1. Introduction
This manual provides detailed instructions for the safe and effective use of your ElectraStim EM60 Flick Electro Stimulator. Please read this manual thoroughly before operating the device and retain it for future reference. The ElectraStim EM60 is designed for electro stimulation, featuring 7 stimulation settings with escalating patterns and pulsations, and 24 intensity levels. Its patented Flick feature offers rhythmic stimulation synchronized with hand movements.
2. Important Safety Information
Although ElectraStim products are not medical devices, they are designed in accordance with European General Requirements for Safety of Medical Electrical Equipment (EN60601-1 and section 2.10 for nerve and muscle stimulators). All stimulators and accessories carry the mandatory CE mark.
Before Use: Always read the stimulator and electrode instructions carefully. If any instructions are unclear, contact ElectraStim for further advice before use. Failure to follow instructions may result in injury or device malfunction.
Proposition 65 Warning: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
3. Package Contents
Verify that all items listed below are present in your package:
- ElectraStim EM60 Flick Stimulator Unit
- Electrode Pads (typically 4 pads)
- Lead Wires (for connecting electrodes)
- USB Charging Cable
- Microfibre Storage Bag
- User Manual (this document)

4. Product Overview
The ElectraStim EM60 Flick is a compact and rechargeable electro stimulator designed for ease of use and portability. It features a clear control panel with intuitive buttons for power, intensity adjustment, mode selection, and a unique Flick mode.

Controls and Indicators:
- Power Button (⏻): Turns the device on or off.
- Intensity Up Button (▲): Increases stimulation intensity.
- Intensity Down Button (▼): Decreases stimulation intensity.
- Mode Button (↻): Cycles through the 7 available stimulation patterns.
- Intensity Indicator LEDs: Displays the current stimulation level.
- Battery Indicator: Shows battery status (bottom left).
5. Setup
- Charge the Device: Before first use, fully charge the EM60 unit using the provided USB cable. Connect the small end of the USB cable to the charging port on the device and the larger end to a USB power source (e.g., computer, wall adapter). The battery indicator will show charging status.
- Connect Lead Wires: Insert the pin connectors of the lead wires into the output ports on the top of the EM60 unit.
- Attach Electrode Pads: Connect the other end of the lead wires to the electrode pads. Ensure a secure connection.
- Apply Electrode Pads: Carefully peel the electrode pads from their protective backing. Apply the pads to clean, dry skin in the desired area. Ensure good contact for effective stimulation.
6. Operating Instructions
6.1. Power On/Off
- To turn on: Press and hold the Power button (⏻) for approximately 2 seconds. The intensity indicator LEDs will light up.
- To turn off: Press and hold the Power button (⏻) for approximately 2 seconds. The LEDs will turn off.
6.2. Adjusting Intensity
The EM60 offers 24 intensity settings.
- To increase intensity: Press the Intensity Up button (▲). Each press increases the intensity by one level.
- To decrease intensity: Press the Intensity Down button (▼). Each press decreases the intensity by one level.
- The intensity indicator LEDs will visually represent the current level. Start at the lowest setting and gradually increase to a comfortable level.
6.3. Changing Stimulation Modes
The device features 7 distinct stimulation patterns.
- To change mode: Press the Mode button (↻). Each press will cycle to the next available pattern.
- Experiment with different modes to find the one that best suits your preference.
6.4. Flick Mode Operation
The patented Flick feature allows for motion-controlled stimulation, utilizing an internal accelerometer to synchronize stimulation with your hand movements.

- Once active, the device will respond to your hand movements, providing a dynamic and interactive stimulation experience.
7. Charging and Battery Life
The ElectraStim EM60 features a rechargeable battery for convenience.

- Charging Time: Approximately 3 hours for a full charge using the provided USB cable.
- Battery Life: The device will run for approximately 6 hours at 50% intensity. Actual battery life may vary depending on the selected intensity level and mode.
- Charging Indication: The battery indicator on the device will show the charging status.
8. Maintenance and Care
- Cleaning the Unit: Wipe the EM60 unit with a soft, damp cloth. Do not submerge the device in water or use abrasive cleaners.
- Electrode Pads: After each use, gently re-apply the electrode pads to their protective backing to maintain their adhesive quality. Replace pads when they lose their stickiness.
- Storage: Store the device and accessories in the provided microfibre bag in a cool, dry place, away from direct sunlight and extreme temperatures.

9. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not turn on. | Battery is depleted. | Charge the device using the USB cable. |
| No stimulation felt. |
|
|
| Stimulation feels weak or inconsistent. |
|
|
10. Specifications
| Model | EM60 Flick |
| Brand | ElectraStim |
| Stimulation Settings | 7 patterns |
| Intensity Levels | 24 levels |
| Channels | Single Channel (for up to 2 unipolar accessories) |
| Power Source | Rechargeable USB |
| Charge Time | Approx. 3 hours |
| Run Time | Approx. 6 hours (at 50% intensity) |
| ASIN | B00AJ0G7FS |
| Manufacturer | ElectraStim |
11. Warranty and Support
The ElectraStim EM60 Flick Stimulator comes with a standard warranty. An image in the product listing indicates a "Free 3 year warranty upgrade." Please refer to the product packaging or the official ElectraStim website for specific warranty terms and conditions.
For technical support, troubleshooting assistance, or warranty claims, please contact ElectraStim customer service through their official website or the retailer where the product was purchased.





