Larson Electronics HL-85

Larson Electronics HL-85 Handheld Spotlight User Manual

Model: HL-85-RED-12V-5

1. Introduction

This manual provides essential information for the safe and effective operation, maintenance, and troubleshooting of your Larson Electronics HL-85-RED-12V-5 Handheld Spotlight. This device is a 100-watt halogen spotlight designed for use with 12-volt or 24-volt DC power sources, featuring a red hunting lens and adjustable spot/flood beam capabilities. Please read this manual thoroughly before using the product.

2. Safety Information

Always observe the following safety precautions to prevent injury or damage to the product:

3. Package Contents

Verify that all items are present in the package:

Larson Electronics HL-85 Handheld Spotlight with red lens and coiled power cord

Image 3.1: Overview of the Larson Electronics HL-85 Handheld Spotlight with its coiled power cord and cigarette plug.

4. Product Features

The Larson Electronics HL-85 Handheld Spotlight offers the following features:

Side view of the HL-85 spotlight showing the handle and product label

Image 4.1: Side view of the spotlight, highlighting the ergonomic handle and product identification label.

Front view of the HL-85 spotlight with the red hunting lens

Image 4.2: Front view of the spotlight, showcasing the red hunting lens.

5. Setup

Follow these steps to set up your handheld spotlight:

  1. Unpack: Carefully remove all components from the packaging. Inspect for any signs of damage.
  2. Power Connection: Locate the 16-foot coil cord with the cigarette plug. Insert the cigarette plug firmly into a compatible 12-volt or 24-volt DC power outlet in your vehicle or power supply. Ensure the connection is secure.
  3. Lens Check: Confirm that the red hunting lens is securely in place. The spotlight is designed to operate with either a 5-inch or 7-inch lens, which can be interchanged if you have optional sizes.
Rear view of the HL-85 spotlight showing the power cable connection point

Image 5.1: Rear view of the spotlight, illustrating the power cable connection point at the base of the handle.

Close-up of the coiled power cord with cigarette lighter plug

Image 5.2: Detailed view of the 16-foot coiled power cord and its cigarette lighter plug for DC power connection.

6. Operating Instructions

To operate your Larson Electronics HL-85 Handheld Spotlight:

  1. Power On/Off: Once connected to a suitable DC power source, press the power switch located on the handle to turn the spotlight on or off.
  2. Adjusting Beam (Spot/Flood): The spotlight features an adjustable lens. To change the beam pattern, gently rotate the front housing or lens assembly. Rotate in one direction for a tighter spot beam and in the opposite direction for a wider flood beam.
  3. Using the Red Hunting Lens: The red lens is designed to minimize disturbance to wildlife and preserve human night vision. It is particularly useful in low-light conditions where maintaining natural night adaptation is crucial.

7. Maintenance

Regular maintenance ensures optimal performance and longevity of your spotlight:

8. Troubleshooting

If you encounter issues with your spotlight, refer to the following table:

ProblemPossible CauseSolution
Spotlight does not turn on.No power to the cigarette plug.
Loose connection.
Blown bulb.
Check vehicle's power outlet (e.g., fuse).
Ensure cigarette plug is fully inserted.
Replace the halogen bulb.
Light is dim or flickers.Insufficient power from source.
Aging or faulty bulb.
Poor connection.
Verify power source voltage and current capacity.
Replace the halogen bulb.
Check and secure all connections.
Cannot adjust beam from spot to flood.Mechanism obstruction.
Improper rotation.
Inspect for debris or damage around the lens assembly.
Ensure you are rotating the correct part of the housing.

9. Specifications

FeatureSpecification
Model NumberHL-85-RED-12V-5 (Part Number) / 1111OP86G3G (Item Model Number)
Light Source TypeHalogen
Wattage100 Watts
Brightness1800 Lumens
Beam DistanceUp to 900 feet (spot mode)
Power Source12V / 24V DC (Plug-in Electric)
MaterialNylon, Polycarbonate
Special FeatureDurable, Adjustable Spot/Flood Beam
Water Resistance LevelNot Water Resistant
Item Weight2 pounds
Product Dimensions9 x 9 x 9 inches

10. Warranty and Support

The Larson Electronics HL-85 Handheld Spotlight is backed by a 3-year warranty. This warranty covers defects in materials and workmanship under normal use.

For warranty claims, technical support, or inquiries regarding replacement parts, please contact Larson Electronics customer service. Refer to the product packaging or the official Larson Electronics website for current contact information.

Related Documents - HL-85

Preview GAU-12-IPS-LED-UVA LED Strip Light: Installation and Features
Detailed installation and maintenance guide for the Larson Electronics GAU-12-IPS-LED-UVA LED Strip Light, designed for industrial locations. Features 12-24V DC operation and high durability.
Preview Larson Electronics NGR-AC-34.5KV-1200A-AN-CU-M1 Air Core Neutral Grounding Reactor Specifications and Test Data
Detailed specifications, parameters, and test results for the Larson Electronics NGR-AC-34.5KV-1200A-AN-CU-M1 Air Core Neutral Grounding Reactor, including electrical ratings, physical dimensions, and performance curves.
Preview EXPCMR-ALG-OZ-IC-1080P-1227 HD-TVI Motorized Bullet Camera Quick Installation and User Guide
This document provides a quick installation and user guide for the Larson Electronics EXPCMR-ALG-OZ-IC-1080P-1227 HD-TVI Motorized Auto-focus Infrared Bullet Camera. It covers features, mounting, wiring instructions, camera adjustments using the OSD, cleaning, troubleshooting, and detailed specifications.
Preview Larson Electronics MT-DOE16-1P-208V-25KVA-480V-N3R Wiring Diagram
Detailed wiring diagram and connection guide for the Larson Electronics MT-DOE16-1P-208V-25KVA-480V-N3R transformer, including primary and secondary voltage connections.
Preview Larson Electronics PDU-MTS-3P-30A-480V Manual Transfer Switch - Product Overview
Detailed information on the Larson Electronics PDU-MTS-3P-30A-480V Manual Transfer Switch, a 30-amp, 3-pole, non-fusible disconnect switch designed for industrial applications with 600V AC/DC rating and NEMA 3R enclosure.
Preview Larson Electronics MPD-ATS Series Automatic Transfer Switch: Installation & Safety Manual
Comprehensive instruction manual for the Larson Electronics MPD-ATS Series Automatic Transfer Switch (NEMA 3R, Floor/Pad Mounted). Details installation, wiring, safety precautions, and operational guidance for industrial use.