aquarius Water Flosser:
- Place the unit on a flat, stable surface near an electrical outlet and a sink.
- Fill the reservoir with warm water. For best results, use lukewarm water.
- Insert your desired flossing tip into the handle until it clicks into place.
- Ensure the power cord is securely plugged into a 120VAC/60Hz outlet.
- For first-time use, prime the unit by setting the pressure control dial to high, pointing the tip into the sink, and turning the unit ON until water flows from the tip. Then turn it OFF.

Operating Instructions
To use your Waterpik Aquarius Water Flosser effectively, follow these steps:
- Select your desired pressure setting using the dial on the unit (10 settings available). First-time users should start at the lowest setting and gradually increase.
- Lean over the sink and place the tip in your mouth.
- Turn the unit ON using the power button on the base.
- Turn the water ON using the switch on the handle.
- Aim the tip along the gumline at a 90-degree angle, pausing briefly between teeth. Close your lips enough to prevent splashing while allowing water to flow from your mouth into the sink.
- Floss both the inside and outside surfaces of your upper and lower teeth. The built-in timer/pacer will pause briefly at 30 seconds and 1 minute to help you track flossing time.
- After use, turn the water OFF on the handle, then turn the unit OFF on the base.
- Empty any remaining water from the reservoir.

Special Features:
- 10 Pressure Settings: Customize the water pressure from gentle to maximum cleaning.
- Massage Mode: Provides gum stimulation for improved circulation and gum health.
- Timer/Pacer: A built-in timer pauses briefly at 30 seconds and 1 minute to guide you through recommended flossing time.
- 360-Degree Tip Rotation: The tip rotates to easily reach all areas of your mouth, including back teeth.

Maintenance
Regular cleaning and maintenance will ensure the longevity and optimal performance of your Waterpik Aquarius Water Flosser.
- Daily Cleaning: After each use, empty any remaining water from the reservoir.
- Reservoir Cleaning: The removable 22 oz reservoir is top-rack dishwasher safe for easy cleaning. It is recommended to clean it regularly to prevent mineral buildup.
- Unit Exterior: Wipe the exterior of the unit with a soft cloth and mild, non-abrasive cleaner as needed.
- Tip Replacement: Replace flossing tips every 3 months for optimal hygiene and performance, or sooner if they show signs of wear.
Troubleshooting
If you encounter issues with your Waterpik Aquarius Water Flosser, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Unit does not turn on | Not plugged in; Power outlet issue; Unit malfunction | Ensure power cord is securely plugged in. Test the outlet with another device. If still no power, contact customer support. |
| Low water pressure | Pressure setting too low; Mineral buildup; Clogged tip | Increase the pressure setting. Clean the unit and tips to remove mineral buildup. Replace the tip if it appears clogged or damaged. |
| Water leaks from unit | Reservoir not seated correctly; Hose or tip connection loose | Ensure the reservoir is firmly seated on the base. Check that the flossing tip is securely clicked into the handle. Inspect hose for damage. |
| No water flow | Reservoir empty; Tip not inserted correctly; Air lock | Fill the reservoir. Re-insert the tip until it clicks. Prime the unit by running it on high pressure with the tip pointed into the sink until water flows. |
Specifications
Detailed technical specifications for the Waterpik Aquarius Water Flosser WP-660:
| Feature | Detail |
|---|---|
| Model Number | WP-660/660C |
| Product Dimensions | 3.8 x 4.7 x 10.3 inches |
| Weight | 1.46 Pounds |
| Power Source | Corded Electric (120VAC/60Hz for North America only) |
| Water Capacity | 22 oz (90+ seconds of flossing time) |
| Pressure Settings | 10 |
| Special Features | Timer, Multiple Pressure Settings, Rotatable Tip, Multiple Operation Modes (Floss, Massage), Multiple Tips |
| Product Benefits | Removes Plaque, ADA Accepted for Safety and Effectiveness, Gum Health |
| Country of Origin | China |
Warranty and Support
The Waterpik Aquarius Water Flosser WP-660 is backed by a 3-year limited manufacturer’s warranty. For detailed warranty information, please refer to the product manual included in your packaging or visit the official Waterpik website.
Should you have any product questions or require assistance, Waterpik’s Colorado-based support team is available to help. Contact information can typically be found on the product packaging or the official Waterpik website.