Beurer 725.30
Contents
Beurer PS160 Digital Bathroom Scale User Manual
Model: PS160 (725.30)
Introduction
Thank you for choosing the Beurer PS160 Digital Bathroom Scale. This manual provides important information regarding the safe and proper use, maintenance, and troubleshooting of your new scale. Please read it thoroughly before first use and keep it for future reference.
The Beurer PS160 is designed for precise and accurate weight measurement in a home environment. Its sleek design, large display, and user-friendly features make it a convenient tool for monitoring your weight.
Safety Information
Please observe the following safety instructions to ensure safe operation and prevent damage to the device or injury:
- Do not step on the scale with wet feet or if the surface is wet, as this may cause slipping.
- Place the scale on a firm, flat surface to ensure accurate measurements. Avoid carpets or uneven flooring.
- The scale is intended for personal use only and not for medical or commercial purposes.
- Keep the scale away from strong electromagnetic fields.
- Do not overload the scale beyond its maximum capacity of 180 kg (396 lb / 28 st).
- Keep batteries out of reach of children. If swallowed, seek immediate medical attention.
- Dispose of batteries according to local regulations.
Package Contents
Upon unpacking, please check that all components are present and undamaged:
- 1 x Beurer PS160 Digital Bathroom Scale
- 1 x 3V CR2032 Battery (pre-installed or included separately)
- 1 x Instruction Manual (this document)
Product Overview




Setup
1. Battery Installation
The Beurer PS160 scale comes with a 3V CR2032 battery. If the battery is not pre-installed or needs replacement:
- Locate the battery compartment on the underside of the scale.
- Open the battery compartment cover.
- Insert the CR2032 battery with the positive (+) terminal facing upwards.
- Close the battery compartment cover securely.
2. Initial Placement
For accurate readings, place the scale on a hard, flat, and stable surface. Avoid placing it on carpets, rugs, or uneven flooring, as this can affect accuracy.
Operating Instructions
1. Switching On and Weighing
The Beurer PS160 features quick-start technology:
- Gently tap the center of the scale with your foot to activate it. The display will show "0.0" or "0.00".
- Once "0.0" or "0.00" is displayed, step onto the scale with bare feet, standing still and centered.
- Your weight will be displayed on the XXL LCD screen.
- The scale will automatically switch off after a few seconds of inactivity to conserve battery life.
2. Changing Weight Units
The scale can display weight in kilograms (kg), pounds (lb), or stones (st). To change the unit:
- Locate the unit switch button on the underside of the scale, usually near the battery compartment.
- Press the button to cycle through the available units (kg, lb, st).
- The selected unit will be indicated on the display.


Maintenance and Care
- Clean the scale surface with a damp cloth and a mild detergent if necessary. Do not use abrasive cleaning agents or immerse the scale in water.
- Do not attempt to disassemble or repair the scale yourself. Refer to qualified service personnel.
- Store the scale in a dry place, away from extreme temperatures and direct sunlight.
- If the scale will not be used for an extended period, remove the battery to prevent leakage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| "Lo" or no display | Low battery. | Replace the CR2032 battery. |
| "Err" or "O-Ld" on display | Overload. Weight exceeds maximum capacity (180 kg). | Reduce the weight on the scale. |
| Inaccurate readings | Scale not on a flat, hard surface; scale moved between readings; initial calibration needed. | Ensure scale is on a stable, flat surface. If moved, tap to activate and wait for "0.0" before weighing. Recalibrate by stepping on and off once. |
| Scale does not turn on | Battery issues; scale not activated correctly. | Check battery installation and charge. Tap the scale firmly to activate. |
Specifications
| Feature | Detail |
|---|---|
| Model | PS160 (Item model number: 725.30) |
| Brand | Beurer |
| Display Type | XXL LCD with 47mm digits |
| Weight Capacity | 180 kg (396 lb / 28 st) |
| Graduation | 100g |
| Units | kg / lb / st (selectable) |
| Standing Surface Area | 30.5 x 30.5 cm |
| Product Dimensions | 30.51 x 2.21 x 30.51 cm |
| Product Weight | Approximately 1.73 kg |
| Power Source | 1 x 3V CR2032 Lithium Metal Battery (included) |
| Special Features | Quick-start technology, Automatic switch-off, Overload indicator |
| Colour | Pure white |
| Country of Origin | China |
Warranty and Support
For warranty information and customer support, please refer to the official Beurer website or contact their customer service department. Keep your purchase receipt as proof of purchase.
For further assistance, you may visit the Beurer Store on Amazon.
Documents and downloads
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.