Satin Nickel Hinge Pin Door Stop User Manual

Introduction

This manual provides detailed instructions for the installation, operation, and maintenance of your Hardware House Satin Nickel Hinge Pin Door Stop. This product is designed to prevent doors from opening too far and causing damage to adjacent walls, furniture, or fixtures. Its hinge pin design allows for discreet and effective door stopping.

This image displays the Satin Nickel Hinge Pin Door Stop, showcasing its design and finish. The door stop is designed to attach to a door hinge to prevent the door from opening too far and damaging adjacent walls or furniture.

Components

The Hardware House Hinge Pin Door Stop package typically includes:

• One (1) Satin Nickel Hinge Pin Door Stop
• One (1) Rubber Tip (pre-installed)
• One (1) Adjustment Screw (pre-installed)

Installation Instructions

Follow these steps to properly install your hinge pin door stop:

1. Identify the Hinge: Choose the top or middle hinge of the door that you wish to stop.
2. Remove Hinge Pin: Carefully tap the hinge pin upwards from the bottom using a hammer and a nail set or a similar tool. Remove the pin completely.
3. Place Door Stop: Slide the hinge pin door stop onto the top of the hinge, aligning its opening with the hinge barrel.
4. Reinsert Hinge Pin: Insert the original hinge pin back through the hinge barrel and the door stop. Tap it down gently until it is fully seated.
5. Adjust Position: Open the door to the desired stopping point. Loosen the adjustment screw on the door stop slightly. Rotate the door stop arm until the rubber tip makes contact with the door frame or wall at the desired stopping angle.
6. Secure Adjustment: Once the desired position is achieved, tighten the adjustment screw firmly to secure the door stop in place. Do not overtighten.

This image provides a side view of the Satin Nickel Hinge Pin Door Stop, highlighting the adjustable screw mechanism that allows for precise positioning to control the door's swing.

A close-up view of the Satin Nickel Hinge Pin Door Stop, illustrating how it fits over a door hinge pin. This view emphasizes the durable die-cast construction and the satin nickel finish.

Operation

Once installed and adjusted, the hinge pin door stop operates passively. As the door opens, the arm of the door stop will rotate with the hinge. When the door reaches the set limit, the rubber tip on the end of the arm will make contact with the door frame or wall, preventing further movement and protecting surfaces from impact damage.

Maintenance

The Satin Nickel Hinge Pin Door Stop requires minimal maintenance:

• Cleaning: Wipe the door stop periodically with a soft, damp cloth to remove dust and grime. Avoid abrasive cleaners that could damage the finish.
• Check Tightness: Occasionally check the adjustment screw to ensure it remains tight and the door stop is securely positioned.
• Rubber Tip Inspection: Inspect the rubber tip for wear or damage. If the tip is worn, it may need replacement to ensure effective cushioning.

Troubleshooting

Specifications

Warranty and Support

Specific warranty information for the Hardware House Satin Nickel Hinge Pin Door Stop is not provided in the product details. For warranty claims, technical support, or replacement parts, please contact Hardware House directly through their official website or customer service channels. Keep your purchase receipt as proof of purchase.