Introduction
Thank you for choosing the GO HC379 Snap on Hard Shell Protective Hard Case. This manual provides essential information for the proper setup, operation, maintenance, and troubleshooting of your new protective case. This case is designed to provide durable protection for your HTC Wildfire S (Metro PCS) device, absorbing minor shocks and preventing scratches.
Product Overview
Figure 1: The GO HC379 Snap on Hard Shell Protective Hard Case. This image shows the black hard shell case from a slightly angled perspective, highlighting the cutouts for the camera, flash, and other ports on the HTC Wildfire S. The smooth, matte finish of the case is visible.
Setup
Follow these steps to properly install the protective case on your HTC Wildfire S:
- Prepare your device: Ensure your HTC Wildfire S is clean and free of dust or debris. Gently wipe the back and sides of the phone with a soft, dry cloth.
- Align the case: Hold the case with the cutouts aligning with your phone's camera, flash, and ports.
- Snap on the case: Starting from one end (either top or bottom), gently press your phone into the case until it snaps securely into place. Ensure all edges of the phone are fully enclosed by the case.
- Verify fit: Check that all buttons and ports are accessible and that the case fits snugly without any gaps.
Operating the Case
The GO HC379 case is designed for passive protection. Once installed, it requires no active operation. It provides continuous protection against minor impacts, scratches, and daily wear and tear. All phone functions, including camera, buttons, and charging ports, remain fully accessible through the case's precise cutouts.
Maintenance
To keep your GO HC379 case in optimal condition:
- Cleaning: Wipe the case regularly with a soft, damp cloth to remove dust and fingerprints. For stubborn dirt, a mild soap solution can be used, followed by wiping with a clean, damp cloth and then drying thoroughly.
- Avoid harsh chemicals: Do not use abrasive cleaners, solvents, or strong chemicals, as these may damage the case's finish.
- Storage: If removing the case for extended periods, store it in a clean, dry place away from direct sunlight and extreme temperatures.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Case does not fit properly. | Incorrect phone model or improper alignment during installation. | Ensure your phone is an HTC Wildfire S (Metro PCS). Remove the case and re-align carefully, ensuring all corners snap into place. |
| Case appears dirty or smudged. | Accumulation of dust, fingerprints, or grime. | Clean the case as described in the "Maintenance" section. |
| Buttons or ports are obstructed. | Case not fully seated or misaligned. | Gently press around the edges of the case to ensure it is fully snapped onto the phone. If issues persist, remove and re-install the case. |
Specifications
| Brand | GO |
| Model Number | HC379 |
| Compatible Device | HTC Wildfire S (Metro PCS) |
| Color | Black |
| Material | Hard Shell (Durable) |
| Product Dimensions (L x W x H) | 4.25 x 2.25 x 0.5 inches |
| Item Weight | 0.353 ounces |
Warranty Information
Specific warranty details for this product are not provided in the available information. Please refer to the product packaging or contact the manufacturer directly for warranty inquiries.
Support
For further assistance or technical support, please contact GO customer service. Contact information may be available on the product packaging or the manufacturer's official website.