Introduction
Thank you for choosing the Konstsmide Teramo 7510-750 Outdoor Wall Light. This manual provides essential information for the safe installation, proper operation, and maintenance of your new lighting fixture. Please read these instructions carefully before installation and retain them for future reference.
The Konstsmide Teramo 7510-750 is a modern outdoor wall light constructed from durable aluminum, designed for universal use. It features an E27 screw-type socket and is rated for a maximum of 40W AGL type bulbs. The fixture has an IP44 rating, indicating protection against solid objects larger than 1mm and splashes of water from any direction.
Safety Information
- Electrical Safety: Installation must be carried out by a qualified electrician in accordance with all local and national wiring regulations. Always switch off the main power supply at the fuse box or circuit breaker before commencing any installation, maintenance, or bulb replacement.
- Voltage: This fixture operates on 240 Volts. Ensure your power supply matches this requirement.
- Bulb Type: Use only E27 AGL type bulbs with a maximum wattage of 40W. Do not exceed the specified wattage to prevent overheating and damage.
- IP44 Rating: This product is designed for outdoor use and is protected against splashing water. However, it should not be submerged in water.
- Handling: Handle the product with care. Avoid dropping or subjecting it to strong impacts.
- Cleaning: Disconnect power before cleaning. Use a soft, damp cloth. Do not use abrasive cleaners or solvents.
Package Contents
Please check that all components are present and undamaged before installation.
- 1 x Konstsmide Teramo 7510-750 Outdoor Wall Light fixture (Black, Aluminum)
- Mounting hardware (screws, wall plugs) - (Typically included, verify upon opening)
- Instruction Manual
- Note: Bulb is not included and must be purchased separately.
Setup and Installation
Tools Required: Drill, screwdriver, wire strippers, voltage tester, pencil, measuring tape.
- Preparation:
- Ensure the main power supply to the installation area is switched off at the circuit breaker.
- Unpack the fixture and inspect for any damage.
- Identify the desired mounting location on the wall.
- Marking and Drilling:
- Hold the mounting bracket of the fixture against the wall at the desired height and mark the drilling points with a pencil.
- Drill holes at the marked points suitable for the provided wall plugs.
- Insert the wall plugs into the drilled holes.
- Wiring:
- Connect the household wiring to the fixture's terminals. Ensure correct polarity: Live (L) to Live, Neutral (N) to Neutral, and Earth (E) to Earth. If unsure, consult a qualified electrician.
- Secure all connections firmly.
- Mounting the Fixture:
- Attach the fixture's mounting bracket to the wall using the screws.
- Carefully secure the main body of the light fixture to the mounting bracket, ensuring all wires are safely tucked away and not pinched.
- Install Bulb:
- Screw an E27 AGL bulb (max 40W) into the lamp holder. Do not overtighten.
- Final Check:
- Ensure all connections are secure and the fixture is firmly mounted.
- Restore power at the circuit breaker and test the light.
Figure 1: Dimensions diagram of the Konstsmide Teramo 7510-750 wall light, showing measurements of 18.5 cm length, 17 cm width, and 7 cm height.
Figure 2: The Konstsmide Teramo 7510-750 wall light installed on an exterior wall, illuminating the area.
Operating Instructions
The Konstsmide Teramo 7510-750 wall light is designed for straightforward operation.
- Power On/Off: The light is typically controlled by an external wall switch connected to your household electrical system. Flip the switch to turn the light on or off.
- Automatic Operation (if applicable): If connected to a separate light sensor or timer (not included with this fixture), the light will operate according to the settings of that device.
Figure 3: Front view of the Konstsmide Teramo 7510-750 outdoor wall light, showcasing its black matte finish and illuminated diffuser.
Maintenance
- Cleaning: To maintain the appearance and performance of your light, clean it regularly.
- Always disconnect the power supply before cleaning.
- Use a soft, damp cloth to wipe the exterior surfaces.
- Do not use harsh chemicals, abrasive cleaners, or scouring pads, as these can damage the finish.
- Bulb Replacement:
- Ensure the power supply is switched off and the bulb has cooled down completely.
- Carefully remove the old E27 bulb by unscrewing it.
- Insert a new E27 AGL bulb (max 40W) into the socket and screw it in gently until secure.
- Restore power and test the new bulb.
- Inspection: Periodically inspect the fixture for any signs of wear, damage, or loose connections. If any issues are found, disconnect power and consult a qualified electrician.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Light does not turn on. |
|
|
| Light flickers. |
|
|
| Water inside the fixture. |
|
|
If you encounter problems not listed here or if the suggested solutions do not resolve the issue, please contact Konstsmide customer support or a qualified electrician.
Specifications
- Brand: Konstsmide
- Model Number: 7510-750
- Product Dimensions (L x W x H): 18.5 x 17 x 7 cm
- Weight: 0.95 kg
- Material: Aluminum (Metal)
- Color: Black
- Style: Modern
- Light Source Type: AGL (Allgebrauchsglühlampe)
- Bulb Socket: E27
- Number of Bulbs: 1 (Bulb not included)
- Maximum Wattage: 40 Watts
- Voltage: 240 Volts
- Ingress Protection (IP) Rating: IP44
- Power Source: Corded Electric
- Installation Type: Wall Mount
- Specific Uses: Universal Model, Outdoor Use
- Batteries Required: No
Warranty and Support
Konstsmide products are manufactured to high standards and are designed for durability. For specific warranty information, please refer to the documentation provided with your purchase or visit the official Konstsmide website.
If you require technical assistance, have questions about installation, or need to report a defect, please contact Konstsmide customer support. Contact details can typically be found on the product packaging or the official Konstsmide website.