Samsung Refrigerator Drain Evaporator Clip Installation Guide

Introduction

This manual provides detailed instructions for the installation of the Samsung Refrigerator Drain Evaporator Clip, part number DA61-06796A. This component is designed to address common issues such as water pooling under the refrigerator's pantry drawer or inside the fresh food compartment, which often results from frost buildup in the evaporator drain tube. Replacing the original, shorter drain clip with this longer, improved version helps ensure proper defrost water drainage, preventing ice blockages and subsequent water leaks.

Safety Information

Always prioritize safety when performing appliance maintenance. Before beginning any installation or repair, ensure the refrigerator is completely unplugged from the power outlet to prevent electrical shock. Wear appropriate personal protective equipment, such as gloves, to protect your hands. If you are unsure about any step, consult a qualified appliance technician.

Tools Required

• Phillips head screwdriver
• Flathead screwdriver or putty knife (for prying)
• Towel or absorbent cloth
• Hair dryer (optional, for defrosting ice)

Part Overview

Figure 1: The Samsung Refrigerator Drain Evaporator Clip (Part DA61-06796A). This metal clip is designed to be longer than the original part, extending into the drain tube to prevent frost from blocking the drainage path.

Installation Guide

Follow these steps carefully to replace the drain evaporator clip:

1. Disconnect Power: Unplug the refrigerator from the electrical outlet.
2. Empty Refrigerator: Remove all food items and shelves from the fresh food compartment to gain access to the rear panel.
3. Remove Rear Panel: Locate the screws holding the rear panel inside the refrigerator compartment. Use a Phillips head screwdriver to remove these screws. Carefully detach the panel, which may require gentle prying with a flathead screwdriver or putty knife. Be mindful of any wiring connected to the panel (e.g., fan wires) and disconnect them if necessary.
4. Locate Drain Tube: Once the rear panel is removed, you will see the evaporator coils. Below these coils, you will find the drain pan and the drain tube opening. This is where the original clip is located.
5. Remove Original Clip: The original drain clip is typically a shorter metal piece inserted into the drain tube. Carefully pull or pry out the old clip. If there is significant ice buildup, use a hair dryer on a low setting to gently melt the ice, being careful not to overheat any plastic components. Use a towel to absorb any melted water.
6. Install New Clip: Take the new DA61-06796A drain evaporator clip. Insert the longer end of the clip into the drain tube opening. Ensure it is securely seated and extends far enough into the tube to prevent future ice blockages. The design of this clip is specifically to conduct heat from the defrost heater down into the drain tube, preventing ice formation.
7. Reassemble Refrigerator: Reconnect any disconnected wiring, then carefully reattach the rear panel, securing it with the screws. Replace all shelves and food items.
8. Restore Power: Plug the refrigerator back into the electrical outlet.
9. Monitor: Observe the refrigerator over the next few days to ensure the water pooling issue has been resolved.

Troubleshooting

• Water still pooling:
  • Ensure the new clip is fully inserted and correctly positioned.
  • Check if the drain tube itself is clogged further down. You may need to flush it with warm water or use a thin wire to clear any obstructions.
  • Verify that the refrigerator is level, as an uneven appliance can sometimes affect drainage.
• Refrigerator not cooling properly after reassembly:
  • Check if all electrical connections, especially to the fan, were properly reconnected.
  • Ensure the rear panel is securely fastened and not obstructing any air vents.

Specifications

Warranty and Support

For warranty information regarding this replacement part, please refer to the documentation provided by the seller or contact the point of purchase directly. For further technical assistance or if the issue persists after following these instructions, it is recommended to contact Samsung customer support or a certified appliance repair professional.

• Samsung Support: Visit the official Samsung website for your region to find contact information and support resources.
• Seller Support: Contact "Part Supply House" for specific product support or warranty claims related to this purchase.