MagLite XL50-S3096
MagLite XL50 LED Flashlight User Manual
Model: XL50-S3096
Introduction
The MagLite XL50 LED Flashlight is a compact, high-performance lighting tool designed for reliability and ease of use. Featuring advanced MAG-LED technology, it provides a powerful beam in a durable, pocket-sized design. This manual provides essential information for the proper setup, operation, and maintenance of your MagLite XL50 flashlight.
Important Safety Information
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Always handle batteries and electronic components with care. Do not attempt to disassemble the flashlight beyond routine maintenance. Keep out of reach of children. Do not look directly into the LED beam, as it can cause temporary vision impairment.
Setup
Battery Installation
Your MagLite XL50 LED Flashlight requires three (3) AAA alkaline batteries, which are included with the product. Follow these steps to install or replace the batteries:
- Unscrew the tail cap of the flashlight by turning it counter-clockwise.
- Insert three AAA batteries into the battery compartment, ensuring the positive (+) end of each battery faces towards the head of the flashlight. Follow the polarity indicators inside the battery tube.
- Carefully screw the tail cap back on by turning it clockwise until it is securely tightened. Do not overtighten.
Image: MagLite XL50 LED Flashlight. This image displays the full length of the gray MagLite XL50 flashlight, highlighting its compact and durable aluminum casing with textured grip sections.
Operating Instructions
The MagLite XL50 features a convenient pushbutton tail cap switch for easy operation and mode selection.
Power On/Off and Mode Selection
- To Turn On/Off: Press the tail cap switch once to turn the flashlight on. Press it again to turn it off.
- Mode 1: High Power (200 Lumens): From the OFF position, press the tail cap switch once and release quickly. This activates the flashlight at its maximum brightness.
- Mode 2: 25% Energy Save Power: From the OFF position, press the tail cap switch twice in quick succession. This mode provides reduced brightness for extended battery life.
- Mode 3: Emergency Strobe: From the OFF position, press the tail cap switch three times in quick succession. This mode activates a rapid flashing light, useful for signaling or emergencies.
The flashlight will remember the last used mode if turned off and on within a short period. For optimal performance, ensure batteries are fresh and properly installed.
Maintenance
Proper maintenance will ensure the longevity and optimal performance of your MagLite XL50 LED Flashlight.
Cleaning
- Wipe the exterior of the flashlight with a clean, damp cloth. Avoid using abrasive cleaners or solvents.
- Keep the lens clean for maximum light output. Use a soft, lint-free cloth to gently wipe the lens.
Battery Care
- Replace batteries when the light output becomes dim or inconsistent.
- If the flashlight will not be used for an extended period (e.g., several months), remove the batteries to prevent potential leakage and damage to the flashlight.
- Dispose of used batteries according to local regulations.
General Care
The MagLite XL50 features a weather-resistant seal and anodized aluminum casing for improved corrosion resistance. While durable, avoid prolonged submersion in water. Store the flashlight in a cool, dry place.
Troubleshooting
If your MagLite XL50 LED Flashlight is not functioning as expected, refer to the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Flashlight does not turn on. | Dead or improperly installed batteries. | Check battery polarity and replace with fresh AAA alkaline batteries. |
| Light is dim or flickers. | Low battery power; loose tail cap. | Replace batteries. Ensure tail cap is securely tightened. |
| Tail cap switch is unresponsive. | Debris in switch mechanism; damaged switch. | Ensure tail cap is clean and free of debris. If issue persists, contact customer support. |
If these solutions do not resolve the issue, please refer to the Warranty and Support section for further assistance.
Specifications
| Model | XL50-S3096 |
| Light Source | LED |
| Brightness | 200 Lumens (High Power) |
| Beam Distance | 224 Meters |
| Run Time (High) | 6 hours 45 minutes |
| Run Time (Low) | 25 hours |
| Batteries | 3 x AAA Alkaline (included) |
| Length | 4.8 inches (12.2 cm) |
| Barrel Diameter | 1 inch (2.54 cm) |
| Head Diameter | 1 inch (2.54 cm) |
| Weight (with batteries) | 3.68 ounces (104.3 grams) |
| Drop Resistance | 1 meter |
| Water Resistance Level | Not Water Resistant |
| Material | Anodized Aircraft Aluminum |
Warranty and Support
Manufacturer's Warranty
The MagLite XL50 LED Flashlight is covered by a manufacturer's warranty. For specific details regarding warranty coverage, terms, and conditions, please refer to the documentation included with your purchase or visit the official MagLite website.
Customer Support
For further assistance, technical support, or to inquire about replacement parts, please visit the official MagLite Store or contact their customer service department:
Related documentsXL50-S3096
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.