InSinkErator SS-200-27
InSinkErator SS-200-27 2 HP Commercial Garbage Disposer User Manual
Model: SS-200-27
Introduction
This manual provides essential instructions for the safe and efficient installation, operation, and maintenance of your InSinkErator SS-200-27 2 HP Commercial Garbage Disposer. Please read this manual thoroughly before installation or operation and retain it for future reference.
Important Safety Information
WARNING: Failure to follow these safety instructions could result in serious injury or property damage.
- Always disconnect power before servicing or installing the disposer.
- This appliance must be installed by a qualified professional in accordance with all local codes and ordinances.
- Do not put hands or utensils into the disposer while it is operating.
- Do not dispose of non-food items, glass, metal, plastic, or large bones.
- Ensure proper grounding to reduce the risk of electric shock.
Setup and Installation
Installation of the InSinkErator SS-200-27 commercial garbage disposer requires specialized knowledge and tools. It is strongly recommended that installation be performed by a licensed plumber or qualified service technician.
Pre-Installation Checklist:
- Verify that all components are present and undamaged.
- Ensure the installation location meets local plumbing and electrical codes.
- Confirm adequate space for the disposer and its connections.
- Have necessary tools and materials ready.
General Installation Steps (Professional Installation Recommended):
- Mounting: Securely attach the disposer to the sink opening using the provided mounting assembly. Ensure a watertight seal.
- Plumbing Connections: Connect the disposer to the drain line. Ensure proper trap and venting according to local codes.
- Electrical Wiring: Connect the disposer to a dedicated, properly grounded electrical circuit. This unit requires a 2 HP motor, so ensure the circuit can handle the load.
- Water Supply: Connect the cold water line to the disposer.
- Test: After installation, run cold water and test the disposer for leaks and proper operation.
Figure 1: InSinkErator SS-200-27 2 HP Commercial Garbage Disposer. This image shows the stainless steel body of the disposer with its top mounting flange and the red reset button on the side.
Operating Instructions
Follow these steps for safe and effective operation of your commercial garbage disposer:
- Turn on Cold Water: Before activating the disposer, turn on a strong stream of cold water. This helps flush food waste and keeps the grinding chamber cool.
- Activate Disposer: Turn on the disposer switch.
- Feed Food Waste: Gradually feed food waste into the disposer opening. Avoid overloading the unit.
- Continue Water Flow: Allow the cold water to run for at least 15-20 seconds after the grinding stops to ensure all waste is flushed through the drain.
- Turn Off Disposer: Turn off the disposer switch.
- Turn Off Water: Turn off the cold water.
Do Not Dispose Of:
- Grease, fats, or oils (pour into a separate container and dispose of in trash).
- Fibrous materials like corn husks, artichokes, or onion skins in large quantities.
- Large bones, fruit pits, or hard shells.
- Non-food items such as plastic, metal, glass, or cleaning rags.
Maintenance
Regular maintenance ensures optimal performance and extends the life of your disposer.
- Daily Cleaning: After each use, run cold water for 15-20 seconds to flush the grinding chamber.
- Deep Cleaning (Monthly): Grind a tray of ice cubes followed by citrus peels (lemon, orange) to clean the grinding elements and freshen the drain.
- Exterior Cleaning: Wipe the exterior with a damp cloth. Do not use abrasive cleaners.
- Professional Inspection: Schedule periodic professional inspections to ensure all components are functioning correctly and to address any potential issues.
Troubleshooting
Before attempting any repairs, always disconnect power to the disposer.
| Problem | Possible Cause | Solution |
|---|---|---|
| Disposer does not start. | No power; tripped circuit breaker; jammed motor. | Check power supply. Reset circuit breaker. Press the red reset button on the bottom/side of the disposer. If jammed, turn off power, use a disposer wrench to free the impellers. |
| Disposer hums but does not grind. | Jammed grinding plate. | Turn off power. Use a disposer wrench (or hex key) in the center hole on the bottom of the disposer and turn it back and forth to free the jam. Remove the object with tongs. |
| Leaks from disposer. | Loose connections; cracked housing. | Check and tighten all plumbing connections. If housing is cracked, professional repair or replacement is required. |
| Unpleasant odors. | Food particles accumulated in grinding chamber or drain. | Grind ice cubes and citrus peels. Clean the splash guard. |
If problems persist after attempting these solutions, contact a qualified service technician.
Specifications
| Feature | Detail |
|---|---|
| Brand | InSinkErator |
| Model Number | SS-200-27 |
| Horsepower | 2 HP |
| Installation Type | Freestanding |
| Application | Commercial |
| ASIN | B00BMV987C |
| Date First Available | February 28, 2013 |
Warranty and Support
InSinkErator products are manufactured to high-quality standards. For specific warranty details, please refer to the warranty card included with your product or visit the official InSinkErator website. Keep your proof of purchase for warranty claims.
For technical support, service, or to locate an authorized service center, please contact InSinkErator customer service or visit their official website. Contact information is typically provided in the product packaging or on the manufacturer's website.
Related documentsSS-200-27
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.