1. Introduction
The Lutron Diva LED+ Dimmer Light Switch (Model DVWCL-153PH-WH) is designed to provide optimal dimming performance for a wide range of dimmable LED, CFL, halogen, and incandescent bulbs. This dimmer features a large paddle switch for on/off control and a discreet slider for precise light level adjustment. It supports both single-pole and 3-way wiring configurations.
This manual provides essential information for the safe installation, operation, and maintenance of your Lutron Diva LED+ Dimmer.
Image 1.1: Lutron Diva LED+ Dimmer Light Switch with included wallplate.
2. Important Safety Information
WARNING: RISK OF ELECTRIC SHOCK. Improper installation can result in serious injury or death.
- Always turn OFF power at the circuit breaker or fuse box before installing or servicing the dimmer.
- Consult a qualified electrician if you are unsure about any part of the installation process.
- Install in accordance with all national and local electrical codes.
- Do not use with non-dimmable bulbs.
- For indoor use only.
3. What's in the Box
Your Lutron Diva LED+ Dimmer package includes:
- One (1) Lutron Diva LED+ Dimmer Switch (Model DVWCL-153PH-WH)
- One (1) Coordinating Wallplate
- Installation Instructions (this document)
4. Setup and Installation
Installation typically takes about 15 minutes. The Diva LED+ dimmer does not require a neutral wire, making it suitable for homes of all ages.
4.1 Pre-Installation Steps
- Turn Off Power: Locate your circuit breaker or fuse box and turn off the power to the light switch you are replacing. Verify power is off by attempting to turn the light on.
- Remove Existing Switch: Carefully remove the wallplate and unscrew the existing switch from the wall box. Disconnect the wires from the old switch.
4.2 Wiring Instructions
The Diva LED+ dimmer can be installed in single-pole or 3-way applications.
Image 4.1: Side view of the dimmer showing wiring connections.
Image 4.2: Single-pole wiring diagram. For lights controlled from one location.
Image 4.3: 3-way wiring diagram. For lights controlled from two locations, using the Diva Dimmer and a standard 3-way mechanical switch.
For detailed, step-by-step wiring instructions, including 4-way applications, please refer to the Lutron Wiring Wizard online or the full installation guide provided with your product.
4.3 Mounting and Finishing
- Mount Dimmer: Carefully push the wired dimmer into the wall box, ensuring wires are not pinched. Screw the dimmer into the wall box.
- Attach Wallplate: Secure the included screwless wallplate over the dimmer.
- Restore Power: Turn the power back ON at the circuit breaker.
5. Operating Instructions
The Lutron Diva LED+ Dimmer provides intuitive control over your lighting.
Image 5.1: Key components of the Diva LED+ Dimmer.
5.1 Turning Lights On/Off
Use the large paddle switch to turn your lights on or off. When turned on, the lights will return to your last preferred dimming level.
5.2 Adjusting Light Level
Use the discreet slider located next to the paddle switch to adjust the brightness of your lights. Move the slider up to brighten and down to dim.
5.3 Setting Optimal Dimming Range (Trim Wheel)
For optimal performance with specific bulb types, especially LEDs, you may need to adjust the dimmer's low-end trim. This helps prevent flickering or lights turning off at low levels.
Image 5.2: The trim wheel, located behind the wallplate, allows manual adjustment of the dimmer's low-end output.
- Remove the wallplate.
- Locate the small adjustment lever (trim wheel) on the side of the dimmer, usually at the bottom.
- With the lights on and dimmed to their lowest desired level using the main slider, slowly adjust the trim wheel until the lights are stable and dim to your preferred minimum brightness without flickering or turning off.
- Replace the wallplate.
6. Bulb Compatibility
The Lutron Diva LED+ Dimmer is designed for broad compatibility with various bulb types:
- Dimmable LED/CFL Bulbs: Up to 150 Watts.
- Incandescent/Halogen Bulbs: Up to 600 Watts.
Lutron's HED technology enhances performance with dimmable CFLs and LEDs by minimizing flicker and ensuring stable operation across the dimming range. For specific bulb recommendations and to check compatibility, visit the official Lutron LED Compatibility Tool online.
Image 6.1: Advanced technology for superior dimming of multiple bulb types.
7. Maintenance
The Lutron Diva LED+ Dimmer requires minimal maintenance.
- Cleaning: To clean the dimmer and wallplate, wipe with a soft, damp cloth. Do not use abrasive cleaners, solvents, or chemical sprays.
- Inspection: Periodically inspect the dimmer and wallplate for any signs of damage or wear. If damage is observed, turn off power at the circuit breaker and replace the unit.
8. Troubleshooting
If you experience issues with your Lutron Diva LED+ Dimmer, refer to the following common solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Lights do not turn ON. | Power is off at the circuit breaker; bulb is burned out; incorrect wiring. | Check circuit breaker; replace bulb; verify wiring connections. |
| Lights flicker or turn off at low dimming levels. | Bulb incompatibility; low-end trim not set correctly. | Ensure bulbs are dimmable and compatible. Adjust the low-end trim using the trim wheel (see Section 5.3). |
| Lights do not dim or dim poorly. | Non-dimmable bulbs; dimmer capacity exceeded; incorrect wiring. | Use only dimmable bulbs. Ensure total wattage does not exceed 150W for LED/CFL or 600W for incandescent/halogen. Verify wiring. |
| Dimmer is warm to the touch. | Normal operation. | It is normal for dimmers to feel warm during operation. If it becomes excessively hot or emits smoke/odor, turn off power immediately and contact support. |
9. Specifications
- Model: DVWCL-153PH-WH
- Wattage: 150W (Dimmable LED/CFL), 600W (Incandescent/Halogen)
- Voltage: 120 Volts
- Circuit Type: Single-Pole or 3-Way
- Operation Mode: ON-OFF, Dimming
- Color: White
- Material: Plastic
- Item Dimensions (L x W x H): 11 x 6 x 7 inches (Product dimensions as packaged)
- Item Weight: 5.6 ounces
- Manufacturer: Lutron
- UL Listed: Yes
Image 9.1: Physical dimensions of the Diva LED+ Dimmer.
10. Warranty Information
The Lutron Diva LED+ Dimmer (Model DVWCL-153PH-WH) is backed by a One-Year Limited Warranty. For full warranty details and terms, please refer to the documentation included with your product or visit the official Lutron website.
11. Customer Support
Lutron offers 24/7, U.S.-based lifetime technical support for any troubleshooting issues or questions you may have.
- Phone Support: Refer to the contact information provided in your product packaging or on the official Lutron website.
- Online Resources: Visit the Lutron website for FAQs, wiring diagrams, and compatibility tools.
Image 11.1: Lutron provides 24/7 customer support.