Introduction
This manual provides instructions for the safe and effective operation of your ATD Tools 70001 Laser Infrared Thermometer. This device is designed for non-contact temperature measurement, offering a wide measurement range and an automatic power-off feature for convenience.
Safety Information
Please read all safety warnings and instructions carefully before using this product. Failure to follow these instructions may result in injury or damage to the device.
Laser Safety Warning
CAUTION: LASER RADIATION. DO NOT STARE INTO BEAM.
- Do not point the laser directly at eyes or reflective surfaces.
- Avoid direct eye exposure to the laser beam.
- Use caution when operating the laser thermometer in areas where others may be present.
General Safety Precautions
- Do not immerse the device in water, despite its waterproof feature, to prevent damage to internal components.
- Keep the device away from strong electromagnetic fields.
- Do not attempt to disassemble or modify the thermometer.
- Store the device in a dry, cool place when not in use.
Product Components
The ATD Tools 70001 Laser Infrared Thermometer includes the following:
- ATD Tools 70001 Laser Infrared Thermometer unit
- One 9V battery
- Instruction Manual
Setup
Battery Installation
- Locate the battery compartment cover, typically on the handle.
- Open the cover.
- Insert the included 9V battery, ensuring correct polarity (+/-).
- Close the battery compartment cover securely.
Note: The device requires one 9V battery for operation. Ensure the battery is properly installed before use.
Operating Instructions
Taking a Measurement
- Point the thermometer at the target object.
- Press and hold the trigger to activate the laser and begin measurement. The laser dot indicates the center of the measurement area.
- The temperature reading will be displayed on the LCD screen.
- Release the trigger to hold the reading on the display.
Distance to Spot Ratio (D:S)
The ATD Tools 70001 has a Distance to Spot ratio of 12:1. This means that at a distance of 12 inches from the target, the measurement area (spot) will be 1 inch in diameter. To ensure accurate readings, position the thermometer at an appropriate distance from the target so that the measurement spot is entirely within the object being measured.
Automatic Power Off
The thermometer features an automatic power-off function to conserve battery life. The device will power off after a period of inactivity (approximately 10-15 seconds after releasing the trigger).
Maintenance
Cleaning
To clean the thermometer, wipe the exterior with a clean, damp cloth. Do not use abrasive cleaners or solvents. Ensure the lens and sensor are kept clean for accurate readings.
Battery Replacement
When the battery indicator appears on the display, replace the 9V battery following the installation steps outlined in the "Setup" section.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not power on | Dead or improperly installed battery | Replace the 9V battery or ensure it is installed with correct polarity. |
| Inaccurate readings |
|
|
| Laser not visible | Laser function disabled or malfunction | Ensure the laser is enabled (if applicable, check device specific controls). If problem persists, contact support. |
Specifications
- Model: ATD Tools 70001
- Measurement Range: -76°F to 1022°F (-60°C to 550°C)
- Display Resolution: LCD Digital
- Distance to Spot Ratio (D:S): 12:1
- Response Time: 1 second
- Power Source: 1 x 9V Battery (included)
- Automatic Power Off: Yes (approx. 10-15 seconds)
- Special Features: Waterproof
- Product Dimensions: 4.43 x 1.63 x 5.82 inches
- Item Weight: 8 ounces
- Country of Origin: China
- UPC: 663126700010
Warranty and Support
For warranty information or technical support, please refer to the documentation included with your purchase or contact ATD Tools customer service. Contact details are typically available on the manufacturer's official website.
ATD Tools Official Website: www.atdtools.com
