1. Introduction
The Elero MonoTel 2 is a pure white, 1-channel remote control operating at an 868 MHz wireless radio frequency. It is designed for convenient control of roller shutters, blinds, and awnings. This manual provides essential information for the setup, operation, and maintenance of your device.
Figure 1: Front view of the Elero MonoTel 2 Remote Control. The device is white with a dark grey base, featuring three central buttons: an upper square button, a circular button with an orange ring, and a lower square button. The Elero logo is visible on the dark grey base.
2. Key Features
- Easy-to-use On/Off Buttons: Designed for intuitive control with a clear LED viewing window.
- Magnetic Wall Mount: For convenient storage and accessibility.
- Battery Powered: Uses common batteries (not included).
- Versatile Compatibility: Supports both unidirectional and bidirectional radio systems.
- Advanced Control Options: Allows for intermediate positioning and ventilation functions.
3. Setup
3.1. Battery Installation
- Locate the battery compartment on the back of the remote control.
- Open the compartment cover.
- Insert the required common batteries, ensuring correct polarity (+/-).
- Close the battery compartment cover securely.
3.2. Pairing with Receiver
Refer to the instruction manual of your Elero receiver (e.g., for roller shutters, blinds, or awnings) for specific pairing procedures. Generally, this involves:
- Activating the programming mode on your receiver.
- Pressing a specific button sequence on the MonoTel 2 remote control within a set timeframe.
- Confirming successful pairing, often indicated by an LED on the receiver or the remote.
3.3. Wall Mount Installation
The MonoTel 2 comes with a magnetic wall mount. Choose a suitable location, ensuring it is within range of your controlled devices. Secure the wall mount using appropriate screws (not included) and then simply attach the remote control to the magnetic mount.
4. Operating Instructions
The MonoTel 2 remote control features three primary buttons for operation:
- Upper Square Button: Typically used for Up or Open functions (e.g., raising a shutter).
- Circular Button (with orange ring): Functions as the Stop or Intermediate Position button. Pressing it during movement will stop the device. A quick press can activate a pre-set intermediate position.
- Lower Square Button: Typically used for Down or Close functions (e.g., lowering a shutter).
4.1. Basic Control
- To move the device up/open: Press the Upper Square Button.
- To move the device down/close: Press the Lower Square Button.
- To stop the device: Press the Circular Button during movement.
4.2. Intermediate Position and Ventilation
If configured with your receiver, a short press of the Circular Button can activate a pre-programmed intermediate position. Consult your receiver's manual for programming these advanced functions.
5. Maintenance
5.1. Cleaning
Wipe the remote control with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these can damage the surface.
5.2. Battery Replacement
When the LED viewing window indicates low battery or the remote's range decreases, replace the batteries as described in the "Battery Installation" section (3.1). Dispose of old batteries responsibly according to local regulations.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote control not responding. | Dead or incorrectly installed batteries. | Check battery polarity or replace batteries. |
| Limited range or intermittent operation. | Low battery power; interference; remote too far from receiver. | Replace batteries. Ensure no large metal objects are blocking the signal. Move closer to the receiver. |
| Device not pairing with receiver. | Incorrect pairing procedure; receiver not in programming mode. | Review the pairing instructions for both the remote and your specific Elero receiver. Ensure the receiver is in programming mode. |
| LED indicator not lighting up. | No power (dead batteries). | Replace batteries. |
7. Specifications
| Brand | Elero |
| Model | MonoTel 2 |
| Color | Pure White |
| Frequency | 868 MHz |
| Channels | 1 Channel |
| Battery Included | No |
| ASIN | B00EZPYUJ8 |
| Manufacturer | Elero |
8. Warranty and Support
For warranty information and technical support, please refer to the documentation provided with your purchase or visit the official Elero website. Keep your proof of purchase for warranty claims.
Manufacturer: Elero
