Nexel 5 Tier Chrome Wire Shelving Starter Unit - Model B2333302 User Manual

Important Safety Information

• Read all instructions carefully before assembly. Failure to follow instructions may result in injury or damage to the unit.
• Do not exceed the maximum weight capacity per shelf. Overloading can cause the unit to collapse.
• Ensure the unit is assembled on a level, stable surface. Uneven surfaces can lead to instability.
• Keep small parts away from children. Choking hazard.
• Wear appropriate safety gear (e.g., gloves) during assembly to prevent cuts or pinches.
• Do not climb on or hang from the shelving unit. This can cause the unit to tip over.

Package Contents

Verify that all components are present before beginning assembly. If any parts are missing or damaged, contact customer support.

• Wire Shelves (5)
• Posts (4)
• Plastic Sleeves/Clips (quantity sufficient for 5 shelves)
• Leveling Feet (4)
• Assembly Guide (1)

Setup and Assembly

No tools are typically required for the assembly of this Nexel chrome wire shelving unit. Follow these steps carefully:

1. Identify Components: Lay out all parts and identify the shelves, posts, plastic sleeves, and leveling feet. The posts have grooves at regular intervals.
2. Attach Leveling Feet: Screw the four leveling feet into the bottom of each post. These can be adjusted later to ensure stability on uneven floors.
3. Install First Shelf:
   

   Image: Close-up of the small black plastic sleeves used to secure shelves to posts.

   Place two plastic sleeves around each of the four posts at the desired height for the bottom shelf. Ensure the sleeves are snapped together securely and are at the same height on all four posts. The tapered end of the sleeve should face upwards.
4. Position Bottom Shelf: Carefully slide the first wire shelf down over the four posts, ensuring that each corner of the shelf rests firmly on the installed plastic sleeves. Apply even pressure to seat the shelf properly.
5. Install Subsequent Shelves: Repeat step 3 and 4 for the remaining four shelves, positioning the plastic sleeves at your desired height for each shelf. Ensure all sleeves for a single shelf are at the same height to keep the shelf level.
6. Final Check: Once all shelves are in place, gently push down on each shelf to ensure it is securely seated on the plastic sleeves. Adjust the leveling feet as needed to eliminate any wobbling.

Image: A fully assembled Nexel 5 Tier Chrome Wire Shelving Starter Unit, showcasing its five shelves and chrome finish.

Operating Instructions

• Weight Distribution: Distribute weight evenly across each shelf. Avoid concentrating heavy items in one area.
• Shelf Adjustment: Shelves can be adjusted to different heights after initial assembly. To adjust, remove all items from the shelf, lift the shelf off the plastic sleeves, reposition the sleeves on the posts at the new desired height, and then re-seat the shelf.
• Stability: For maximum stability, place heavier items on lower shelves.

Maintenance and Care

• Cleaning: Wipe with a dry cloth to remove dust and debris. For more stubborn marks, a damp cloth with mild soap can be used, followed by immediate drying to prevent water spots or rust.
• Inspection: Periodically inspect the unit for any loose connections or signs of wear. Ensure all shelves are securely seated.
• Avoid Harsh Chemicals: Do not use abrasive cleaners or harsh chemicals, as these can damage the chrome finish.

Troubleshooting

• Unit is Wobbly:
  Solution: Ensure the unit is on a level surface. Adjust the leveling feet at the bottom of each post until the unit is stable. Check that all plastic sleeves are securely snapped and that shelves are fully seated.
• Difficulty Installing Shelves:
  Solution: Ensure the plastic sleeves are correctly oriented with the tapered end facing up and are fully snapped together around the posts. Apply even downward pressure on the shelf corners.
• Shelf Not Level:
  Solution: Remove items from the shelf. Check that the plastic sleeves for that shelf are all positioned at the exact same height on their respective posts. Adjust as necessary.

Specifications

Warranty Information

Specific warranty details for the Nexel 5 Tier Chrome Wire Shelving Starter Unit (Model B2333302) are typically provided with the product packaging or can be obtained directly from the manufacturer, Nexel, or the authorized seller at the time of purchase. Please retain your proof of purchase for any warranty claims.

Customer Support

For further assistance, missing parts, or technical support regarding your Nexel 5 Tier Chrome Wire Shelving Starter Unit, please contact the manufacturer or the seller from whom you purchased the product. Refer to your purchase documentation for contact information.