Tivoli Audio Model One Bluetooth AM/FM Radio Instruction Manual

Introduction

The Tivoli Audio Model One Bluetooth AM/FM Radio is designed to provide high-quality audio reception and reproduction. Featuring a classic design with a handmade wood cabinet, this radio integrates both traditional AM/FM tuning and modern Bluetooth connectivity. Its simple controls offer an intuitive user experience, delivering clear sound and reliable performance.

What's in the Box

• (1) Model One BT Radio
• (1) Owner's Manual
• (1) Power Supply
• (1) External FM Antenna

Setup

1. Unpacking: Carefully remove all components from the packaging.

   

2. Power Connection: Connect the power supply to the DC input on the rear of the radio and then plug it into a wall outlet.

   

3. Antenna Connection: For optimal FM reception, connect the included external FM antenna to the "FM-EXT" jack on the rear panel. For AM reception, the internal AM antenna is usually sufficient, but an external AM antenna can be connected if needed.
4. Placement: Position the radio on a stable, flat surface away from direct sunlight, heat sources, or excessive moisture. Experiment with different locations to find the best reception for both AM and FM bands.

Operating Instructions

1. Power On/Off and Source Selection

• Locate the three-position switch on the front panel.
• To turn the radio on, slide the switch from "OFF" to either "FM", "AM", "BT" (Bluetooth), or "AUX" (Auxiliary Input) depending on your desired source.
• To turn the radio off, slide the switch to "OFF".

2. AM/FM Radio Tuning

• Set the source switch to "FM" or "AM".
• Use the large tuning dial to scan for stations. The tuning indicator light will illuminate when a strong signal is received, indicating optimal tuning.
• Adjust the volume using the volume knob.

3. Bluetooth Connectivity

• Set the source switch to "BT". The Bluetooth indicator light will begin to flash, indicating it is in pairing mode.
• On your Bluetooth-enabled device (e.g., smartphone, tablet), navigate to the Bluetooth settings and select "Tivoli Audio Model One BT" from the list of available devices.
• Once paired, the Bluetooth indicator light on the radio will glow solid, and you can stream audio from your device.

4. Auxiliary Input

• Connect an external audio device (e.g., MP3 player, CD player) to the "AUX IN" port on the rear panel using a 3.5mm audio cable (not included).
• Set the source switch to "AUX".
• Control playback and volume from your connected device.

5. Official Product Video

Maintenance

• Cleaning: Use a soft, dry cloth to clean the radio's cabinet and controls. Avoid abrasive cleaners or solvents, which can damage the finish.
• Wood Care: The wood cabinet can be polished with a non-abrasive wood furniture polish as needed.
• Antenna Care: Ensure the external FM antenna is not bent or damaged.

Troubleshooting

• No Power: Ensure the power supply is securely connected to both the radio and a working electrical outlet.
• Poor Radio Reception:
  • Verify the external FM antenna is properly connected and fully extended.
  • Reposition the radio or antenna to improve signal strength.
  • Check for local interference from other electronic devices.
• Bluetooth Pairing Issues:
  • Ensure the radio is set to "BT" mode and the indicator light is flashing.
  • Make sure your device's Bluetooth is enabled and within range.
  • If previously paired, try "forgetting" the device on your phone and re-pairing.
• No Sound from Auxiliary Input:
  • Confirm the radio is set to "AUX" mode.
  • Check the audio cable connection at both the radio and the external device.
  • Ensure the volume on both the radio and the external device is turned up.

Specifications

Warranty and Support

For warranty information, product support, or service inquiries, please refer to the included Owner's Manual or visit the official Tivoli Audio website. Keep your proof of purchase for warranty claims.