ICOM IC-F4001 03

Icom IC-F4001 Series Two-Way Radio User Manual

Model: IC-F4001 03 (UHF 400-470MHz)

1. Introduction

This manual provides essential information for the safe and efficient operation of your Icom IC-F4001 series two-way radio. Please read this manual thoroughly before using the radio to ensure proper functionality and to prevent damage.

The Icom IC-F4001 03 is a robust 4-watt, 16-channel UHF radio operating in the 400-470MHz frequency range, designed for reliable communication.

2. Package Contents

Verify that all items listed below are present in your package:

  • Icom IC-F4001 Two-Way Radio Unit
  • BP-265 Li-Ion Battery Pack (1900mAh)
  • BC-193 Desktop Rapid Charger
  • MB-124 Belt Clip
  • FA-SC57U Antenna
  • 120V AC Adapter for Charger
  • Owner's Manual (this document)
  • Warranty Card

3. Product Features

The Icom IC-F4001 radio offers a range of features for effective communication:

  • Transmit Power: 4 Watts for strong signal transmission.
  • Band: UHF (400-470MHz) for clear communication in various environments.
  • Battery: High-capacity 1900mAh Li-Ion Battery for extended operation.
  • Charger: 3-Hour Rapid Charger for quick battery replenishment.
  • Channels: 16 programmable channels for versatile communication groups.
  • Durability: Robust construction for reliable performance.

4. Setup

4.1. Battery Installation and Charging

  1. Install Battery: Align the BP-265 battery pack with the grooves on the back of the radio. Slide the battery pack firmly until it clicks into place.
  2. Charge Battery:
    • Connect the 120V AC adapter to the BC-193 Desktop Rapid Charger.
    • Plug the AC adapter into a standard wall outlet.
    • Place the radio with the installed battery into the charging slot of the BC-193 charger. Ensure the charging contacts align.
    • The charger's indicator light will typically show red during charging and green when fully charged. A full charge takes approximately 3 hours.

4.2. Antenna Attachment

Screw the FA-SC57U antenna clockwise onto the antenna connector on the top of the radio until it is finger-tight. Do not overtighten.

Icom IC-F4001 Two-Way Radio held in hand

Figure 1: The Icom IC-F4001 radio, shown held in a hand, illustrating its compact size and design. The antenna is visible at the top, and the channel/volume knobs are also present.

5. Operating Instructions

5.1. Power On/Off and Volume Adjustment

Rotate the top-most knob clockwise to turn the radio ON. Continue rotating clockwise to increase the volume. Rotate counter-clockwise to decrease volume and turn the radio OFF.

5.2. Channel Selection

Rotate the second knob from the top (channel selector knob) to select one of the 16 available channels. Each click corresponds to a different channel.

5.3. Transmitting and Receiving

  • Receiving: When the radio is on and tuned to an active channel, it will automatically receive incoming transmissions.
  • Transmitting:
    • Press and hold the Push-To-Talk (PTT) button located on the side of the radio.
    • Speak clearly into the microphone, holding the radio approximately 2-3 inches from your mouth.
    • Release the PTT button when you have finished speaking to return to receive mode.

6. Maintenance

6.1. Cleaning

Wipe the radio's exterior with a soft, damp cloth. Do not use harsh chemicals or abrasive cleaners. Ensure the radio is dry before use or charging.

6.2. Battery Care

  • Avoid fully discharging the battery frequently to prolong its lifespan.
  • Store the battery in a cool, dry place when not in use for extended periods.
  • Use only Icom approved battery packs and chargers.

7. Troubleshooting

ProblemPossible CauseSolution
Radio does not power on.Battery is not charged or not properly installed.Charge the battery fully. Ensure the battery is securely installed.
Cannot transmit or receive.Incorrect channel selected, antenna loose, or out of range.Verify channel selection. Check antenna connection. Move closer to other radios.
Poor audio quality.Low battery, antenna issue, or interference.Charge battery. Check antenna. Move away from sources of interference.

8. Specifications

FeatureDetail
Model NumberIC-F4001 03 (F4001 71 RC)
Frequency RangeUHF 400-470 MHz
Transmit Power4 Watts
Number of Channels16 Channels
Battery Type1900mAh Li-Ion (BP-265)
Dimensions (H x W x D)4.4 x 2.3 x 1.4 inches (approx.)
Weight (with battery)4.8 ounces (approx.)
Water Resistance LevelWaterproof

9. Warranty and Support

Your Icom IC-F4001 radio comes with a 2-Year Manufacturer Warranty. This warranty covers defects in materials and workmanship under normal use.

For warranty claims, technical support, or service inquiries, please contact Icom America customer service. Refer to the warranty card included in your package for specific contact details or visit the official Icom website.

Icom America Website: www.icomamerica.com

© 2024 Icom America Inc. All rights reserved. Specifications are subject to change without notice.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.