Carrera Go!!! Red Bull Racing Set Instruction Manual

1. Introduction

This manual provides essential information for the assembly, operation, and maintenance of your Carrera Go!!! Red Bull Racing Set. This analog racetrack system features a 1:43 scale track and includes two 1:43 scale Red Bull RB7 2011 vehicles. Please read this manual thoroughly before use to ensure safe and optimal performance.

2. Safety Information

• Age Recommendation: This product is recommended for ages 6 years and up. Not suitable for children under 3 years due to small parts which may present a choking hazard.
• Electrical Safety: Use only the provided transformer. Do not attempt to modify the electrical components. Disconnect power before cleaning or performing maintenance.
• Track Assembly: Ensure all track pieces are securely connected to prevent disconnections during operation.
• Supervision: Adult supervision is recommended during assembly and operation, especially for younger users.
• Indoor Use Only: This product is designed for indoor use in dry conditions. Avoid exposure to moisture or extreme temperatures.

3. Package Contents

Carefully unpack all components and verify that all items are present. The Carrera Go!!! Red Bull Racing Set typically includes:

• 2 x Red Bull RB7 2011 Vehicles (Sebastian Vettel, Mark Webber)
• 1 x Transformer (Power Supply)
• 1 x Connecting Bar (Power Connection Track)
• 2 x Speed Controllers
• Straight Track Sections
• Curved Track Sections
• 1 x Lap Counter
• 1 x Looping Section
• 1 x Fly Over Section
• Track Supports and Barriers

Image 1: Overview of the Carrera Go!!! Red Bull Racing Set packaging and typical contents.

4. Setup

Follow these steps to assemble your racetrack:

1. Choose a Location: Select a flat, stable surface for assembly. The track requires a building dimension of approximately 192 cm x 60 cm (75.6 inches x 23.6 inches).
2. Assemble Track Sections: Connect the track pieces by aligning the connectors and pressing them firmly together until they click into place. Refer to the included layout diagram for the recommended track configuration, including straights, curves, looping, and fly over sections.
3. Install Track Supports: Attach the provided track supports to elevated sections like the looping and fly over to ensure stability.
4. Connect Power: Insert the connecting bar track section into the layout. Connect the transformer to the connecting bar and plug the transformer into a suitable electrical outlet.
5. Connect Speed Controllers: Plug the two speed controllers into the designated ports on the connecting bar.
6. Place Barriers: Attach track barriers to the outside of curves and other critical areas to help prevent cars from derailing.

5. Operating Instructions

Once the track is fully assembled and powered, you are ready to race:

1. Place Cars: Carefully place the Red Bull RB7 vehicles onto the track, ensuring the guide pin on the bottom of each car is correctly seated in the track slot.
2. Start Racing: Use the speed controllers to accelerate your car. Press the trigger to increase speed and release to slow down.
3. Control Speed: Learn to modulate your speed, especially around curves and through the looping section, to prevent cars from flying off the track. Too much speed on curves or too little speed in the loop can cause derailments.
4. Lap Counter: The integrated lap counter will automatically register each completed lap for both cars.

Image 2: A Carrera Go!!! Red Bull RB7 race car, showing the guide pin for track engagement.

6. Maintenance

Regular maintenance ensures the longevity and performance of your set:

• Track Cleaning: Periodically wipe down the track rails with a clean, dry, lint-free cloth to remove dust and debris, which can affect electrical conductivity.
• Car Maintenance: Check the car's guide pins and braids (electrical contacts) for wear. Replace worn braids as needed to maintain good electrical contact with the track. Ensure wheels are free of hair or lint.
• Storage: When not in use, store the track and cars in a clean, dry place, away from direct sunlight and extreme temperatures. Disassemble the track if long-term storage is required.

7. Troubleshooting

If you encounter issues, try these solutions:

8. Specifications

• Model Number: CA62278
• Scale: 1:43
• Track Length: 5.4 meters (17.71 feet)
• Building Dimensions: 192 cm x 60 cm (75.6 inches x 23.6 inches)
• Product Dimensions: 24 x 6 x 12 inches (Boxed)
• Weight: 7.94 Pounds (Boxed)
• Manufacturer Recommended Age: 6 years and up
• Date First Available: August 6, 2012

9. Warranty and Support

For warranty information, technical support, or replacement parts, please contact Carrera customer service directly. Refer to the contact details provided on the product packaging or visit the official Carrera website for the most up-to-date support information.

Carrera Official Website: www.carrera-toys.com