Introduction
This manual provides essential information for the proper installation, maintenance, and care of your Chrysler Genuine 5020664AC B-Pillar Molding. Please read this manual thoroughly before beginning installation to ensure correct procedure and optimal performance.
Safety Information
Always exercise caution when working with automotive parts. Wear appropriate personal protective equipment (PPE) such as gloves and eye protection. Ensure the vehicle is stable and secure before beginning any work. Keep small parts away from children.
Package Contents
Verify that all components are present and undamaged upon opening the package.
- 1 x Chrysler Genuine 5020664AC B-Pillar Molding
Figure 1: Front view of the B-Pillar Molding, showing its overall shape and finish.
Installation Instructions
This B-Pillar Molding is designed for direct replacement or installation on the vehicle's B-pillar surface. Proper surface preparation is crucial for secure adhesion.
- Prepare the Surface: Thoroughly clean the B-pillar surface where the molding will be applied. Use an automotive-grade degreaser or alcohol wipe to remove any dirt, wax, or grease. Allow the surface to dry completely.
- Test Fit: Before removing the adhesive backing, carefully position the molding on the B-pillar to ensure it aligns correctly. Note the exact placement.
- Apply Adhesive (Optional, Recommended): For enhanced adhesion, a thin layer of automotive-grade adhesive (e.g., strong automotive adhesive) can be applied to the back of the molding, avoiding the pre-applied adhesive strips. This step is optional but recommended for a more solid bond.
- Remove Adhesive Backing: Carefully peel off the protective film from the adhesive strips on the back of the molding. It is critical not to remove the adhesive tape until the piece is ready for final installation.
- Install the Molding: Align the molding with the prepared B-pillar surface and firmly press it into place. Apply even pressure along the entire length of the molding to ensure full contact with the adhesive. Hold pressure for several minutes.
- Curing Time: Allow the adhesive to cure for at least 24 hours before exposing the vehicle to extreme weather conditions or car washes. Refer to the adhesive manufacturer's instructions if an additional adhesive was used.
Figure 2: Rear view of the B-Pillar Molding, highlighting the pre-applied adhesive strips for installation.
Maintenance
The B-Pillar Molding requires minimal maintenance. Regularly clean the surface with standard automotive cleaning products. Avoid abrasive cleaners or harsh chemicals that could damage the finish or adhesive bond.
Troubleshooting
- Molding not adhering properly: Ensure the surface was thoroughly cleaned and dry before installation. Temperature can affect adhesive performance; install in moderate temperatures. Re-apply with a stronger automotive adhesive if necessary.
- Molding appears misaligned: This typically occurs during initial placement. If the adhesive has not fully cured, it may be possible to carefully reposition. If fully cured, removal may damage the molding or vehicle surface.
Specifications
| Attribute | Detail |
|---|---|
| Product Type | Auto Part (B-Pillar Molding) |
| Brand | Chrysler |
| Model Number | 5020664AC |
| Manufacturer Part Number | 5020664AC |
| Item Weight | 7.2 ounces (0.44974301448 Pounds) |
| Package Dimensions | 25.98 x 10 x 0.2 inches |
| Surface Recommendation | Pillar |
Warranty and Support
For warranty information or technical support regarding your Chrysler Genuine 5020664AC B-Pillar Molding, please contact Chrysler customer service or refer to the official Chrysler website. Keep your purchase receipt as proof of purchase.
Visit the official Chrysler store for more information: Chrysler Store
