Introduction
This manual provides essential instructions for the safe operation, setup, maintenance, and troubleshooting of your Amewi 22125 HBX Thunderburst 2007G Brushed 1:10 4WD RTR Buggy. Please read this manual thoroughly before operating the vehicle to ensure proper function and longevity.
Safety Warning: This product is recommended for users aged 14 years and older.
Package Contents
Ensure all items listed below are present in your package:
- Amewi 22125 HBX Thunderburst 2007G RC Buggy Model
- 2.4 GHz Professional Proportional Remote Control
- Battery (Ni-MH 7.2V 1800mAh)
- Battery Charger
- Illustrated Instructions (may not be in English)
Figure 1: Top-down view of the Amewi HBX Thunderburst 2007G RC Buggy with the body shell removed, revealing the chassis, motor, receiver, and battery compartment. This view helps identify the main components.
Setup
- Charge the Battery:
Connect the included Ni-MH 7.2V 1800mAh battery to the charger. Plug the charger into a suitable power outlet. The charging process typically takes approximately 5 hours. Do not overcharge the battery. Always supervise charging.
- Install Vehicle Battery:
Once fully charged, disconnect the battery from the charger. Open the battery compartment on the RC buggy (refer to Figure 1 for location). Insert the charged battery and securely close the compartment. Ensure the battery is properly connected to the vehicle's power connector.
- Install Remote Control Batteries:
The remote control requires batteries (not included). Open the battery compartment on the remote control. Insert the required batteries, observing correct polarity. Close the compartment securely.
Figure 2: The 2.4 GHz professional proportional remote control unit for the Amewi HBX Thunderburst 2007G RC Buggy, showing the steering wheel, trigger, and various control knobs and buttons. This is used to operate the buggy.
- Pairing the Remote Control:
Turn on the RC buggy first, then turn on the remote control. The remote control and buggy should automatically pair. If pairing fails, refer to the troubleshooting section or the illustrated instructions for specific pairing procedures. The 2.4 GHz system allows multiple vehicles to operate simultaneously without interference.
Operating Instructions
The Amewi HBX Thunderburst 2007G is designed for outdoor use and offers a dynamic driving experience with its 4WD system and powerful brushed motor.
- Starting the Vehicle:
Place the buggy on a flat, open surface. Ensure the area is clear of obstacles and people. Turn on the buggy's power switch, then the remote control's power switch.
- Steering:
Use the steering wheel on the remote control (Figure 2) to control the direction of the buggy. Turn the wheel left to steer left, and right to steer right.
- Acceleration and Braking:
Use the trigger on the remote control (Figure 2). Pull the trigger towards you to accelerate forward. Push the trigger away from you to brake or reverse.
- Speed Control:
The electronic speed controller provides precise control over the buggy's speed. The powerful air-cooled finned electric motor allows for extreme acceleration, reaching speeds of approximately 35 km/h.
- Driving Environment:
This buggy is recommended for outdoor use. Avoid operating in wet conditions, deep sand, or extremely dusty environments to prevent damage to electronic components and moving parts.
- Ending Operation:
When finished, turn off the remote control first, then turn off the buggy's power switch. Disconnect and remove the battery from the buggy for safety and to prevent discharge.
Figure 3: Front-side view of the Amewi HBX Thunderburst 2007G RC Buggy, showcasing its vibrant yellow, orange, and black body with flame decals, large off-road tires, and rear spoiler. This image displays the overall design of the vehicle.
Maintenance
Regular maintenance ensures optimal performance and extends the lifespan of your RC buggy.
- Cleaning:
After each use, especially in dusty or dirty conditions, clean the buggy. Use a soft brush or compressed air to remove dirt and debris from the chassis, suspension, and motor area. Avoid using water directly on electronic components.
- Inspecting Moving Parts:
Regularly check all moving parts, including wheels, suspension components, and steering linkages, for wear or damage. Ensure all screws are tight. The sealed gearbox is designed to be robust.
Figure 4: Close-up view of the front suspension system of the Amewi HBX Thunderburst 2007G RC Buggy, showing the oil pressure shock absorbers, independent suspension arms, and knobby tire. This highlights the robust suspension design.
- Motor Care:
The powerful air-cooled finned electric motor requires occasional inspection. Ensure no debris is obstructing the cooling fins. If the motor shows signs of reduced performance, it may require servicing.
Figure 5: Close-up view of the brushed electric motor with blue cooling fins and the receiver unit inside the Amewi HBX Thunderburst 2007G RC Buggy chassis. This shows the core power and control components.
- Battery Storage:
Store the Ni-MH battery in a cool, dry place, partially charged (around 50%). Do not store fully charged or fully discharged for extended periods.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Buggy does not respond to remote control. |
|
|
| Reduced speed or power. |
|
|
| Steering issues (e.g., not straight, unresponsive). |
|
|
Specifications
- Model: Amewi 22125 HBX Thunderburst 2007G
- Scale: 1:10
- Drive System: 4WD (Four-Wheel Drive)
- Motor Type: Brushed Electric Motor (Air-cooled, finned)
- Speed: Approximately 35 km/h
- Battery: Ni-MH 7.2V 1800mAh (Included)
- Charger: Included (Charging time approx. 5 hours)
- Remote Control: 2.4 GHz Professional Proportional Radio Remote Control (Batteries not included)
- Dimensions (L x W x H): 50 x 30 x 20 cm
- Weight: 1.38 kg (3.04 lbs)
- Main Material: Plastic
- Suspension: Independent suspension with oil pressure shock absorbers
- Gearbox: Sealed, unbreakable gearbox
- Electronic Speed Controller: Yes
- Steering: Power steering
- Recommended Age: 14 years and older
- Recommended Use: Outdoor
Warranty and Support
Information regarding spare parts availability is not provided. For warranty claims or technical support, please contact your retailer or the manufacturer directly. Keep your purchase receipt as proof of purchase.
Manufacturer: Amewi
Languages for instructions: German, English, Spanish, French, Italian
