1. Introduction
The Lafayette SUBHEAD is a robust and versatile LED flashlight designed for various applications, including underwater use. Featuring a powerful 170 lumen Luxeon Rebel LED, it provides bright illumination and includes an emergency flashing mode. Its durable construction, magnetic rotary switch, and resistance to corrosion and chemicals make it an ideal tool for demanding environments. This manual provides essential information for the proper setup, operation, and maintenance of your SUBHEAD flashlight.
2. Safety Information
- Battery Safety: Use only specified 1.5V AAA Alkaline batteries. Do not mix old and new batteries, or different types of batteries. Ensure correct polarity when inserting. Remove batteries if the device will not be used for an extended period to prevent leakage.
- Water Immersion: Ensure the battery compartment is securely sealed before submerging the flashlight. Do not exceed the maximum immersion depth of 30 meters.
- Light Beam: Do not look directly into the LED light beam, as it can cause temporary vision impairment.
- Maintenance: Do not attempt to disassemble or modify the flashlight beyond the instructions provided in this manual. Refer all servicing to qualified personnel.
- Storage: Store the flashlight in a cool, dry place away from direct sunlight and extreme temperatures.
3. Package Contents
Verify that all items are present in your package:
- Lafayette SUBHEAD LED Flashlight
- 4 x 1.5V AAA Alkaline Batteries (pre-installed or separate)
- Adjustable Headband
4. Setup
4.1 Battery Installation
- Locate the battery compartment cap, typically at the rear or side of the flashlight head.
- Unscrew or unlatch the cap carefully.
- Insert four (4) 1.5V AAA Alkaline batteries, ensuring correct polarity (+/-) as indicated inside the compartment.
- Securely close the battery compartment cap. For water resistance, ensure the O-ring seal is clean and properly seated before tightening.
Figure 1: Lafayette SUBHEAD LED Flashlight with its adjustable headband. The main light unit is yellow and black, attached to a black elastic strap.
4.2 Headband Adjustment
The SUBHEAD flashlight comes with an adjustable headband for comfortable wear. Adjust the straps to fit snugly around your head or helmet. The flashlight unit can be tilted to direct the light beam as needed.
Figure 2: Top-down view of the Lafayette SUBHEAD flashlight, showing how the yellow and black light unit is mounted on the black elastic headband.
5. Operating Instructions
5.1 Power On/Off and Mode Selection
The SUBHEAD flashlight features a magnetic rotary switch for easy operation, even with gloves or underwater.
- To Turn On: Rotate the magnetic switch clockwise from the OFF position.
- To Select Modes: Continue rotating the switch to cycle through available lighting modes (e.g., full brightness, emergency flashing).
- To Turn Off: Rotate the magnetic switch counter-clockwise back to the OFF position.
5.2 Adjustable Lighting Angle
The flashlight head can be manually tilted up or down to adjust the lighting angle, allowing you to direct the beam precisely where needed.
6. Maintenance
- Cleaning: After use, especially after submersion, rinse the flashlight with fresh water to remove salt or debris. Wipe dry with a soft cloth.
- O-Ring Care: Periodically inspect the O-ring seal in the battery compartment for cracks or damage. Keep it clean and lightly lubricated with silicone grease to maintain water resistance.
- Battery Replacement: Replace all four AAA batteries simultaneously when the light becomes dim or stops functioning. Dispose of used batteries responsibly.
- Corrosion and Chemical Resistance: The flashlight is designed to be resistant to corrosion and certain chemicals. However, avoid prolonged exposure to harsh chemicals that may damage the housing or seals.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Flashlight does not turn on. | Dead or incorrectly inserted batteries. | Replace batteries, ensuring correct polarity. |
| Light is dim or flickers. | Low battery power. | Replace all four AAA batteries. |
| Water inside battery compartment. | Improperly sealed battery cap or damaged O-ring. | Open compartment, dry thoroughly. Inspect and clean O-ring, apply silicone grease, and ensure cap is securely tightened. Replace O-ring if damaged. |
| Magnetic switch is stiff. | Debris or corrosion. | Rinse with fresh water and clean around the switch mechanism. |
8. Specifications
| Model: | SUBHEAD |
| Brand: | LAFAYETTE |
| Light Source: | 1 x Luxeon Rebel LED |
| Lumen Output: | 170 lumens |
| Flash Intensity: | 3400 cd |
| Flash Distance: | 115 meters |
| Water Resistance: | Up to 30 meters immersion depth |
| Impact Resistance: | 1 meter |
| Switch Type: | Magnetic Rotary Switch (Anti-corrosion) |
| Batteries: | 4 x 1.5V AAA Alkaline (included) |
| Battery Life: | 1.30 hours (continuous on), 6 hours (flashing) |
| Dimensions (L x W x H): | 110 x 80 x 90 mm |
| Weight: | 180 grams (with batteries) |
| Chemical Resistance: | Yes |
9. Warranty and Support
For warranty information or technical support, please contact your retailer or the manufacturer, MARCUCCI S.P.A. Keep your purchase receipt as proof of purchase.
Manufacturer: MARCUCCI S.P.A.
For further assistance, please visit the official LAFAYETTE website or contact their customer service.
