PARTS-QUICK 512MB Printer Memory Module User Manual

1. Introduction

This manual provides instructions for the installation and use of the PARTS-QUICK 512MB 200-pin SODIMM printer memory module. This module is designed as an equivalent to Xerox Part Number 097S03382 and is compatible with Xerox Phaser 4510B, 4510DT, 4510DX, and 4510N printer models.

2. Installation

Follow these steps to install the 512MB printer memory module into your compatible Xerox Phaser 4510 series printer. Ensure the printer is powered off and unplugged before beginning the installation process.

Image: The PARTS-QUICK 512MB Printer Memory Module, a 200-pin SODIMM with a label indicating 'parts-quick' and 'Warranty Void If Removed'.

1. Power Off and Unplug: Before starting, ensure your printer is completely powered off and disconnected from the electrical outlet.
2. Access the Memory Compartment: Locate the thumbscrew on the right rear of the printer. Remove this thumbscrew and carefully detach the right plastic panel.
3. Expose the Image Processing Board: Behind the plastic panel, you will see a metal panel. On the right side of this metal panel, near the top, there are two short thumbscrews. Remove these to partially detach the metal panel, revealing the image processing board.
4. Remove Existing Memory (if applicable): The existing RAM chip will be in a slot near the top of the image processing board. To remove it, gently push the plastic clasps on either side of the chip outwards. This action will release the tension, allowing the chip to pop forward. Carefully pull it out.
5. Install New Memory Module: Hold the new PARTS-QUICK 512MB memory module by its edges. Align the notch on the module with the key in the memory slot. Insert the bottom edge of the new chip into the slot at an angle, then gently push the top edge down until it clicks into place and the plastic clasps secure it.
6. Reassemble: Reattach the metal panel using its thumbscrews, then replace the right plastic panel and secure it with its thumbscrew.
7. Power On: Plug the printer back into the electrical outlet and power it on. The printer should recognize the new memory automatically.

3. Operation

Once the memory module is correctly installed, it operates automatically. The printer will utilize the additional 512MB of RAM to enhance its performance, particularly for processing complex print jobs or handling larger documents. No further user interaction is required for the memory module itself.

4. Maintenance

The PARTS-QUICK 512MB printer memory module is a sealed electronic component and requires no routine maintenance. Avoid exposing the module to extreme temperatures, humidity, or physical impact. Do not attempt to clean the gold contacts with abrasive materials or liquids.

5. Troubleshooting

• Printer Does Not Power On: Ensure all cables are securely connected and the printer is plugged into a working power outlet. Recheck the installation steps to confirm all panels are correctly reassembled.
• "RAM Error" or Similar Message: If your printer displays a memory-related error message after installation, power off and unplug the printer. Carefully open the memory compartment and re-seat the memory module, ensuring it is firmly and correctly inserted into the slot. Verify that the plastic clasps are fully engaged.
• Printer Not Recognizing New Memory: Confirm that the memory module is fully seated. If the issue persists, ensure the module is compatible with your specific Xerox Phaser 4510 model (B, DT, DX, N).
• Performance Issues: While rare, if you experience unexpected performance issues, ensure your printer's firmware is up to date.

6. Specifications

7. Warranty and Support

This PARTS-QUICK memory module comes with a Lifetime Warranty. For warranty claims or technical support, please contact PARTS-QUICK customer service directly. Refer to your product packaging or the official PARTS-QUICK website for current contact information.