1. Introduction
This manual provides essential information for the proper installation, operation, and maintenance of the Bosch AQOK AquaStar Outdoor Installation Kit. This kit is specifically designed to enable the outdoor installation of the Bosch AquaStar 2700ES tankless water heater in approved climates. Adherence to these instructions is crucial for safe and efficient operation of your water heating system.
The AQOK kit provides necessary protection for the AquaStar 2700ES when installed outside, shielding it from environmental elements while maintaining accessibility for service.
2. Safety Information
Read all instructions carefully before installation. Failure to follow these instructions could result in property damage, personal injury, or death. Installation must be performed by a qualified professional in accordance with all local, state, and national codes and regulations.
- Electrical Hazard: Ensure all power to the water heater and associated circuits is disconnected before installation.
- Gas Hazard: If applicable, ensure gas supply to the water heater is shut off and properly vented before installation.
- Water Hazard: Turn off water supply and drain the water heater before beginning installation.
- Weight: The water heater and kit components can be heavy. Use proper lifting techniques or seek assistance to prevent injury.
- Approved Climates: This kit is for use in approved climates only. Consult local regulations and the AquaStar 2700ES manual for climate suitability.
- Clearances: Maintain proper clearances around the installed unit as specified in the AquaStar 2700ES manual and local codes.
3. Package Contents
The Bosch AQOK Outdoor Installation Kit typically includes components necessary to enclose and protect the AquaStar 2700ES tankless water heater for outdoor use. Please verify all components are present and undamaged upon receipt.
- Outdoor enclosure/cabinet components
- Mounting hardware
- Installation instructions (this document)
- Note: The AquaStar 2700ES water heater is sold separately and is not included in this kit.
4. Installation Requirements
Before beginning installation, ensure the following conditions are met:
- Location: Select a suitable outdoor location that complies with all local codes for gas appliances, ventilation, and clearances. The location should be accessible for maintenance.
- Climate: Confirm your climate is approved for outdoor tankless water heater installation. This kit provides weather protection but does not prevent freezing in extremely cold conditions unless specified otherwise by the water heater manufacturer.
- Mounting Surface: The mounting surface must be structurally sound and capable of supporting the combined weight of the AQOK kit and the AquaStar 2700ES water heater, plus water content.
- Utilities: Ensure access to necessary water, gas (if applicable), and electrical connections at the chosen installation site.
- Tools: Gather all required tools for assembly and installation, including but not limited to drills, screwdrivers, levels, and measuring tape.
5. Installation Instructions
These instructions outline the general steps for installing the AQOK kit. Refer to the specific instructions provided with your AquaStar 2700ES water heater for its internal connections and startup procedures.
- Unpack and Inspect: Carefully unpack all components of the AQOK kit. Inspect for any shipping damage. Report any damage immediately.
- Assemble Enclosure: Follow the kit's specific instructions to assemble the outdoor enclosure. Ensure all panels are securely fastened and weather-sealed as directed.
- Mount Enclosure: Position the assembled enclosure on the chosen mounting surface. Mark drilling locations. Drill pilot holes and securely fasten the enclosure to the wall using appropriate mounting hardware for your wall type. Ensure the enclosure is level.
- Install AquaStar 2700ES: Carefully lift and place the AquaStar 2700ES water heater inside the assembled AQOK enclosure. Secure the water heater according to its own manual and any provisions within the AQOK kit for internal mounting.
- Connect Utilities: Connect water, gas (if applicable), and electrical lines to the AquaStar 2700ES as per its installation manual. Ensure all connections pass through the designated openings in the AQOK enclosure and are properly sealed to maintain weather integrity.
- Ventilation: Verify that the enclosure's design allows for proper ventilation as required by the AquaStar 2700ES and local codes. Do not obstruct any vents.
- Final Checks: Before operating the water heater, perform a thorough inspection. Check all connections for leaks (water and gas). Ensure all electrical connections are secure. Confirm the enclosure is fully assembled and sealed.
6. Operation (Post-Installation)
The Bosch AQOK kit itself does not have operational controls. Its function is to provide a protective environment for the AquaStar 2700ES water heater, allowing it to operate safely outdoors. Once the kit is installed and the water heater is properly connected and started according to its own manual, the water heater will function as intended within its protective enclosure.
Ensure the enclosure doors or access panels are securely closed after any maintenance or inspection to maintain weather protection.
7. Maintenance
Regular maintenance of the AQOK kit ensures its longevity and continued protection for your water heater.
- Annual Inspection: Annually inspect the enclosure for any signs of wear, corrosion, or damage. Check seals around doors and utility penetrations for integrity.
- Cleaning: Keep the exterior of the enclosure clean from debris, leaves, and dirt to prevent blockage of vents and maintain appearance.
- Fasteners: Periodically check all mounting fasteners and enclosure assembly screws to ensure they remain tight.
- Pest Control: Ensure no pests (insects, rodents) have made nests inside the enclosure, which could obstruct ventilation or damage components.
8. Troubleshooting
This section addresses issues related to the AQOK outdoor installation kit. For troubleshooting issues with the AquaStar 2700ES water heater itself, refer to its dedicated manual.
| Problem | Possible Cause | Solution |
|---|---|---|
| Water inside enclosure | Damaged seals, improperly closed access panel, blocked drainage. | Inspect and repair/replace seals. Ensure access panels are securely closed. Clear any drainage obstructions. |
| Enclosure appears loose or unstable | Loose mounting hardware, inadequate mounting surface. | Tighten all mounting screws. If the mounting surface is inadequate, reinforce it or relocate the unit. |
| Pest infestation within enclosure | Unsealed openings, lack of regular inspection. | Seal any gaps or openings. Remove pests and clean the enclosure. Implement regular pest checks. |
9. Specifications
Technical specifications for the Bosch AQOK Outdoor Installation Kit:
- Model Number: AQOK
- Item Weight: 8.85 pounds
- Product Dimensions: 9 x 16 x 21 inches
- Item Package Quantity: 1
- Country Of Origin: China
- Compatible Water Heater: Bosch AquaStar 2700ES
10. Warranty Information
For detailed warranty information regarding the Bosch AQOK Outdoor Installation Kit, please refer to the warranty documentation included with your purchase or visit the official Bosch website. Warranty terms and conditions may vary.
11. Customer Support
If you require assistance or have questions regarding the Bosch AQOK Outdoor Installation Kit, please contact Bosch Customer Service:
- Phone: 800-283-3787
- Website: Visit the Bosch Store on Amazon (for product information)
- For technical support, please refer to the contact information provided in the AquaStar 2700ES water heater manual.