PDP Gaming Energizer Dual Controller Charging System

Introduction

Thank you for purchasing the PDP Gaming Energizer Dual Controller Charging System. This system is designed to provide convenient and efficient charging for two Xbox One wireless controllers simultaneously. It includes two 1200mAh Energizer Recharge Battery Packs, offering extended playtime and a clutter-free charging experience.

What's in the Box

• 1 x Dual Controller Charging Station
• 1 x AC Power Adapter
• 2 x Energizer 1200mAh Recharge Battery Packs
• 2 x Black Battery Doors (for Xbox One Standard Controllers)
• 2 x White Battery Doors (for Xbox One Standard Controllers)

Image: Front packaging of the PDP Gaming Energizer Dual Controller Charging System, showing the charging station and two Xbox One controllers.

Image: Back packaging of the charging system, highlighting included battery packs and battery doors (black and white).

Setup Instructions

1. Install Battery Packs: Open the battery compartment on your Xbox One wireless controller. Insert one Energizer Recharge Battery Pack into each controller, ensuring correct polarity.
2. Replace Battery Doors: Replace the original battery doors with the included custom battery doors (choose black or white to match your controller). These doors are designed to allow the controller to make contact with the charging station's conductive pads.
3. Connect Power: Plug the AC power adapter into the charging station and then into a standard wall outlet.
4. Place Controllers: Place your Xbox One controllers onto the charging cradles. Ensure the controllers are seated correctly and the conductive pads on the battery door align with the pins on the charging station.

Operating Instructions

Charging Your Controllers

• Once controllers are placed on the charging cradles, the LED indicators on the front of the station will illuminate.
• A red LED indicates that the controller is currently charging.
• A green LED indicates that the controller is fully charged.
• Charging time from empty to full is approximately 2-3 hours.
• Each fully charged 1200mAh battery pack provides up to 40 hours of playtime.

Compatibility

This charging system is compatible with both Standard Xbox One and Xbox Elite wireless controllers.

Specifications

Troubleshooting

• Controller not charging (LED remains off or red indefinitely):
  • Ensure the AC adapter is securely plugged into both the charging station and a working wall outlet.
  • Verify that the Energizer Recharge Battery Pack is correctly installed in the controller and the custom battery door is properly attached.
  • Check that the controller is seated firmly on the charging cradle, ensuring the conductive pads make proper contact with the charging pins.
  • Try charging a different controller or swapping the battery packs to isolate the issue.
• Short battery life after charging:
  • Ensure the controller was fully charged (green LED) before use.
  • Battery performance can degrade over time. If battery life significantly decreases, consider replacing the Energizer Recharge Battery Packs.
• LED indicator not changing from red to green:
  • This may indicate the battery is not reaching a full charge. Follow the steps for "Controller not charging" above.
  • If the issue persists, the battery pack may be faulty and require replacement.

Warranty and Support

For warranty information or technical support, please refer to the official PDP website or contact their customer service directly. Keep your proof of purchase for any warranty claims.