1. Introduction
The Sanitas SIH 21 Compressor Nebulizer Inhaler is designed for the treatment of upper and lower respiratory tract conditions. This device effectively nebulizes liquid medications and saline solutions into fine aerosols for inhalation, aiding in the prevention and relief of symptoms associated with respiratory diseases such as colds and bronchitis.
This manual provides essential information for the safe and effective operation, maintenance, and troubleshooting of your SIH 21 inhaler. Please read all instructions carefully before first use and retain this manual for future reference.
2. Safety Information
- Always consult your doctor or pharmacist regarding the suitability of medications for nebulization and the correct dosage.
- This device is intended for personal use and should not be shared without proper disinfection.
- Keep the device out of reach of children when not in use.
- Ensure the device is placed on a stable, flat surface during operation.
- Do not immerse the main compressor unit in water or other liquids.
- Unplug the device from the power outlet before cleaning or if it is not in use for an extended period.
- Use only original Sanitas accessories and replacement parts.
- If you experience any discomfort or adverse reactions during use, discontinue treatment and consult a medical professional.
3. Package Contents
Verify that all components are present in the package:
- Sanitas SIH 21 Compressor Unit
- Nebulizer Cup
- Air Tube
- Mouthpiece
- Adult Mask
- Child Mask
- Elastic Straps for Masks
Figure 1: Sanitas SIH 21 Compressor Nebulizer Inhaler with all included accessories: the main unit, nebulizer cup, air tube, mouthpiece, adult mask, child mask, and elastic straps.
Figure 2: Packaging for the Sanitas SIH 21 Inhaler, illustrating its use for upper and lower respiratory tract treatment.
4. Setup
- Prepare the Compressor Unit: Place the Sanitas SIH 21 compressor unit on a clean, stable, and flat surface. Ensure the air filter is clean and properly installed.
- Connect the Air Tube: Firmly attach one end of the air tube to the air outlet on the compressor unit.
- Prepare the Nebulizer Cup: Open the nebulizer cup and pour the prescribed amount of medication or saline solution into the medication chamber. Do not overfill.
- Assemble the Nebulizer: Close the nebulizer cup securely. Attach the other end of the air tube to the bottom inlet of the nebulizer cup.
- Attach the Inhalation Accessory: Depending on your treatment, attach either the mouthpiece, adult mask, or child mask to the top of the nebulizer cup. Ensure a tight fit.
Figure 3: A person assembling the nebulizer cup and mouthpiece for the Sanitas SIH 21 Inhaler.
Figure 4: The transparent air tube connecting the compressor unit to the nebulizer cup.
Figure 5: Close-up view of the mouthpiece accessory for the Sanitas SIH 21 Inhaler.
Figure 6: The included adult and child masks with elastic straps, designed for comfortable inhalation.
5. Operating Instructions
- Power On: Plug the compressor unit into a suitable electrical outlet. Press the power switch to turn on the device. The compressor will begin to generate air pressure, and the nebulizer will start producing a fine mist.
- Inhale:
- Using the Mouthpiece: Place the mouthpiece between your teeth and seal your lips around it. Breathe in slowly and deeply through your mouth, then exhale slowly.
- Using a Mask: Place the mask over your nose and mouth, ensuring a snug fit. Breathe normally through your nose and mouth.
- Continue Treatment: Continue inhaling until the medication chamber is empty or until the prescribed treatment time has elapsed. The nebulization performance of approximately 1 ml/min allows for shorter inhalation times.
- Power Off: Once the treatment is complete, press the power switch to turn off the device and unplug it from the electrical outlet.
Figure 7: A person demonstrating the use of the Sanitas SIH 21 Inhaler with the mouthpiece attachment.
6. Maintenance and Cleaning
Regular cleaning and disinfection are crucial for the hygienic and effective operation of your inhaler. The entire set is fully disinfectable.
- After Each Use: Disassemble the nebulizer cup, mouthpiece/mask, and air tube. Wash these components with warm water and a mild detergent. Rinse thoroughly with clean water.
- Disinfection: For thorough disinfection, boil the washed components (excluding the air tube and compressor unit) in distilled water for 5 minutes, or use a cold sterilization solution as recommended by your doctor or pharmacist.
- Drying: Allow all components to air dry completely before reassembling or storing.
- Compressor Unit: Wipe the exterior of the compressor unit with a damp cloth. Do not use abrasive cleaners or immerse the unit in water.
- Air Filter: Check the air filter regularly. Replace it if it appears discolored or clogged. Refer to the manufacturer's instructions for filter replacement.
- Storage: Store the clean and dry components in the practical storage bin provided with the device, in a clean, dry place away from direct sunlight.
7. Troubleshooting
If you encounter issues with your Sanitas SIH 21 inhaler, refer to the following common troubleshooting steps:
- No Mist Production:
- Ensure the device is properly plugged in and turned on.
- Check that the air tube is securely connected to both the compressor unit and the nebulizer cup.
- Verify that the nebulizer cup contains medication and is correctly assembled.
- Inspect the air filter for blockages and replace if necessary.
- Weak Mist Production:
- Ensure all connections are tight and there are no leaks in the air tube or nebulizer cup.
- Clean the nebulizer cup and its components thoroughly, as residue can affect performance.
- Check the air filter; a dirty filter can reduce airflow.
- Unusual Noise:
- Ensure the device is on a stable, flat surface.
- If the noise persists and is excessive, contact customer support.
If these steps do not resolve the issue, please contact Sanitas customer support or your retailer for further assistance.
8. Specifications
| Feature | Specification |
|---|---|
| Model | SIH 21 |
| Brand | Sanitas |
| Manufacturer | Beurer GmbH |
| Product Dimensions (L x W x H) | 29.5 x 17.8 x 9.4 cm |
| Item Weight | 1.71 kg |
| Nebulization Performance | Approx. 1 ml/min |
| Technology | Compressor Air Technology |
| Target Audience | Adults, Children |
| Disinfectable Components | Yes (Nebulizer cup, masks, mouthpiece) |
9. Warranty and Support
For warranty information, please refer to the warranty card included with your product or visit the official Sanitas website. If you require technical support, replacement parts, or have questions not covered in this manual, please contact Sanitas customer service directly. Contact details can typically be found on the product packaging or the manufacturer's website.
