Viper 2-Way LCD Remote Control (DEI7756V) User Manual

Introduction

This manual provides comprehensive instructions for the operation and maintenance of your Viper 2-Way LCD Remote Control (Model DEI7756V). This remote serves as an additional or replacement unit for compatible Viper security and remote start systems. It features up to one-mile range, a rechargeable battery, and a premium LCD display for visual and audible confirmation of commands.

Figure 1: Front view of the Viper 2-Way LCD Remote Control, displaying an illuminated screen with a lock icon and time. This remote provides visual feedback on your vehicle's status.

System Compatibility

The DEI7756V remote is compatible with the following Viper security and remote start systems:

• 3706V
• 3806V
• 4706V
• 4606V
• 5606V
• 5706V
• 5806V
• 9756V

Ensure your existing Viper system is listed above for proper functionality.

Setup and Pairing

To ensure proper operation, the remote control must be paired with your Viper security and remote start system. The pairing process typically involves placing the vehicle's system into programming mode and then activating the remote.

Pairing the Remote Control with Your System:

1. Prepare the vehicle system: Refer to your Viper system's main unit manual for specific instructions on entering programming mode. This often involves turning the ignition key to the ON position and pressing a control button (e.g., Valet button) a specific number of times. The system will usually respond with a chirp or LED flash to indicate it's in programming mode.
2. Activate the remote: While the vehicle system is in programming mode, press and hold the LOCK button on the DEI7756V remote until the remote's LCD screen displays "PROG" or a similar indication.
3. Confirm pairing: The vehicle system should respond with a chirp or flash to confirm successful pairing. The remote's LCD may also show a confirmation message.
4. Exit programming mode: Turn the vehicle's ignition key to the OFF position to exit programming mode. Test the remote's functions to ensure proper operation.

Note: If you encounter difficulties, consult the detailed user guide for your specific Viper system or seek professional installation assistance.

Operating Instructions

The DEI7756V remote features a 5-button layout with a premium LCD display for intuitive control and feedback.

Figure 2: The Viper 2-Way LCD Remote Control, showing the main lock and unlock buttons and the blank LCD screen when not active.

Basic Functions:

• Lock: Press the LOCK button once to arm your security system and lock your vehicle's doors. The remote's LCD will display a lock icon and provide audible confirmation.
• Unlock: Press the UNLOCK button once to disarm your security system and unlock your vehicle's doors. The remote's LCD will display an unlock icon and provide audible confirmation.
• Remote Start: To remote start your vehicle, press and hold the Remote Start button (often indicated by a lightning bolt or similar icon) for approximately 3 seconds. The remote will confirm the command on its LCD.
• Trunk Release: If programmed, press and hold the Trunk Release button (often indicated by a trunk icon) for approximately 3 seconds to open your vehicle's trunk.
• Panic/Car Finder: Press the Panic button (often indicated by a siren icon) to activate the vehicle's alarm. Press again to disarm. This can also be used to locate your vehicle in a crowded parking lot.

The premium LCD display provides visual feedback on the status of your vehicle, including lock/unlock status, remote start confirmation, and battery level.

Figure 3: Side view of the Viper 2-Way LCD Remote Control, highlighting the additional function buttons located on the side of the device.

Maintenance and Charging

The DEI7756V remote control features a rechargeable battery. Regular charging ensures optimal performance and range.

Charging the Remote:

• Locate the micro USB charging port on the side of the remote control.
• Connect a standard micro USB cable to the remote and to a USB power source (e.g., computer USB port, wall adapter).
• The LCD screen will typically display a charging indicator. Allow the remote to charge fully.
• Disconnect the cable once charging is complete.

Note: A full charge can last for an extended period, providing convenience and reliability.