Introduction
This manual provides essential information for the proper use, installation, and maintenance of your Hurom HU-100 Slow Juicer Ultem Strainer. Please read this manual thoroughly before installation and operation to ensure optimal performance and longevity of the product.
Product Compatibility
Important: This Ultem Strainer is specifically designed for compatibility with certain Hurom HU-100 juicer models.
- ONLY FITS: Hurom HU-100 model juicers with serial numbers starting with 10041061 or higher.
- DOES NOT FIT: Premium models, Elite models, or Hurom HU-100 models with serial numbers lower than 10041061.
Verify your juicer's model and serial number before attempting installation to prevent damage or improper fit.
Product Overview
The Hurom HU-100 Slow Juicer Ultem Strainer is a key component of your Hurom slow juicer, responsible for separating pulp from juice. Constructed from durable Polyetherimide (Ultem), this fine mesh strainer is designed for efficient juice extraction.
Image: The Hurom HU-100 Slow Juicer Ultem Strainer, a black and silver cylindrical component with a fine mesh screen, designed for efficient juice extraction.
Setup and Installation
- Preparation: Ensure your Hurom HU-100 juicer is unplugged and all existing components are removed and cleaned.
- Placement: Carefully place the Ultem Strainer into the juicer's drum bowl, ensuring it sits securely and aligns with the base.
- Assembly: Install the auger (squeezing screw) into the center of the strainer, followed by the spinning brush and hopper, according to your juicer's main instruction manual.
- Verification: Confirm all parts are correctly assembled and locked into place before operating the juicer.
Refer to your main Hurom HU-100 juicer manual for detailed assembly instructions specific to your model.
Operating Considerations
The Ultem Strainer functions as the primary filtration component during the juicing process. To ensure its longevity and optimal performance:
- Feed Rate: Introduce ingredients at a steady, moderate pace. Overloading the juicer or forcing ingredients too quickly can stress the strainer and other components.
- Hard Ingredients: For very hard ingredients like carrots, cut them into smaller pieces to reduce strain on the auger and strainer.
- Citrus Fruits: While the strainer is durable, excessive pressure from juicing large quantities of citrus fruits with rind can potentially cause damage over time. It is recommended to peel citrus fruits before juicing.
Maintenance and Cleaning
Proper cleaning and maintenance are crucial for the performance and lifespan of your Ultem Strainer.
- Immediate Cleaning: Clean the strainer immediately after each use to prevent pulp from drying and hardening in the mesh.
- Hand Wash Only: The Ultem Strainer is not dishwasher safe. Wash it by hand using warm, soapy water and the cleaning brush provided with your juicer.
- Thorough Rinsing: Rinse thoroughly under running water to remove all soap residue.
- Drying: Allow the strainer to air dry completely before reassembling or storing.
- Stubborn Pulp: For stubborn pulp, soak the strainer in warm water for 10-15 minutes before scrubbing with the cleaning brush.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Strainer does not fit into the juicer. | Incompatible model or serial number. | Verify your juicer's model and serial number against the compatibility requirements in this manual. This strainer is only for Hurom HU-100 models with serial numbers 10041061 or higher. |
| Reduced juice yield or excessive pulp in juice. | Strainer mesh is clogged or damaged. | Thoroughly clean the strainer as per the "Maintenance and Cleaning" section. Inspect for any cracks or damage. If damaged, replacement may be necessary. |
| Strainer appears cracked or broken. | Excessive force during juicing, hard ingredients, or improper cleaning. | Avoid forcing ingredients. Cut hard produce into smaller pieces. Ensure only the provided tamper is used. Replace the strainer if damaged. |
Specifications
- Brand: Hurom
- Model Number: M9017
- Color: Black
- Material: Polyetherimide (Ultem)
- Product Dimensions: 6.42 x 4.69 x 4.69 inches
- Item Weight: 3.84 ounces
- Care Instructions: Hand Wash Only
- Dishwasher Safe: No
Warranty and Support
For information regarding warranty coverage or to obtain further assistance, please contact Hurom customer support directly. Keep your purchase receipt and juicer's serial number readily available when contacting support.
You can visit the official Hurom website or refer to the contact information provided with your original Hurom juicer purchase.
