Oster 000 Detachable Clipper Blade Instruction Manual

Introduction

This manual provides essential information for the proper use and maintenance of your Oster 000 Detachable Clipper Blade (Model 76918-626). This blade is designed for use with Oster Titan and Turbo77 clippers, as well as other clippers in the Oster 76 series. It is crafted from high-quality raw materials to ensure proven quality and professional results.

The Oster 000 blade is specifically engineered for very close fades and bald fading, leaving approximately 0.5mm (1/50") of hair length.

Product Overview

The front of the product packaging displays the Oster Professional logo and indicates that this is a Replacement Blade for TITAN® and TURBO 77™ clippers. It specifies '000 1/50" (0.5mm) DETACHABLE CLIPPER BLADE' and states it 'Fits Models: 76076, 76077. Very close fades, bald fading.'

The back of the packaging describes the Diamox Blade Collection, highlighting its high carbon steel construction for maximum blade performance and lasting sharpness. It includes detailed Blade Replacement Instructions for removal and installation, and provides contact information for Oster Direct® Services for sharpening.

This image shows the Oster 000 Detachable Clipper Blade held in a hand, with a ruler indicating its approximate length of 2.3 inches (5 cm).

Setup: Blade Installation and Removal

Proper installation and removal of the blade are crucial for safe and effective operation.

To Remove the Blade:

1. IMPORTANT: Ensure the clipper motor is stopped.
2. Lift the blade away from the clipper body.
3. Slide the blade off the tongue mechanism.

To Replace the Blade:

1. Turn the clipper motor on.
2. Insert the blade fully onto the tongue mechanism.
3. Snap the blade firmly into place.

Operating Instructions

The Oster 000 Detachable Clipper Blade is designed to provide a very close cut, ideal for fades and achieving a bald-like finish. The blade leaves approximately 0.5mm (1/50") of hair length.

Ensure the blade is securely attached to your compatible Oster clipper (e.g., Titan, Turbo77, or other 76 series models) before use. Always operate the clipper according to its own instruction manual.

Maintenance

Regular maintenance ensures optimal performance and extends the life of your blade.

Cleaning:

After each use, brush away any loose hair from the blade. For thorough cleaning, the blade can be disassembled by removing the two Phillips head screws. Clean both the top and bottom parts of the blade. Reassemble carefully, ensuring the screws are tightened securely.

Oiling:

Apply clipper oil to the blade teeth regularly, especially before and after each use, to reduce friction and heat buildup.

Sharpening:

For the best sharpening results, use Oster Direct® Services (1-800-830-3678, North America only) or an Authorized Oster® Service Center. Professional sharpening helps maintain the blade's precision and longevity.

Troubleshooting

If you experience issues with cutting performance, consider the following:

• Poor Cutting Performance: Ensure the blade is clean and properly oiled. Hair buildup or lack of lubrication can significantly reduce cutting efficiency.
• Blade Dullness: If the blade is no longer cutting effectively even after cleaning and oiling, it may need professional sharpening or replacement.
• Improper Installation: Verify that the blade is correctly inserted and snapped into place on the clipper's tongue mechanism. Refer to the 'Setup' section for detailed instructions.

Specifications

Support

For assistance with your Oster product, including sharpening services, please contact Oster Direct® Services at 1-800-830-3678 (North America only) or visit an Authorized Oster® Service Center.