Introduction
This user manual provides comprehensive instructions for the setup, operation, and maintenance of your Fanimation TR31 Traditional Hand Held DC Motor Remote and Transmitter. Please read this manual thoroughly before using the product to ensure safe and efficient operation.
Safety Information
- Keep the remote control away from water and excessive moisture.
- Do not expose the remote to extreme temperatures.
- Ensure batteries are inserted with correct polarity.
- Dispose of used batteries responsibly according to local regulations.
- Do not attempt to disassemble or repair the remote control yourself. Refer to qualified service personnel.
Setup
1. Battery Installation
The Fanimation TR31 remote requires batteries for operation. Locate the battery compartment on the back of the remote. Insert the required batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment. Close the battery cover securely.
2. Initial Pairing (If Applicable)
For most Fanimation TR31 units, no programming or pairing is needed. Simply insert the batteries, and the remote should be ready to operate your compatible Fanimation ceiling fan. If the remote does not respond, ensure the fan's receiver is powered and functioning correctly.
Operating Instructions
Image: Front view of the Fanimation TR31 remote control, showing the fan speed buttons (I-VI) arranged in a circle, and two light control buttons below them. The Fanimation logo is at the bottom.
The Fanimation TR31 remote control provides intuitive control over your ceiling fan's functions. Familiarize yourself with the button layout:
- Fan Speed Buttons (I, II, III, IV, V, VI): These buttons are arranged in a circular pattern. Press the corresponding Roman numeral button to select one of the six available fan speeds. 'I' typically represents the lowest speed, and 'VI' represents the highest speed. The center button within this circle is usually the fan off button.
- Light Control Buttons: Located below the fan speed buttons, there are two distinct light control buttons.
- One button controls the Up Light (if your fan model has this feature). Press to turn the up light on/off or to dim/brighten.
- The other button controls the Down Light. Press to turn the down light on/off or to dim/brighten.
- Power Indicator Light: A small LED light at the top of the remote illuminates when a button is pressed, indicating that a signal is being transmitted.
Maintenance
Battery Replacement
When the remote's range decreases or the indicator light dims, it's time to replace the batteries. Follow the battery installation steps outlined in the Setup section. Always use the recommended battery type.
Cleaning
Wipe the remote control with a soft, dry cloth. Do not use abrasive cleaners or solvents, as they may damage the surface or internal components.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote not responding. | Dead or incorrectly installed batteries. | Replace batteries, ensuring correct polarity. |
| Fan not responding to remote. | Fan receiver not powered or out of range. | Check power to the fan. Ensure you are within the remote's operating range. |
| Lights not responding. | Light bulbs faulty or light control not enabled on fan. | Check light bulbs. Refer to your fan's manual for light control settings. |
Specifications
- Model: TR31
- Brand: Fanimation
- Color: Gray
- Dimensions: 0.3 x 1.5 x 4.5 inches
- Item Weight: 2.88 ounces
- Voltage: 120 Volts
- Wattage: 60 watts (for compatible fan)
- Number of Power Levels: 6 (fan speeds)
- Control Method: Remote
Warranty
The Fanimation TR31 remote control comes with a Lifetime Warranty. For detailed warranty terms and conditions, please refer to the official Fanimation website or contact their customer support.
Support
For further assistance, technical support, or to inquire about replacement parts, please contact Fanimation customer service. Visit the official Fanimation website for contact information and additional resources.
You can find more information at the Fanimation Store on Amazon.
