Introduction
This manual provides essential information for the safe and efficient use of your Respekta KM9120EN Domino Ceramic Hob. Please read these instructions carefully before installation, operation, or maintenance to ensure proper functioning and to prevent injury or damage. Keep this manual for future reference.
Safety Instructions
- Read all instructions thoroughly before using the appliance.
- This appliance is intended for domestic use only.
- Do not touch hot surfaces. Always use oven mitts or pot holders when handling hot items.
- Supervise children closely when the appliance is in use. Do not allow children to play with the hob.
- Ensure the appliance is properly installed and grounded by a qualified electrician.
- Disconnect the power supply before cleaning or performing any maintenance.
- Do not use abrasive cleaners or sharp objects on the ceramic surface.
- Never leave cooking unattended, especially when using high heat settings.
- Do not store flammable materials on or near the hob.
- If the ceramic surface is cracked, immediately switch off the appliance and disconnect it from the power supply to avoid electric shock.
Setup and Installation
The Respekta KM9120EN is a self-sufficient domino ceramic hob designed for integrated installation into a countertop. Ensure adequate ventilation around the appliance.
Installation Requirements:
- Power Supply: 230 Volts, 3000 Watts. A dedicated circuit may be required.
- Countertop Cutout: Refer to the installation diagram for precise dimensions.
- Clearance: Maintain a minimum clearance of 600mm above the hob for safety and proper ventilation.
- Ventilation: Ensure sufficient airflow beneath and around the appliance.
Installation diagram showing cutout dimensions for the Respekta KM9120EN Domino Ceramic Hob. The diagram indicates a minimum clearance of 600mm above the hob and specific cutout dimensions for integration into a countertop.
Installation should only be performed by a qualified technician in accordance with local electrical and building codes.
Operating Instructions
The Respekta KM9120EN features two ceramic cooking zones controlled by rotary knobs, offering 6 power levels for precise cooking.
Overview of the Respekta KM9120EN Domino Ceramic Hob, showing the two cooking zones and control knobs.
Controls:
- Each cooking zone has its own rotary knob.
- Turn the knob clockwise to increase the power level from 1 (low) to 6 (high).
- Turn the knob counter-clockwise to decrease the power level or to switch off the zone.
Close-up view of the control knobs for the Respekta KM9120EN hob, showing the power level markings and residual heat indicator light.
Residual Heat Indicator:
The hob is equipped with a residual heat indicator. After a cooking zone is switched off, a light will remain illuminated until the surface temperature has cooled down to a safe level. Do not touch the cooking zone while the indicator light is on.
The Respekta KM9120EN hob with one cooking zone activated and glowing red, indicating it is in use.
Top-down view of the Respekta KM9120EN hob with both cooking zones activated and glowing red.
Cleaning and Maintenance
Regular cleaning and maintenance will prolong the life of your hob and ensure optimal performance.
Cleaning the Ceramic Surface:
- Always ensure the hob is cool and disconnected from the power supply before cleaning.
- For light spills, wipe with a damp cloth and a small amount of mild dish soap.
- For stubborn stains or burnt-on food, use a specialized ceramic hob cleaner and a non-abrasive scraper. Follow the cleaner manufacturer's instructions.
- Rinse thoroughly with a clean, damp cloth and dry with a soft, clean towel to prevent water spots.
- Do not use abrasive sponges, scouring pads, or harsh chemical cleaners, as these can scratch or damage the ceramic surface.
Cleaning the Control Knobs:
- Wipe the control knobs with a damp cloth. Do not immerse them in water.
- Ensure they are completely dry before operating the hob again.
Troubleshooting
Before contacting customer service, please check the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Hob does not turn on. | No power supply. | Check the circuit breaker or fuse box. Ensure the appliance is properly plugged in. |
| Cooking zone not heating. | Control knob not set correctly. | Ensure the control knob for the desired zone is turned to a power level (1-6). |
| Residual heat indicator remains on. | Normal operation. | This indicates the cooking zone is still hot. Wait for the light to turn off before touching the surface. |
| Unusual odors during first use. | Protective coatings burning off. | This is normal for new appliances. Ensure good ventilation during initial use. The odor will dissipate. |
Technical Specifications
| Feature | Specification |
|---|---|
| Brand | Respekta |
| Model Number | KM9120EN |
| Product Dimensions (L x W x H) | 51 x 28.8 x 4.5 cm |
| Weight | 4.3 Kilograms |
| Number of Heating Elements | 2 |
| Color | Black (Ceramic), Stainless Steel (Frame) |
| Power Source | Electric Cable |
| Control Type | Knobs |
| Voltage | 230 Volts |
| Wattage | 3000 Watts |
| Surface Material | Vitroceramic |
| Special Features | 6 Power Levels per Hob, Residual Heat Indicator |
| Installation Type | Autonomous / Built-in |
Warranty Information
For detailed warranty terms and conditions, please refer to the warranty card included with your product or visit the official Respekta website. Keep your proof of purchase for any warranty claims.
Customer Support
If you require further assistance, have questions about your Respekta KM9120EN Domino Ceramic Hob, or need to report a fault, please contact Respekta customer service. Contact details can typically be found on the Respekta website or in the product packaging.