Rust-Oleum 269038

Rust-Oleum Specialty Camouflage Spray Paint Kit User Manual

Model: 269038

Product Overview

The Rust-Oleum Specialty Camouflage 6-Pack Spray Kit is designed for ultimate concealment on various surfaces. Its oil-based formula provides a non-reflective, ultra-flat finish, ideal for blending into natural environments.

This kit includes six 12-ounce cans, with specific colors: 2 Forest Green, 2 Earth Brown, 1 Army Green, and 1 Khaki. Each 12 oz. can covers approximately 12 square feet and dries to the touch in as little as 20 minutes.

Rust-Oleum Specialty Camouflage Spray Paint Kit box

Image: Rust-Oleum Specialty Camouflage Spray Paint Kit, showing the product packaging with color indicators.

Six Rust-Oleum Camouflage spray paint cans in various colors

Image: A set of six Rust-Oleum Camouflage spray paint cans, displaying the different shades included in the pack.

Safety Information

WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Always use in a well-ventilated area and wear appropriate personal protective equipment, including gloves and eye protection.

Setup and Preparation

  1. Surface Preparation: Ensure the surface is clean, dry, and free of loose paint, rust, wax, or grease. Lightly sand glossy surfaces for better adhesion. For bare wood, metal, or plastic, priming may be beneficial for optimal results and durability.
  2. Protection: Protect surrounding areas from overspray with drop cloths or newspaper.
  3. Ventilation: Use in a well-ventilated area, preferably outdoors.
  4. Shake Can: Shake the can vigorously for one minute after the mixing ball begins to rattle. Continue to shake occasionally during use.
  5. Test Spray: Test spray on an inconspicuous area or scrap material to check color and spray pattern.

Operating Instructions

  1. Application Temperature: Apply when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying.
  2. Holding Distance: Hold can upright 10-16 inches from the surface.
  3. Spray Technique: Spray with a steady, back-and-forth motion, slightly overlapping each stroke. Apply two or more light coats a few minutes apart rather than one heavy coat to avoid drips and ensure even coverage.
  4. Drying Time: Dries to the touch in 20 minutes. Can be handled in 1 hour. Allow 24 hours for full cure before heavy use.
  5. Pattern Application (Optional): For camouflage patterns, use natural materials like leaves, branches, or stencils. Apply different colors in layers, allowing each layer to dry to the touch before applying the next.
Color palette of Rust-Oleum camouflage paints

Image: A visual representation of the color palette for Rust-Oleum camouflage paints, showing shades of green, brown, and khaki.

Maintenance

Troubleshooting

ProblemPossible CauseSolution
Uneven Spray / DripsCan held too close; too much paint applied in one coat; inconsistent spray motion.Hold can 10-16 inches from surface. Apply multiple light coats instead of one heavy coat. Use a steady, even spray motion.
Clogged NozzlePaint dried in the nozzle.Invert can and spray for 5 seconds after each use. If clogged, remove tip and clean with mineral spirits.
Poor AdhesionSurface not properly cleaned or prepared; surface too smooth.Ensure surface is clean, dry, and free of contaminants. Lightly sand glossy surfaces. Consider using a primer for optimal adhesion.
Slow Drying TimeHigh humidity; low temperature; too heavy a coat.Apply in temperatures between 50-90°F (10-32°C) and humidity below 85%. Apply lighter coats. Ensure good ventilation.

Specifications

FeatureDetail
BrandRust-Oleum
Model Number269038
Paint TypeOil-based
Finish TypeUltra-flat, Non-reflective Matte
Kit Contents6 x 12 Fl Oz cans (2 Forest Green, 2 Earth Brown, 1 Army Green, 1 Khaki)
Item Volume (per can)12 Fluid Ounces
Coverage (per can)Approx. 12 sq. ft.
Dry to Touch Time20 minutes
Full Cure Time24 hours
Recommended SurfacesWood, Metal, Masonry, Plaster, Plastic
UsageInterior/Exterior
Item Weight (total)6 pounds
Product Dimensions8.38 x 5.63 x 8.25 inches

Warranty Information

Specific warranty details for the Rust-Oleum Specialty Camouflage Spray Paint Kit are typically provided with the product packaging or can be found on the official Rust-Oleum website. Please refer to these sources for the most accurate and up-to-date warranty information.

Support and Contact

For further assistance, product inquiries, or safety data sheets, please refer to the official Rust-Oleum resources:

Related Documents - 269038

Preview Rust-Oleum Stops Rust Turbo Spray System SRT-44 Technical Data Sheet
Technical data sheet for Rust-Oleum Stops Rust with Turbo Spray System (SRT-44), including product description, application instructions, and physical properties. Learn about coverage, dry times, and preparation.
Preview Rust-Oleum Stops Rust Textured Sprays: Technical Data and Application Guide
Technical data and application guide for Rust-Oleum Stops Rust Textured Sprays, detailing product uses, preparation, application instructions, dry times, cleanup, and physical properties for various textured spray paint finishes.
Preview Rust-Oleum Fillcoat Waterproofing Membrane: Technical Specifications
Detailed technical specifications for Rust-Oleum Fillcoat waterproofing membrane, including application, drying times, consumption, and safety data for roofs and terraces. Product code: Fillcoat.
Preview Rust-Oleum Pourable Concrete Patch: Technical Data & Application Guide
Comprehensive technical data and application guide for Rust-Oleum Pourable Concrete Patch, a fiber-reinforced material for fast and easy concrete repairs. Includes preparation, mixing, curing, and physical properties.
Preview Rust-Oleum LeakSeal Basement & Masonry Waterproofer: Application Guide & Instructions
Comprehensive guide to applying Rust-Oleum LeakSeal Basement & Masonry Waterproofer. Learn about surface preparation, application techniques, coverage, limitations, and safety warnings for effective waterproofing of basements, cellars, and masonry.
Preview Rust-Oleum Tub & Tile Refinishing Kit Technical Data and Application Guide
Comprehensive technical data, product details, application instructions, and safety information for the Rust-Oleum Tub & Tile Refinishing Kit, designed for renewing ceramic tile, porcelain, fiberglass, acrylic, cast iron, and steel tubs and sinks.