Varilight 2-Gang 1 or 2-Way 10A Switch

Introduction

This manual provides comprehensive instructions for the safe installation, operation, and maintenance of your Varilight 2-Gang 1 or 2-Way 10A Pewter Switch, model XR2B. Please read all instructions carefully before beginning installation or use to ensure proper function and safety.

This image displays the Varilight XR2B 2-Gang 10A Pewter Switch. It features a rectangular pewter-colored faceplate with two black rocker switches centrally located. Two visible screw heads are present, one in the top-left and one in the top-right corner of the faceplate, securing it.

Safety Information

• Installation should only be carried out by a qualified electrician or competent person.
• Always isolate the mains electricity supply at the consumer unit/fuse box before commencing any electrical work.
• Ensure all wiring complies with the latest IET Wiring Regulations (BS 7671).
• Do not exceed the maximum load rating of 10A.
• This product is designed for indoor use only.

Setup and Installation

Before installation, ensure the power supply to the circuit is switched off at the main consumer unit.

Wiring Instructions:

1. Carefully remove the existing switch from the wall box, noting the current wiring configuration.
2. Connect the wires to the terminals on the Varilight XR2B switch as follows:
   • Common (COM) Terminal: Connect the permanent live wire.
   • L1 Terminal: Connect the switched live wire for one-way operation, or the first strap wire for two-way operation.
   • L2 Terminal: Connect the second strap wire for two-way operation (if applicable).
   • Earth Terminal: Ensure the earth wire is connected to the earth terminal on the switch plate or the metal wall box.
3. Ensure all terminal screws are tightened securely.
4. Gently push the switch into the wall box, ensuring no wires are trapped or pinched.
5. Secure the switch plate to the wall box using the provided screws.
6. Restore power at the consumer unit and test the switch functionality.

Note: For 2-way switching, two switches control the same light. For 1-way switching, a single switch controls the light.

Operating Instructions

The Varilight XR2B switch features two rocker switches, each controlling a separate circuit or acting as part of a 2-way circuit.

• To turn a connected light or appliance ON, press the top part of the corresponding rocker switch.
• To turn a connected light or appliance OFF, press the bottom part of the corresponding rocker switch.

The switch provides a clear tactile and audible click when operated, indicating the change in circuit status.

Maintenance

To maintain the appearance and functionality of your Varilight switch:

• Ensure the power supply to the switch is OFF before cleaning.
• Wipe the faceplate with a soft, dry cloth.
• Do not use abrasive cleaners, chemical solvents, or polishes as these may damage the finish.
• Regularly check for any loose connections or signs of wear, especially during routine electrical inspections.

Troubleshooting

If the problem persists after attempting these solutions, please contact a qualified electrician or Varilight customer support.

Specifications

• Model: XR2B
• Type: 2-Gang 1 or 2-Way Switch
• Current Rating: 10A
• Colour: Pewter
• Switch Style: Rocker Switch
• Manufacturer: Varilight
• ASIN: B001B0EGM6
• Date First Available: 17 Feb. 2010

Warranty and Support

For information regarding warranty terms and conditions, please refer to the Varilight official website or contact their customer support directly. Keep your proof of purchase for any warranty claims.

Manufacturer: Varilight

For further assistance or technical support, please visit the Varilight Store on Amazon or their official website.