Accu-Chek Multiclix Lancets User Manual

1. Introduction

The Accu-Chek Multiclix Lancets are designed for use with the Accu-Chek Multiclix lancing device to obtain a blood sample for glucose testing. This system features a pre-loaded drum containing six lancets, eliminating the need to handle individual lancets. This manual provides essential instructions for the safe and effective use of these lancets.

Image 1: Accu-Chek Multiclix Lancets packaging.

2. Safety Information

• Always use a new lancet drum for each new testing session to ensure sterility and minimize pain.
• Do not share your lancing device or lancets with others. This is for single-person use only to prevent the transmission of infections.
• Keep lancets out of reach of children.
• Dispose of used lancet drums properly in a sharps container.
• Consult your healthcare professional for proper lancing technique and site selection.

3. Setup: Loading the Lancet Drum

The Accu-Chek Multiclix lancing device uses a drum containing six sterile lancets. Follow these steps to load a new drum:

1. Prepare the Lancing Device: Remove the cap from your Accu-Chek Multiclix lancing device.
2. Insert the Lancet Drum: Insert a new lancet drum, white end first, into the drum holder of the lancing device. Push it in firmly until it clicks into place.
3. Replace the Cap: Place the cap back onto the lancing device. Ensure it is securely fastened.
4. Set Puncture Depth: Rotate the dial on the cap to select your desired puncture depth. Start with a lower setting (e.g., 2) and adjust as needed to obtain a sufficient blood sample.

Note: The lancet drum is designed so that you do not see or touch the individual lancets, ensuring safety and hygiene.

4. Operating: Performing a Blood Sample Collection

Once the lancet drum is loaded and the depth is set, you are ready to collect a blood sample:

1. Prime the Device: Push the priming button on the end of the lancing device until it clicks. The release button will now be yellow, indicating it is ready to use.
2. Position the Device: Place the lancing device firmly against the side of your fingertip.
3. Activate the Lancet: Press the yellow release button to activate the lancet and prick your finger.
4. Obtain Blood Sample: Gently squeeze your finger to form a drop of blood. Apply the blood drop to your test strip as instructed by your blood glucose meter's manual.
5. Advance to Next Lancet: To use the next sterile lancet, rotate the priming button clockwise until it clicks, then rotate it back counter-clockwise until it clicks again. The number in the window will advance, indicating the next lancet is ready.

Important: Do not reuse a lancet. Always advance to a new lancet for each test.

5. Maintenance and Disposal

5.1. Cleaning the Lancing Device

Clean the exterior of your Accu-Chek Multiclix lancing device regularly with a damp cloth and mild detergent. Do not immerse the device in water. Ensure it is completely dry before storage or next use.

5.2. Disposing of Used Lancet Drums

After all six lancets in a drum have been used, the drum must be safely disposed of. The lancing device will indicate when the drum is empty (usually by showing a red line or a specific symbol in the window).

1. Remove the Cap: Take off the cap of the lancing device.
2. Eject the Drum: Push the drum ejector button (if available on your model) or simply pull the used drum out of the device.
3. Dispose Safely: Place the used lancet drum immediately into an approved sharps container. Do not dispose of used drums in household trash.

For more information on sharps disposal, contact your local waste management facility or healthcare provider.

6. Troubleshooting

• Difficulty Installing Drum: Ensure the drum is inserted white end first and pushed firmly until it clicks. Check for any obstructions.
• No Blood Sample / Insufficient Blood:
  • Increase the puncture depth setting on the lancing device.
  • Ensure the lancing device is held firmly against the skin.
  • Wash your hands with warm water and dry them thoroughly before testing to improve blood flow.
• Painful Puncture:
  • Ensure you are using a fresh lancet for each test.
  • Try a different puncture site on your fingertip.
  • Consider reducing the puncture depth if a sufficient sample is obtained at a lower setting.

7. Specifications

8. Warranty and Support

For specific warranty information regarding Accu-Chek Multiclix Lancets or the Accu-Chek Multiclix Lancing Device, please refer to the documentation included with your lancing device or visit the official Accu-Chek website. For customer support, contact Accu-Chek directly through their official channels.

Manufacturer: Accu-Chek

Website: www.accu-chek.com (Please note: This link is provided for informational purposes and may require navigation to the correct regional site.)