1. Product Overview
The Osmo Wash & Care Floor Cleaner (Model 8016) is a special water-soluble cleaning concentrate designed for the regular damp cleaning and maintenance of oiled and waxed wood floors. This product effectively cleans and freshens floors without stripping their protective coating, leaving a low-maintenance, slip-resistant surface. Its water-soluble ingredients prevent streaking and film-building, are mild to skin, free of dyes and aromas, biodegradable, and free of solvents and fumes, supporting a healthy living environment.
- Special water-soluble wiping concentrate for regular use.
- Cleans and freshens floors simultaneously.
- Does not form hardening film and leaves no streaks.
- Free from solvents, colours, and fragrances.
- Biodegradable formulation.
Image: Osmo Wash & Care Floor Cleaner, 1 Liter bottle. This product is designed for effective and gentle cleaning of oiled and waxed wood floors.
2. Safety Information
When using any cleaning product, it is important to follow safety guidelines to ensure personal well-being and proper product handling.
- Keep out of reach of children.
- Always read the product container or label for specific safety instructions before use.
- Avoid contact with eyes. In case of contact, rinse thoroughly with water.
- Do not ingest. If swallowed, seek medical advice immediately.
- Ensure adequate ventilation during and after use.
3. Surface Preparation
Before applying Osmo Wash & Care, ensure the floor is free of loose debris. This step is crucial for effective cleaning and to prevent scratching.
- Remove loose debris: Use an Osmo Dust-Mop, a conventional vacuum cleaner, or a broom to thoroughly clean the floor surface.
4. Operating Instructions
4.1. Manual Application
For everyday cleaning, Osmo Wash & Care is ideally used with the Osmo Micro-Mop Plush or a similar damp mop.
- Dilution: Add approximately 2 capfuls (1 Fl. Oz. / 30 ml) of Osmo Wash & Care per gallon of water.
- Application: Clean the floor with a damp mop (ensure the mop is not overly wet).
- Important: Correct dosage is cost-effective and gentle to the environment. Only a small quantity of product is needed. Do not mix with other cleaners.
4.2. Machine Application
For larger areas or more intensive cleaning, machine application can be used.
- Distribution: Distribute the diluted Wash & Care solution using a pump sprayer.
- Cleaning: Loosen dirt with a single-disk machine (e.g., Osmo FloorXcenter) and a white Microfiber Pad.
- Wiping: Wipe the area clean by hand or by using a Microfiber Pad in combination with a machine.
4.3. Addressing Tough Stains and Intensive Refreshing
For areas with tough stains, a more concentrated solution may be required.
- Tough Stains: First clean with a more concentrated Wash & Care solution using machine applications (e.g., single-disk machine with a red pad).
- Post-Cleaning: After drying, one thin coat of an Osmo Polyx®-Oil must be applied to the flooring.
- Intensive Refreshing: For strong stains and intensive refreshing of waxed or oiled floors, an undiluted application of Osmo Polyx®-Oil (based on natural vegetable oils and waxes) is recommended for machine renovation.
Drying Conditions: Ventilate well while drying. Lower humidity may increase drying times. Ideal climatic conditions are 73°F / 50% relative humidity.
5. Maintenance
Regular use of Osmo Wash & Care as directed will maintain the beauty and protective qualities of your oiled and waxed wood floors. It is also suitable for the cleaning and care of oiled and waxed furniture, doors, wall, and ceiling paneling.
6. Troubleshooting
If you encounter any issues while using Osmo Wash & Care, consider the following common solutions:
- Streaks or Film: If streaks or a film appear on the floor, ensure the correct dilution ratio is used and that the mop is damp, not overly wet. Over-application or insufficient rinsing can cause these issues. The product is designed to prevent streaking and film-building when used correctly.
- Ineffective Cleaning: Ensure loose debris is thoroughly removed prior to cleaning. Verify the correct dilution. For tough stains, consider the concentrated application method described in Section 4.3.
7. Specifications
| Brand | Osmo |
| Model Number | 8016 (p-000657_SML) |
| Item Form | Liquid |
| Scent | Pine |
| Specific Uses | Floor (oiled and waxed wood floors, furniture, doors, wall and ceiling paneling) |
| Product Dimensions | 0.39 x 0.39 x 0.39 inches; 2.2 Pounds (for 1L bottle) |
| Ingredients | 5-15% plant soaps (anionic tensides); <5% non-ionic tensides; care components. |
| Storage | Store in the closed original can. Do not expose to frost or temperatures above 86°F (30°C). |
| Disposal | Dispose of completely emptied packaging according to local official guidelines. Emptied cans can be recycled. |
8. Warranty and Support
Specific warranty information for the Osmo Wash & Care Floor Cleaner (Model 8016) is not provided in the available product data. For detailed warranty terms, product support, or further inquiries, please refer to the official Osmo website or contact Osmo customer service directly.
You can often find contact information and FAQs on the manufacturer's official website: www.osmo.com
