Introduction
The Leviton SureSlide 6674 is a versatile dimmer designed for both single-pole and 3-way applications, compatible with dimmable CFL and incandescent light sources. This manual provides essential information for the safe and proper installation, operation, and maintenance of your dimmer.
Product Overview
This image displays a front view of the Leviton SureSlide 6674 dimmer. The device is white, featuring a prominent vertical slide control for adjusting light intensity and a separate rocker switch located at the bottom for simple on/off functionality. The dimmer is mounted on a metal bracket, revealing the screw terminals for wiring connections and a product information label indicating 'SURESLIDE™ Cat. NO. 6674'.
Setup and Installation
Safety Warnings
- WARNING: To avoid fire, shock, or death, turn off power at the circuit breaker or fuse box and test that power is off before wiring.
- Install in accordance with all national and local electrical codes.
- Use only with dimmable CFL, dimmable LED, or incandescent light sources as specified.
- Do not use with motor-operated appliances or non-dimmable fluorescent lighting.
- If you are unsure about any part of these instructions, consult a qualified electrician.
Wiring Instructions
Ensure power is OFF at the circuit breaker before beginning. This dimmer can be wired for single-pole (one location control) or 3-way (two location control) applications. Refer to the wiring diagram provided with your product for specific connections. Generally, connect the dimmer's wires to the corresponding house wires using wire connectors.
- Identify Wires: Identify the hot (line), load (to light fixture), and traveler wires (for 3-way applications).
- Single-Pole Wiring: Connect the dimmer's line wire to the hot house wire, and the dimmer's load wire to the load house wire. Cap off any unused traveler wires.
- 3-Way Wiring: Connect the dimmer's common wire to the hot house wire. Connect the two traveler wires from the dimmer to the two traveler wires from the other 3-way switch. Connect the load wire from the dimmer to the load house wire.
- Grounding: Connect the dimmer's green ground wire to the bare copper or green ground wire in the wall box.
- Mounting: Carefully fold wires into the wall box, mount the dimmer using the provided screws, and attach the wallplate (sold separately).
- Restore Power: Turn power back ON at the circuit breaker.
Operating Instructions
- On/Off Control: Use the rocker switch at the bottom of the dimmer to turn the lights ON or OFF.
- Dimming Control: Slide the vertical control lever up to increase light intensity and down to decrease light intensity.
- Preset Level: The dimmer will return to the last dimmed level when turned ON, if not at full brightness.
Maintenance
The Leviton SureSlide dimmer requires minimal maintenance. To clean the dimmer, wipe it with a soft, damp cloth. Do not use abrasive cleaners, solvents, or harsh chemicals, as these can damage the finish or internal components. Ensure power is off before cleaning.
Troubleshooting
| Problem | Solution |
|---|---|
| Lights do not turn ON. | Check that the circuit breaker is ON. Verify all wiring connections are secure. Ensure the light bulb is functional and properly screwed in. |
| Lights flicker or do not dim properly. | Ensure that the light bulbs are specifically rated as dimmable CFL or LED. Incandescent bulbs must be compatible with dimmers. Check for minimum load requirements for CFL/LED bulbs. |
| Dimmer feels warm to the touch. | It is normal for dimmers to feel warm during operation. If it is excessively hot, ensure the total wattage of connected lights does not exceed the dimmer's maximum rating (600W Incandescent, 150W CFL). |
| Dimmer does not respond to controls. | Turn off power at the circuit breaker, wait 30 seconds, then turn power back on. Recheck wiring connections if the issue persists. |
Specifications
| Feature | Value |
|---|---|
| Operation Mode | Slide Dimmer |
| Operating Voltage | 120 Volts |
| Wattage (Incandescent) | 600 watts |
| Wattage (Dimmable CFL) | 150 watts |
| Circuit Type | Single-Pole / 3-Way |
| Color | White |
| Connector Type | Screw Terminals |
| Actuator Type | Rocker (On/Off) |
| Control Method | Touch (Slide) |
| Item Dimensions (L x W x H) | 2.7 x 4 x 6.75 inches |
| Item Weight | 4 ounces |
| Manufacturer | Leviton Mfg Co Inc |
| Model Number | 078477561942 |
| UPC | 078477590249 |
| Certifications | UL Listed, CSA Listed |
Warranty Information
The Leviton SureSlide 6674 dimmer is backed by a 5-Year Limited Warranty. This warranty covers defects in materials and workmanship under normal use. For full warranty terms and conditions, please refer to the documentation included with your product or visit the official Leviton website.
Customer Support
For technical assistance, troubleshooting beyond this manual, or warranty claims, please contact Leviton customer support. You can typically find contact information on the Leviton website or on the product packaging. When contacting support, please have your product model number (6674 or 078477561942) and purchase details readily available.