JERDON JP7808N
JERDON 8-Inch Two-Sided Swivel Wall Mount Mirror (Model JP7808N) User Manual
Model: JP7808N | Brand: JERDON
Introduction
This manual provides instructions for the installation, operation, and maintenance of your JERDON 8-Inch Two-Sided Swivel Wall Mount Mirror, Model JP7808N. This mirror features an 8-inch diameter, 1x and 8x magnification, and a 13.5-inch extendable arm, all finished in nickel.
Important Safety Information
CAUTION: This mirror is heavy and should be installed by a professional. Handle with care to avoid injury or damage.
- Ensure the mounting surface is structurally sound and can support the weight of the mirror.
- Keep out of reach of children.
- Avoid direct sunlight exposure to the magnified side, as it can concentrate light and pose a fire hazard.
Package Contents
- JERDON 8-Inch Two-Sided Swivel Wall Mount Mirror (Model JP7808N)
- Mounting Hardware (screws, anchors)
Setup and Installation
Proper installation is crucial for the stability and functionality of your wall-mount mirror. It is recommended to have this mirror installed by a qualified professional due to its weight and the need for secure wall mounting.
- Choose Location: Select a suitable wall location, preferably near a stud for maximum support. Ensure there is enough clearance for the mirror to extend and swivel freely (up to 13.5 inches).
- Mark Drilling Points: Hold the mounting bracket against the wall at the desired height and use a pencil to mark the positions for the mounting screws.
- Drill Pilot Holes: Drill pilot holes at the marked locations. If drilling into a stud, use a drill bit slightly smaller than the screw diameter. If drilling into drywall without a stud, use appropriate wall anchors (included) and drill holes according to anchor instructions.
- Secure Mounting Bracket: Attach the mounting bracket to the wall using the provided screws. Ensure it is firmly secured and level.
- Attach Mirror Arm: Slide the mirror's extension arm onto the mounting bracket. Secure it according to the specific design of the bracket, typically with a set screw or by tightening nuts.
- Test Stability: Gently extend and swivel the mirror to ensure it is securely mounted and operates smoothly.
Image: The JERDON JP7808N wall mount mirror in nickel finish, showing its folded position against the wall.
Image: The JERDON JP7808N mirror fully extended, illustrating its 13.5-inch reach from the wall.
Operating Instructions
- Extending and Retracting: Gently pull the mirror head away from the wall to extend the arm. Push it back towards the wall to retract. The arm extends up to 13.5 inches.
- Swiveling the Mirror Head: The mirror head features a 360-degree swivel design. Rotate the mirror head to switch between the 1x (true image) and 8x (magnified) sides.
- Adjusting Viewing Angle: The extension arm and mirror head can be adjusted to various angles to achieve your desired viewing position.
Image: Diagram illustrating the 360-degree swivel function and the 8X magnification feature of the JERDON mirror.
Image: The mirror face with an overlay indicating its 8-inch diameter.
Maintenance and Care
- Cleaning the Mirror: Use a soft, lint-free cloth and a non-abrasive glass cleaner. Spray the cleaner onto the cloth, not directly onto the mirror, to prevent liquid from seeping into the edges.
- Cleaning the Finish: Wipe the nickel finish with a soft, dry cloth. Avoid abrasive cleaners or harsh chemicals, as these can damage the finish.
- Lubrication: If the swivel or extension arm becomes stiff over time, a small amount of silicone-based lubricant can be applied to the pivot points. Avoid oil-based lubricants.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Mirror feels loose or wobbly | Mounting screws are loose; improper installation. | Check and tighten all mounting screws. Ensure wall anchors are properly seated if used. Re-install if necessary, ensuring a secure mounting surface. |
| Arm or swivel is stiff | Accumulation of dust/debris; lack of lubrication. | Clean pivot points. Apply a small amount of silicone-based lubricant to hinges and swivel mechanisms. |
| Mirror does not hold position | Pivot points are too loose. | Some pivot points may have adjustable tension screws. Gently tighten these if accessible. Avoid overtightening. |
| Distortion on magnified side | Incorrect viewing distance. | For 8x magnification, position your face closer to the mirror (typically within 4-6 inches) for optimal clarity and to minimize distortion. |
Specifications
- Model: JP7808N
- Brand: JERDON
- Mirror Diameter: 8 inches
- Magnification: 1x / 8x (Two-Sided)
- Extension Length: Up to 13.5 inches from wall
- Finish: Nickel
- Frame Material: Metal
- Product Dimensions (folded): Approximately 9.5 x 1.25 x 12.5 inches
- Weight: Approximately 1.75 Pounds
- Room Type: Bathroom, Bedroom, Dressing Room
- Shape: Round
Warranty and Support
For warranty information or technical support, please contact JERDON customer service. Refer to the product packaging or the official JERDON website for the most current contact details.
You can visit the official JERDON store for more information: JERDON Store
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.