Elkay 92715C

Elkay 92715C Bubbler Replacement Instruction Manual

Model: 92715C

1. Introduction

This manual provides instructions for the installation, operation, and maintenance of the Elkay 92715C Bubbler. This component is designed as a replacement part for standard Elkay Water Coolers and drinking fountains.

Elkay 92715C Bubbler replacement part

Image 1.1: The Elkay 92715C Bubbler replacement part.

Key Features:

  • Flexible mouth guard for user safety.
  • Compatible with Elkay water coolers, bottle filling stations, and drinking fountains.
  • Designed to be keyed into position to prevent rotation.
  • Complements the existing styling of the cooler or fountain.

2. Included Components

The Elkay 92715C Bubbler package typically includes the following:

  • One (1) Elkay 92715C Bubbler replacement part.
  • Necessary hardware for installation (e.g., locking nut), which may vary slightly.

3. Installation Instructions

This section outlines the general steps for installing the Elkay 92715C Bubbler. It is recommended to consult the specific manual for your Elkay Water Cooler or drinking fountain for detailed, model-specific instructions.

  1. Preparation: Ensure the water supply to the unit is turned off before beginning installation. Gather any necessary tools, such as wrenches or pliers.
  2. Remove Old Bubbler: Carefully remove the existing bubbler from the water cooler or drinking fountain. This may involve unscrewing a locking nut from underneath the basin.
  3. Position New Bubbler: Place the new Elkay 92715C Bubbler into the opening. The bubbler is designed to be keyed into position to prevent rotation. Align the keyway on the bubbler with the corresponding slot on the fountain's basin.
  4. Secure Bubbler: From underneath the basin, thread the locking nut onto the bubbler's stem and tighten it securely. Do not overtighten, as this may damage the bubbler or the fountain.
  5. Test for Leaks: Turn the water supply back on slowly and check for any leaks around the newly installed bubbler. If leaks are present, gently tighten the locking nut further until the leak stops.

For optimal performance, ensure all connections are tight and the bubbler is seated correctly.

4. Operation

The Elkay 92715C Bubbler functions as a standard drinking fountain bubbler. To operate:

  • Press the activation button or lever on your water cooler or drinking fountain.
  • Water will flow from the bubbler in an arc, allowing for direct drinking.
  • The flexible mouth guard is designed to provide protection during use.

5. Maintenance

Regular cleaning and maintenance are essential to ensure the longevity and hygienic operation of your Elkay 92715C Bubbler.

  • Cleaning: Clean the bubbler regularly with a mild soap and water solution. Use a soft cloth or sponge to wipe down all surfaces. Avoid abrasive cleaners or scouring pads, as these can damage the finish.
  • Disinfection: Periodically disinfect the bubbler using a food-safe disinfectant solution, following the manufacturer's instructions for the disinfectant. Rinse thoroughly with clean water after disinfection.
  • Inspection: Periodically inspect the bubbler for any signs of wear, damage, or mineral buildup. If the water flow becomes weak or erratic, check for blockages.
  • Longevity: Consistent cleaning and proper care will contribute to the bubbler's long-term performance.

6. Troubleshooting

This section addresses common issues you might encounter with the Elkay 92715C Bubbler. For more complex problems, refer to your water cooler or drinking fountain's main instruction manual or contact Elkay customer support.

ProblemPossible CauseSolution
No water flow or weak stream
  • Water supply turned off.
  • Bubbler clogged with debris or mineral buildup.
  • Low water pressure to the unit.
  • Ensure water supply valve is fully open.
  • Clean the bubbler thoroughly, removing any obstructions.
  • Check the water pressure to the main unit.
Water leaking from base of bubbler
  • Locking nut is loose.
  • Gasket or seal is damaged or improperly seated.
  • Gently tighten the locking nut.
  • Inspect the gasket/seal and replace if damaged. Ensure it is seated correctly during installation.

7. Specifications

FeatureDetail
ManufacturerElkay
Part Number92715C
Item Model Number92715C
Item Weight2.72 ounces
Product Dimensions (L x W x H)1 x 3 x 5 inches
MaterialCopper
Item Package Quantity1
Included ComponentsReplacement Part
ASINB004PUHTFU
Date First AvailableNovember 4, 2010

8. Warranty and Support

Specific warranty information for the Elkay 92715C Bubbler is typically provided with the original water cooler or drinking fountain unit, or can be obtained directly from Elkay. Please retain your purchase receipt for warranty claims.

For technical assistance, replacement parts, or detailed warranty inquiries, please contact Elkay customer support directly. You can usually find contact information on the official Elkay website or in the documentation provided with your Elkay product.

Elkay Official Website: www.elkay.com

© 2023 Elkay. All rights reserved. This manual is for informational purposes only.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.