1. Introduction
This manual provides essential information for the safe and effective use of your Sylvania 20314 Compact Fluorescent Lamp (CFL). This 13-watt, 4-pin single tube lamp is designed to provide 2700K warm white light, suitable for various indoor lighting applications. It is compatible with electronic and dimming ballasts.
2. Safety Information
- Electrical Safety: Always turn off power at the circuit breaker or fuse box before installing, removing, or servicing the lamp. Ensure your hands are dry when handling electrical components.
- Lamp Handling: Handle the lamp by its base, not the glass tube, to avoid breakage and ensure proper electrical contact. Avoid touching the glass with bare hands as oils can reduce lamp life.
- Disposal: This lamp contains a small amount of mercury. Dispose of it in accordance with local, state, and federal regulations. Do not dispose of in regular household trash. Recycling options may be available in your area.
- Breakage: In case of lamp breakage, ventilate the area for 15 minutes. Use stiff paper or cardboard to scoop up glass fragments and fine powder. Do not use a vacuum cleaner. Place all materials in a sealed plastic bag and dispose of properly.
- Compatibility: Use only with compatible electronic and dimming ballasts as specified. Using an incompatible ballast may damage the lamp or cause improper operation.
3. Product Overview
The Sylvania 20314 is a compact fluorescent lamp designed for energy-efficient lighting. Its key features include:
- Wattage: 13 Watts
- Brightness: 800 Lumens
- Color Temperature: 2700 Kelvin (Warm White)
- Base Type: 4-pin single tube
- Rated Life: Approximately 10,000 hours
- Color Rendering Index (CRI): 82
Figure 3.1: Sylvania 20314 Compact Fluorescent Lamp. This image shows the overall appearance of the 4-pin single tube CFL.
Figure 3.2: Sylvania 20314 Compact Fluorescent Lamp with approximate dimensions. The lamp measures approximately 6.7 inches (16 cm) in length.
4. Setup and Installation
- Power Off: Before beginning installation, ensure the power to the fixture is completely turned off at the circuit breaker or fuse box.
- Remove Old Lamp (if applicable): If replacing an existing lamp, allow it to cool completely. Gently twist or pull the old lamp straight out from the fixture base, depending on the fixture type.
- Inspect Fixture: Check the fixture's socket for any damage or debris. Ensure it is clean and dry.
- Insert New Lamp: Align the 4 pins of the Sylvania 20314 lamp with the corresponding slots in the fixture's socket. Gently push the lamp straight into the socket until it is firmly seated. Do not force the lamp, as this may damage the pins or the fixture.
- Restore Power: Once the lamp is securely installed, restore power to the fixture at the circuit breaker.
- Test: Turn on the light switch to confirm the lamp is functioning correctly.
Note: This lamp requires a compatible electronic or dimming ballast for proper operation. Consult your fixture's specifications if unsure.
5. Operating Instructions
The Sylvania 20314 CFL operates like a standard light bulb once installed in a compatible fixture.
- Turning On/Off: Use the wall switch or fixture control to turn the light on or off.
- Warm-up Time: Like most CFLs, this lamp may require a short warm-up period (typically a few seconds to a minute) to reach full brightness and color stability, especially in colder environments.
- Dimming: If installed in a fixture with a compatible dimming ballast, the lamp's brightness can be adjusted using the dimmer control. Ensure the dimmer is rated for CFLs.
6. Maintenance
- Cleaning: Ensure the lamp is cool and the power is off before cleaning. Wipe the glass tube gently with a soft, dry, lint-free cloth. Do not use liquid cleaners or abrasive materials.
- Replacement: Replace the lamp when it reaches the end of its rated life or if it begins to flicker excessively or fails to illuminate. Follow the installation steps in Section 4 for replacement.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Lamp does not light up. |
|
|
| Lamp flickers or cycles on/off. |
|
|
| Reduced brightness. |
|
|
8. Specifications
| Attribute | Value |
|---|---|
| Model Number | 20314 |
| Brand | LEDVANCE (Sylvania) |
| Light Type | Compact Fluorescent Lamp (CFL) |
| Wattage | 13 Watts |
| Brightness | 800 Lumens |
| Color Temperature | 2700 Kelvin (Warm White) |
| Color Rendering Index (CRI) | 82 |
| Voltage | 120 Volts |
| Base Type | 4-Pin Single Tube |
| Rated Average Life | 10,000 Hours |
| Dimensions (L x W x H) | 6.72 x 0.88 x 1.5 inches (approx.) |
| Material | Glass |
| Indoor/Outdoor Usage | Indoor |
9. Warranty and Support
This Sylvania 20314 Compact Fluorescent Lamp comes with a 2-year limited warranty from the manufacturer, LEDVANCE. Please retain your proof of purchase for warranty claims.
For technical support, warranty inquiries, or further assistance, please contact LEDVANCE customer service. Refer to the product packaging or the official LEDVANCE website for the most current contact information.
Disclaimer: The information in this manual is subject to change without notice. LEDVANCE assumes no responsibility for any errors or omissions that may appear in this manual.
