Vivitar ViviCam X426 Waterproof Digital Camera User Manual

Introduction

This manual provides comprehensive instructions for the operation and maintenance of your Vivitar ViviCam X426 Waterproof Digital Camera. Please read this manual thoroughly before using the camera to ensure proper function and longevity.

The Vivitar ViviCam X426 is designed for ease of use, featuring a 10-megapixel sensor, a 2.4-inch LCD display, and waterproof capabilities up to 10 feet (3 meters), making it ideal for capturing photos and videos in various environments, including underwater.

Package Contents

Verify that all items are present in your camera package:

• Vivitar ViviCam X426 Digital Camera Body
• USB Cable
• User Manual (this document)
• Software CD (may be included for older models)

Note: Batteries (2x AAA) and an SD card are not included and must be purchased separately.

Camera Overview

Front View

Figure 1: Front view of the Vivitar ViviCam X426 camera. This image displays the camera's red and silver casing, the central lens, the flash unit above the lens, and the Vivitar ViviCam X426 branding along with "10 Mega Pixels" and "2.4" LCD Monitor" indicators.

• Lens: Captures images and video.
• Flash: Provides illumination in low-light conditions.
• Microphone: Records audio during video capture.

Rear View

Figure 2: Rear view of the Vivitar ViviCam X426 camera. This image shows the 2.4" TFT display, along with the control buttons on the right side, including T (Telephoto), W (Wide-angle), Flash, Playback, Menu, and Delete buttons.

• 2.4" LCD Display: For framing shots, reviewing images, and navigating menus.
• Control Buttons: (T/W Zoom, Flash, Playback, Menu, Delete) For camera operation and settings adjustment.

Setup

1. Installing Batteries

1. Locate the battery compartment door on the side or bottom of the camera.
2. To open the waterproof battery compartment, you must continually hold a very small lever while sliding the door sideways with your other hand. Due to the water seal, this door is very tight.
3. Insert two AAA batteries, ensuring correct polarity (+/-).
4. Securely close the battery compartment door until it clicks into place. Ensure it is fully sealed to maintain waterproof integrity.

2. Inserting an SD Card

1. Open the battery compartment door as described above. The SD card slot is typically located within this compartment.
2. Insert a compatible SD card (not included) into the slot with the metal contacts facing the correct direction, usually towards the front of the camera. Push until it clicks into place.
3. Close the battery compartment door securely.

3. Initial Power On

Press and hold the Power button (usually located on the top or rear of the camera) until the LCD screen illuminates. The camera may prompt you to set the date and time upon first use.

Operating the Camera

Taking Photos

1. Power On: Turn on the camera.
2. Framing: Use the 2.4" LCD display to frame your shot.
3. Zoom: Use the 'T' (Telephoto) and 'W' (Wide-angle) buttons to adjust the 4x optical zoom.
4. Flash: Press the Flash button to cycle through flash modes (Auto, Fill-in, Red-eye reduction, Off).
5. Capture: Press the Shutter button (usually on top) fully down to take a picture.

Recording Videos

1. Switch Mode: Navigate to video recording mode using the Mode button (if available) or menu options.
2. Start Recording: Press the Shutter button to begin recording.
3. Stop Recording: Press the Shutter button again to stop recording.

Playback Mode

Press the Playback button to review your captured photos and videos. Use the navigation buttons to scroll through your media. Press the Delete button to remove unwanted files.

Underwater Use

Important: Before submerging the camera, ensure the battery/SD card compartment door is completely and securely sealed. Failure to do so will result in water damage and void the warranty.

• The camera is waterproof up to 10 feet (3 meters).
• After each use in saltwater, rinse the camera with fresh water and dry thoroughly with a soft cloth.
• In bright sunlight underwater, the LCD screen may be difficult to see. Point and shoot, or practice to improve framing.

Maintenance

• Cleaning the Lens: Use a soft, lint-free cloth specifically designed for camera lenses. Do not use abrasive materials or harsh chemicals.
• Cleaning the Body: Wipe the camera body with a soft, damp cloth. For stubborn dirt, use a mild soap solution, then wipe with a clean, damp cloth and dry thoroughly.
• Battery Care: Remove batteries if the camera will not be used for an extended period. Use fresh, high-quality AAA batteries for optimal performance.
• Storage: Store the camera in a cool, dry place away from direct sunlight and extreme temperatures.
• Water Seal Inspection: Regularly inspect the rubber seal around the battery/SD card compartment for any signs of damage, dirt, or debris. A clean and intact seal is crucial for waterproof performance.

Troubleshooting

Specifications

Warranty and Support

For warranty information and technical support, please refer to the warranty card included with your product or visit the official Vivitar website. Keep your purchase receipt as proof of purchase.

Manufacturer: Sakar International, Inc.