Introduction
This manual provides comprehensive instructions for the Sangean SR-35 AM/FM Analog Pocket Radio. It covers essential information for setting up, operating, and maintaining your radio, ensuring optimal performance and longevity. The SR-35 features AM/FM reception, a built-in speaker, and a headphone output, designed for portable listening.
Product Overview
Figure 1: Front view of the Sangean SR-35 AM/FM Analog Pocket Radio.
Key Features:
- AM/FM Pocket Radio with DSP Tuner
- Rotary Tuning and Dial Scale Display
- Excellent Sound and Reception
- Built-in 2.5" Speaker
- Handheld Size for portability
- Headphone Output for private listening
Controls and Components:
- Volume/Power Dial: Located on the side, this dial turns the radio on/off and adjusts the listening volume.
- Tuning Dial: Located on the side, used to select desired radio frequencies.
- AM/FM Switch: Selects between AM and FM radio bands.
- Analog Dial Scale Display: Shows the current tuned frequency.
- Tuning Indicator: A light that illuminates when a station is properly tuned.
- Built-in Speaker: For audio output.
- Headphone Jack: 3.5mm stereo jack for connecting headphones.
- Telescopic Antenna: Extendable antenna for FM reception.
- Battery Compartment: Located on the back for two AA batteries.
Setup
1. Battery Installation
- Locate the battery compartment cover on the back of the radio.
- Slide or unclip the cover to open the compartment.
- Insert two (2) AA batteries, ensuring correct polarity (+ and -) as indicated inside the compartment.
- Replace the battery compartment cover securely.
Note: Use only fresh AA batteries. Do not mix old and new batteries, or different types of batteries.
2. Antenna Adjustment
- For optimal FM reception, fully extend the telescopic antenna.
- Adjust the angle and direction of the antenna to achieve the clearest signal.
- For AM reception, the radio uses a built-in ferrite bar antenna. Rotate the entire radio for best AM reception.
Operating Instructions
1. Power On/Off and Volume Control
- To turn the radio ON, rotate the Volume/Power dial clockwise until you hear a click and the radio powers on.
- Continue rotating the dial clockwise to increase the volume.
- Rotate the dial counter-clockwise to decrease the volume.
- To turn the radio OFF, rotate the Volume/Power dial counter-clockwise until it clicks off.
2. Selecting Radio Band (AM/FM)
- Locate the AM/FM switch on the side of the radio.
- Slide the switch to the desired band: AM for Amplitude Modulation or FM for Frequency Modulation.
3. Tuning to Stations
- Once the radio is on and the band is selected, slowly rotate the Tuning dial.
- Observe the Analog Dial Scale Display to find your desired frequency.
- The Tuning Indicator light will illuminate when a strong signal is received, indicating optimal tuning.
4. Using Headphones
- Insert a 3.5mm stereo headphone plug into the Headphone Jack located on the side of the radio.
- The built-in speaker will automatically mute when headphones are connected.
- Adjust the volume using the Volume/Power dial to a comfortable listening level.
Maintenance
Cleaning the Unit
- Wipe the radio's exterior with a soft, slightly damp cloth.
- Do not use abrasive cleaners, waxes, or solvents as they may damage the finish.
- Avoid getting moisture into any openings.
Battery Care
- If the radio will not be used for an extended period, remove the batteries to prevent leakage and potential damage.
- Dispose of used batteries responsibly according to local regulations.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| No power / Radio does not turn on. | Batteries are dead or incorrectly inserted. | Replace with fresh AA batteries, ensuring correct polarity. |
| Poor reception / Static. | Antenna not extended (FM) or radio position (AM). Weak signal. | Fully extend and adjust the FM antenna. For AM, rotate the radio. Try moving to a different location. |
| No sound from speaker. | Volume too low. Headphones connected. | Increase volume. Disconnect headphones if not desired. |
Specifications
Figure 2: Sangean SR-35 with approximate dimensions.
| Brand: | Sangean |
| Model Number: | SR-35 |
| Tuner Technology: | AM, FM |
| Power Source: | 2 x AA Batteries (3.0V) |
| Speaker Output Power: | 0.15 Watts (Maximum) |
| Product Dimensions (L x W x H): | 2.93" x 1.28" x 4.9" (7.44 cm x 3.25 cm x 12.45 cm) |
| Item Weight: | 0.03 Pounds (approximately 13.6 grams without batteries) |
| Included Components: | Carrying Strap, Owner's Manual |
| Hardware Interface: | Headphone Jack |
| Display Type: | Analog |
Warranty and Support
Warranty Information
The Sangean SR-35 AM/FM Analog Pocket Radio is covered by a 90-day warranty from the date of purchase. This warranty covers manufacturing defects under normal use. Please retain your proof of purchase for warranty claims.
Customer Support
For technical assistance, troubleshooting beyond this manual, or warranty service, please contact Sangean customer support. Refer to the official Sangean website or the packaging for the most current contact information.